INPUT CHARACTERISTICS: P1H-6350/6400P
VOLTAGE: 90 ~ 264 VAC FULL RANGE
FREQUENCY : 47 ~ 63 HZ
INPUT CURRENT: 8.0 A ( RMS ) FOR 115VAC
4.0 / 5.0 A ( RMS ) FOR 230VAC
INRUSH CURRENT: 60A MAX. FOR 115 VAC
80 A MAX. FOR 230 VAC
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT(A) REGULATION OUTPUT
MIN. MAX. PEAK LOAD LINE
5V 3.0 25 ± 5% ± 1% 80mV
12V 2 28 ± 6% ± 1% 120mV
-5V 0 0.5 ±10% ± 1% 150mV
-12V 0 0.5 ±10% ± 1% 150mV
3.3V 1.0 20 ± 5% ± 1% 80mV
+5VSB 0.1 2 ± 5% ± 1% 80mV
OUTPUT
VOLTAGE RIPPLE & NOISE
MAX. [P-P]
REMARKS: THE OUTPUT POWER OF 5V & 3.3V NOT EXCEED 175W
SPECIFICATION:
TEMPERATURE RANGE: OPERATING 0℃ --- 50 / 40 ℃
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
EFFICIENCY: 65% TYPICAL
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
OVER LOAD PROTECTION: 110 % ~ 160 %
OVER VOLTAGE PROTECTION: +5V 5.7 ~ 6.5 V, 3.3V 3.7 ~ 4.1 V
+12V 13.3 ~ 14.3 V
SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B
SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL
DISABLE / ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
3.3V / 5V REMOTE SENSING
COOLING: TWO 40mm DC FANS
DIMENSION: 225 (D) x 100 (W) x 40.5 (H) mm
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
Revision: A01
