tyca / Electronics Instruction Sheet OSP Feedthrough Panel 408-8693 ANP Jack Receptacle 1059677-1 05 AUG 02 RevO OSP Feedthrough Panel Jack Receptacle 1059677-1 TYCO ELECTRONICS PART NUMBER PREVIOUS PART NUMBER USED WITH 1059677-1 4558-5337-02 Customer Panel Figure 7 1. INTRODUCTION TOOL TYCO ELECTRONICS | PREVIOUS This instruction sheet contains the assembly DESCRIPTION PART NUMBER PART NUMBER procedures for the OSP Feedthrough Panel Jack Optional Receptacle shown in Figure 1. Installation Too! 1055845-1 2598-5211-54 This connector can be installed into customer panels Figure 2 using the tooling shown in Figure 2 . Dimensions on this sheet are in mifimeters [with NOTE . ; . i inches in brackets], unless otherwise specified. 6.35 Figures are not drawn fo scale. [25] To 2. ASSEMBLY PROCEDURES 4.11 40.03 : [.162 +. 001] Dia. 2.1. Mounting Hole Preparation 1. Drill a pilot hole with a diameter of 4.11 + 0.03 [.162 + .001] through the panel. ' Ff 2. Insert step reamer into pilot hole and ream 6.95 +0.03 6.35 + .025 [.250 + .001] diameter hole to [25 4, 001] depth shown in Figure 3. Dia. 5.33 + 0,05 [21 +, 002] 3. Plate the panel according to the customer application. The recommended maximum plating thickness is 0.005 [.00019]. Figure 3 4. Clean the mounting hole with a suitable solvent. 2.2. Installation of Receptacle Into Panel (Figure 4) Optional Botton Here Installation Too! + Jack Receptacle Press receptacle into panel. If necessary, use the tooling listed in Figure 2. Receptacle should be bottomed in panel as NOTE a shown in Figure 4. 3. REVISION SUMMARY Figure 4 Initial release of instruction sheet per EC Q990-11 74-02 2002 Tyco Electronics Corporation, Harrisburg, PA. This controlled document is subject to change. TOOLING ASSISTANCE CENTER 1-800-722-1111 1of1 All Intemational Rights Reserved. For latest revision call the AMP FAX* number. AMP FAX/PRODUCT INFO 1-800-822-6752 AMP and Tyco are trademarks. For Regional Customer Service, visit our website at LOC B *Trademark www.tycoelectronics.com