CPTC Thermistor: PT Series
Temperature Sensor
THINKING ELECTRONIC INDUSTRIAL Co., LTD.
6
www.thinking.com.tw
2013.04
All specifications are subject to change without notice.
Reliability Test
Item Standard Test Conditions and Methods Specifications
Robustness of
Terminations IEC 60738-1
Gradually apply the specified force and keep the unit fixed for
10±1 sec.
Terminal diameter
Force
(mm)
T(N)
0.35<d0.5
5.0
0.5<d0.8
10.0
R 25
No visible damage
Solderability IEC 60738-1
245±3 , 2±0.5 sec
new solder
Resistance to
Soldering Heat IEC 60738-1
260±3 , 10±1 sec R25/R25 20 %
No visible damage
Vibration IEC 60738-1
Frequency range:10~55Hz
Amplitude: 0.75mm or 98m/s
2
Direction: 3 mutually perpendicular directions
Duration: 6hrs(3x2 hrs)
R25/R25 20%
No visible damage
Shock IEC 60738-1
Wave: half-sine V: 1.0m/s
Acceleration: 50 m/s
2
Pulse time: 30ms
R25/R25 20%
No visible damage
Rapid Change of
Temperature IEC 60738-1
The thermal shock conditions shown below shall be repeated
5 cycles.
Step Temperature ( ) Period (minutes)
1 -40 ± 5 30 ± 3
2 Room temperature 5 ± 3
3 85 ± 5 30 ± 3
4 Room temperature 5 ± 3
R25/R25 20%
No visible damage
Damp Heat,
Steady State IEC 60738-1
40±2, 90~95%RH, 12±2V
dc
* for 1000±2 hrs R25/R25 20%
No visible damage
Climatic sequence
IEC60738-1
Dry heat: Ts+25°C for 16 hrs
Damp heat first cycle: 55, 95% R.H ,cycle time: 24 hrs
Cold: 0 for 2 hrs
Damp heat (cyclic), remaining cycles: 5 cycles
Test according to IEC60068-2-30
R25/R25
No damage observed
Endurance at upper
category temperature
IEC60738-1
Ts+25 , for 1000±2hrs R25/R25
No damage observed
Endurance at
maximum operating
temperature and
maximum voltage
IEC60738-1
Ts+25 , Vmax, Imax for 1000±2 hrs R25/R25
No damage observed
Insulation * CECC42000
100±15Vdc, 60±5 Sec 100MΩ
Voltage Proof * CECC42000
1000±10Vrms, 60±5 Sec No damage observed
Note: * Available for PTM series only.