Round LED HI Red, 3mm Specifications: Dice material Emitted colour Lens colour Peak wavelength Viewing angle Luminous intensity (IV) : GaP : HI-Red : Red Diffused : 697nm : 76 : 1.6mcd Absolute Maximum Ratings (Ta = 25C) Reverse Voltage 5V Reverse Current 10A (Vr = 5V) Operating Temperature Range -40C to +85C Storage Temperature Range -40C to +100C Lead Soldering Temperature Range 1.6mm (1/16 inch) from body 260C for 5 Seconds Electrical/Optical Characteristics at Ta = 25C Parameter Symbol Minimum Typical Maximum Luminous Intensity IV 0.8 1.6 2.5 mcd Viewing Angle 2 1/2 - 70 - degrees Peak Emission Wavelength P - 697 - Dominant Wavelength D - 650 - Spectral Line Half-Width - 90 - Unit Test IF = 20mA - nm - Forward Voltage VF 1.7 2.1 2.6 V IF = 20mA Power Dissipation Pd - - 45 - - Peak Forward Current (Duty 1/10 at 1KHz) IF (Peak) - - 50 - - Recommended Operating Current IF (Rec) - 10 - mA - www.element14.com www.farnell.com www.newark.com Page <1> 09/10/12 V1.0 Round LED HI Red, 3mm Bright Red (Gap P = 697nm) www.element14.com www.farnell.com www.newark.com Page <2> 09/10/12 V1.0 Round LED HI Red, 3mm Dimensions : Millimetres (Inches) Part Number Table Description Part Number LED, 3mm, 70, HI-Red MCL514PD Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <3> 09/10/12 V1.0