Embedded Single Board Computers
All product specifications are subject to change without notice Last updated : 09-Nov-2009
Features
PCM-9387 3.5" SBC with Intel® ULV Celeron® M,
VGA, LVDS, DVI, LAN, USB
Embedded Intel® ULV Celeron® M 600 MHz and 1.0 GHz processor
Supports 36-bit LVDS (48-bit LVDS optional)/VGA
100 Mbps Ethernet; Gigabit Ethernet (optional)
+5 V and +12 V power; or single +5 V power
Supports Embedded Software API and Utility
LAN SIR
CRT
FAN
USB
Primary IDE
USB
Power
LVDSAudio
PCI-104
SODIMM
(Solder side)
COM2
LPT
COM1 KB/Mouse
CF
(Solder side)
LCD converter
GPIO
HDD LED
DVI
Specifications
Processor System
CPU Intel Celeron M 600 MHz Intel Celeron M 1 GHz
Front Side Bus 400 MHz 400 MHz
L2 Cache 512 KB -
Chipset Intel 852GM + ICH4 Intel 852GM + ICH4
BIOS Award 4 Mbit Award 4 Mbit
Memory
Technology DDR 266 MHz
Max. Capacity 1 GB
Socket 1 x 200-pin SODIMM
SSD CompactFlash Card Type I/II
Coastline I/O
VGA 1
COM 1
RJ-45 1
USB 1
K/B, Mouse 1
Internal I/O
LPT 1
RS-232 -
RS-232/422/485 1
K/B -
Mouse -
USB 2 x USB 2.0
Audio AC97, Line-in, Line-out, Mic-in
IrDA 115 kbps, SIR, IrDA 1.0 complaint (optional)
GPIO 4-bit general purpose Input/Output
SMBus Supported
EIDE Mode UDMA 33
Channel 1
Expansion Slot PCI-104 1
Ethernet
Speed 10/100 Mbps
10/100/1000 Mbps (optional)
Controller Intel 82551QM (with Wake on LAN)
Intel 82541PI (Gigabit, Optional)
Interface 1 x RJ-45
Display
Controller Intel 852GM
VRAM Optimized Shared Memory Architecture up to 64 MB system memory
LVDS LCD 1 x 36-bit LVDS (48-bit LVDS optional), Panel 16:9 wide screen panel supported
Dual Independent Display CRT + LVDS, CRT + DVI / LVDS + DVI
Environment Operating Temperature 0 ~ 60° C (32 ~ 140° F)
Operating Humidity 10% ~ 90% relative humidity, non-condensing
Power
Power Type AT / ATX
Power Supply Voltage ATX: +5 V ± 5%, ±12 V ± 5%
AT: 5V only to boot up (12 V is optional for LCD inverter and add on card)
Power Consumption Max (Test in HCT): +5 V @ 2.0 A, +12 V @ 0.02 A (ULV Celeron M 600/DDR 256 MB)
Power Management APM1.2, ACPI2.0, wake on LAN, and modem ring-in functions
Battery Lithium 3 V / 196 mAH
Watchdog Timer Output System reset
Interval Programmable 1 ~ 255 sec
Physical Characteristics Dimensions (L x W) 146 x 102 mm (5.7" x 4")
Weight 0.85 kg (1.87 lb), weight of total package
Backlight
On/Off
WatchdogGPIO H/W
Monitor
Monitoring
BIOS flash
Software APIs:
Utility:
SMBus CPU Speed System
Throttling
www.advantech.com/products
Online Download
Board Diagram
Packing List
Part No. Description Quantity
PCM-9387 SBC 1
9689000002 Mini jumper pack 1
Startup manual 1
Utility CD 1
1703100152 Audio cable 1
1701440351 IDE 44 pin 1
1703100121 USB 2 port cable 1
1700260250 Parallel port cable 1
1700060202 Keyboard/mouse cable 1
1701140201 Second serial port cable 1
1700000265 ATX power cable 20P-12P cable 1
Optional
Part No. Description
1700000410 CABLE DVI-26P/DF13-20P 20 cm
1700002595 Cable 110-pin, 1.27 mm/4-pin, 1.25 mm, 20 cm for
PCM-9381/87
1700002532 FLAT cable 14P/5P for internal COM1 RS-232 20 cm
Embedded OS
Part No. Description
2070000584 Win CE 4.2 P-M Core Image, PCM-938x, 2 COM, English, V
1.10 (17.2 MB) (Optional)
2070000585 Win CE 4.2 P-M Pro Image, PCM-938x, 2 COM, English, V
1.10 (29.1 MB) (Optional)
2070000586 Win CE 4.2 P-M Plus Image, PCM-938x, 2 COM, English, V
1.10 (29.9 MB) (Optional)
2070000765 Image CE 5.0 Pro Plus English for P-M, 2 COM (Optional)
2070000605 Win XPE SP2 Image, PCM-938x, English, V2.10 (440 MB)
(Optional)
PCM-9387
Ordering Information
Part No. CPU CRT LVDS DVI LAN USB RS-232 RS-232/422/485 LPT GPIO IrDA CF PCI-104
PCM-9387F-M0A2E Celeron M 600 MHz
(512 KB) 1 1 1 1 FE, GbE (option) 3 1 1 1 2 in, 2 out optional 1 1
PCM-9387F-S0A2E Celeron 1 GHz (0 KB) 1 1 1 1 FE, GbE (option) 3 1 1 1 2 in, 2 out optional 1 1
COM1/COM2
Analog RGB
LPC Super I/O
(W83627HF)
FWH
400MHz PSB
GPIO
PCI BUS
200pin SODIMM x 1
DDR SDRAM
IRDA
USB 2.0 x 3
(82551/82541)
10/100/1000M
LPT
LPC Bus
Intel ICH4
(82801DB)
PS/2 KB&MS
DDR200/266
(852GM)
Intel GMCH
CRT
Connector
LAN
Connector
USB
Connector
DVI
Connector
LVDS
Connector
ALC203 AC97
CODEC
CompactFlash
Type I
Primary IDE
Connector
Audio
Connector PCI-104
Connector
CH7301
Celeron M
All product specifications are subject to change without notice Last updated : 09-Nov-2009
Embedded Single Board Computers
Software APIs
Control Monitor
GPIO
General Purpose Input/Output is a flexible parallel interface
that allows a variety of custom connections. It allows users
to monitor the level of signal input or set the output status to
switch on/off a device. Our API also provides Programmable
GPIO, which allows developers to dynamically set the GPIO
input or output status. Watchdog
A watchdog timer (WDT) is a device that performs a specific
operation after a certain period of time if something goes wrong
and the system does not recover on its own.
A watchdog timer can be programmed to perform a warm boot
(restarting the system) after a certain number of seconds.
SMBus
SMBus is the System Management Bus defined by Intel®
Corporation in 1995. It is used in personal computers and
servers for low-speed system management communications.
The SMBus API allows a developer to interface a embedded
system environment and transfer serial messages using the
SMBus protocols, allowing multiple simultaneous device
control.
Hardware
Monitor
The Hardware Monitor (HWM) API is a system health
supervision API that inspects certain condition indexes, such as
fan speed, temperature and voltage.
I2C
I2C is a bi-directional two wire bus that was developed by
Philips for use in their televisions in the 1980s.
The I2C API allows a developer to interface with an embedded
system environment and transfer serial messages using the I2C
protocols, allowing multiple simultaneous device control. Hardware
Control
The Hardware Control API allows developers to set the PWM
(Pulse Width Modulation) value to adjust fan speed or other
devices; it can also be used to adjust the LCD brightness.
Display Power Saving
Brightness
Control
The Brightness Control API allows a developer to interface with
an embedded device to easily control brightness.
CPU Speed
Make use of Intel SpeedStep technology to reduce power power
consumption. The system will automatically adjust the CPU
Speed depending on system loading.
Backlight
The Backlight API allows a developer to control the backlight
(screen) on/off in an embedded device.
System
Throttling
Refers to a series of methods for reducing power consumption in
computers by lowering the clock frequency. These APIs allow the
user to lower the clock from 87.5% to 12.5%.
Software Utilities
BIOS Flash
The BIOS Flash utility allows customers to update the flash
ROM BIOS version, or use it to back up current BIOS by
copying it from the flash chip to a file on customers’ disk. The
BIOS Flash utility also provides a command line version and
API for fast implementation into customized applications. eSOS
The eSOS is a small OS stored in BIOS ROM. It will boot up in
case of a main OS crash. It will diagnose the hardware status,
and then send an e-mail to a designated administrator. The
eSOS also provides remote connection: Telnet server and FTP
server, allowing the administrator to rescue the system.
Embedded
Security ID
The embedded application is the most important property of
a system integrator. It contains valuable intellectual property,
design knowledge and innovation, but it is easily copied! The
Embedded Security ID utility provides reliable security functions
for customers to secure their application data within embedded
BIOS. Flash Lock
Flash Lock is a mechanism that binds the board and CF card
(SQFlash) together. The user can “Lock” SQFlash via the Flash
Lock function and “Unlock” it via BIOS while booting. A locked
SQFlash cannot be read by any card reader or boot from other
platforms without a BIOS with the “Unlock” feature.
Monitoring
The Monitoring utility allows the customer to monitor system
health, including voltage, CPU and system temperature and fan
speed. These items are important to a device; if critical errors
happen and are not solved immediately, permanent damage may
be caused.
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying
drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms.
It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
