MEMBRAPOR SPECIFICATION SHEET FOR FOR H2 SENSOR TYPE H2/CA-1000 PERFORMANCE CHARACTERISTICS PHYSICAL CHARACTERISTICS Nominal Range Maximum Overload Expected Operation Life Output Signal Resolution Temperature Range Pressure Range Pressure Coefficient T90 Response Time Relative Humidity Range Weight Position Sensitivity Storage Life 0 - 1'000 ppm 2'000 ppm 2 years in air 17 - 40 nA/ppm 1) Recommended Storage Temperature Warranty Period 2 ppm 0 C to 45 C 1) Atmospheric 10% No data < 50 sec 15 % to 90 % R.H. non-condensing < 10 ppm Typical Baseline Range (pure air, 20C) Maximum Zero Shift (+20C to +40C) Long Term Output Drift Recommended Load Resistor Bias Voltage Repeatability Output Linearity ~ 13 g None Six months in container 5 C - 20 C 12 months from date of dispatch Compact-Size Outline Dimensions BOTTOM VIEW No data yet < 2% signal loss/month 10 Ohm Not recommended < 5% of signal Linear 45 Reference 45 Sensing Counter 17.0 mm PCD Nonconnected Pin CO cross sensitivity can be > 5% below 0 C. 24 mm CROSS-SENSITIVITY DATA Interfering Gas Concentration CO 2) 100 ppm Reading < 2 ppm 2) for temperature 20 C SIDE VIEW 32 mm 27.1 mm O-Ring 23.7 mm Performance data conditions: 20 C, 50% RH and 1013 mbar APPLICATIONS H2 Detection in H2/CO-Mixtures Medical Applications Safety and Environmental Control 3.5 mm Pin Projection 1 mm Pins on 17.0 mm PCD Note: The sensor must be operated by using a suitable gas ket for gas flow exposure The data contained in this document is for guidance only. Membrapor AG accepts no liability for any consequential losses, injury or damage resulting from the use of this document or the information contained within it. The data is given for guidance only. Customers should test under their own conditions, to ensure that the sensors are suitable for their own requirements. REV.: 6/2004 Phone: +41 43 311 72 00 Fax : +41 43 311 72 01 Email: info@membrapor.ch www.membrapor.ch Page 1 of 1 MEMBRAPOR AG Rautistrasse 164 CH-8048 Zurich Switzerland