Specifications: STATSHIELD(R) METAL-IN SERIES Standard Document ANSI/ESD S541 (ANSI/ESD S20.20) ANSI/ESD S11.4 Electrical Properties Surface Resistance: Outer Surface Inner Surface Discharge Shielding Charge Generation Capacitance Probe (to dissipate 1 KV) Date & Lot Code Printed for QC Traceablility Weld Seal Side Weld Seals 3/8 in. (0.10) Soft Fold Bottom Low Charging Static Dissipative Proprietary Outer Polyester Layer ANSI/ESD STM11.11 ANSI/ESD STM11.11 ANSI/ESD STM11.31, EIA 541 Modified Incline Plane Modified Incline Plane ANSI/EIA-541/Appendix E, 1kV Discharge Nominal 3.0 mil (0.07mm) 10% Nominal -0" / + 0.250" Nominal 0.125"; Offset 0 to 1/4" >40% (Tobias) >10 lbs/in 4600 PSI, 32 MPa >10 lbs Pass Not detected Pass MIL-STD-3010, 1003 Mixed Unsortable Plastic Scrap Mixed unsortable plastic scrap shall contain assorted plastics of multiple grades that are co-extruded, bonded or laminated together which are unsortable into individual grades ANSI/ESD S541 Section 6.2 Outside an EPA "Transportation of sensitive products outside of an EPA shall require packaging that provides: 1. Low charge generation 2. Dissipative or conductive materials for intimate contact 3. A structure that provides electrostatic discharge shielding." Statshield(R) and Statfree(R) are Registered Trademarks of Desco Industries Inc. See Bag Selection Chart Click HERE. Desco's bags are recyclable Statshield(R) bags are packaged 100 per package in an oversized shielding bag. See Shielding Bag Storage at TB-7057. STATSHIELD(R) BAG, SHIELDING, METAL-IN, 3.0 MIL (0.07mm) DESCO EAST: ONECOLGATEWAY, CANTON, MA 02021-1407 PHONE (781) 821-8370 Employee Owned Made in the United States of America Specifications and procedures subject to change without notice. DESCO WEST: 3651 WALNUT AVE., CHINO, CA 91710 WEB SITE: Desco.com PHONE (909) 627-8178 (c) 2019 DESCO INDUSTRIES INC ASTM D-1003 375F, 1/2 sec 60 psi ASTM D882 MIL-STD-3010, 2065 MIL-STD-3010, M3005 FTIR IPC-TM-650 2.4.1 Limited Warranty See Desco's Limited Warranty at Desco.com Low Charging Static Dissipative Proprietary Inner Polyethylene Layer 1 x 104 to < 1 x 1011 ohms 1 x 104 to < 1 x 1011 ohms <20 nJ Teflon: 0.09 nC/sq. in. Quartz: 0.01 nC/sq. in. <30 volts RoHS, REACH, and Conflict Minerals Statement: See RoHS, REACH, and Conflict Minerals Statement at Desco.com. Aluminum Shielding Layer 7 Physical Properties Film Thickness Width (Inside Dimensions) Length (Inside Dimensions) Light Transmission Heat Seal Tensile Strength Puncture Resistance Non-corrosive Silicone Marking Adhesion Typical Values Meets Requirements of: ESD Protective Packaging Level 3 Technical Requirements Test Procedures/Method DRAWING NUMBER 13405 DATE: June 2019