Assembly Instructions-C18 Amphenol®
HN - Typical Clamp
292
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Push nut, washer and gasket over cable jacket.
Cut cable even to dimensions shown in table.
Push clamp over copper braid, flush against cable jacket. Cut
exposed copper braid so that approximately 3/16 remains and fan
over clamp. Trim braid even with end of taper. Cut cable dielectric
(dim c) from end of cable cut. Tin exposed conductor.
Solder contact pin to conductor. Do not overheat dielectric. Do not
use excess solder. W ipe clean; see that dielectric is free from solder,
resin and foreign material. T ighten nut to recommended torque 35-40
in lbs securely with wrench.
Nut Washer Gasket Clamp Male
Contact Plug Body
a
b c
Stripping dims. inches (millimeters)
Amphenol
Part # a b c
16750 .799 (20.2) .594 (15.1) .203 (5.8)
82-816-1000 .843 (21.4) .625 (15.9) .218 (5.5)
