MCC TM Micro Commercial Components 2EZ5.1D5 THRU 2EZ75D5 omponents 20736 Marilla Street Chatsworth !"# $ % !"# Features 2 W Glass Passivated Glass Passivation Junction Lead Free Finish/RoHS Compliant (Note C) ("P"Suffix designates Junction Silicon Compliant. See ordering information) Zener Diode 5.1-75 Volts Excellent Clamping Capability Mechanical Data DO-41 Epoxy meets UL 94 V-0 flammability rating Moisture Sensitivity Level 1 TERMINALS : Solder plated, solderable per MIL-STD-750, method 2026 POLARITY : Color band denotes positive end (cathode) D Maximum Ratings @ 25oC Unless Otherwise Specified Peak Pulse Power Dissipation (Note A) o Derate above 75 C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) (Note B) Operating And Storage Temperature Range A PD 2 26.7 Cathode Mark Watts mW/ oC B D IFSM 15 Amps C TJ , TSTG -55o C to +150o C DIMENSIONS NOTES: A. Mounted on 5.0mm2(.013mm thick) land areas. B. Measured on 8.3ms, single half sine-wave or equivalent DIM A B C D INCHES MIN .166 .080 .028 1.000 MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE square wave, duty cycle = 4 pulses per minute maximum. C. High Temperature Solder Exemption Applied, see EU Directive Annex 7. Revision: B www.mccsemi.com 1 of 5 2011/05/12 MCC 2EZ5.1D5 THRU 2EZ75D5 TM Micro Commercial Components 0 ELECTRICAL CHARACTERISTICS (T A=25 C unless otherwise noted) VF=1.2 V max , IF=200 mA for all types Type No. Nominal Zener (Note 1.) Voltage Vz@IZT current 2EZ5.1D5 2EZ5.6D5 2EZ6.2D5 2EZ6.8D5 2EZ7.5D5 2EZ8.2D5 2EZ9.1D5 2EZ10D5 2EZ11D5 2EZ12D5 2EZ13D5 2EZ14D5 2EZ15D5 2EZ16D5 2EZ17D5 2EZ18D5 2EZ19D5 2EZ20D5 2EZ22D5 2EZ24D5 2EZ27D5 2EZ30D5 2EZ33D5 2EZ36D5 2EZ39D5 2EZ43D5 2EZ47D5 2EZ51D5 2EZ56D5 2EZ62D5 2EZ68D5 2EZ75D5 Notes: Test Maximum Zener Impedance (Note 3) volts IZT ZZT @ IZT ZZk @ IZK IZK (Note 2.) mA Ohms Ohms mA 3.5 2.5 1.5 2.0 2.0 2.3 2.5 3.5 4.0 4.5 5.0 5.5 7.0 8.0 9.0 10 11 11 12 13 18 20 23 25 30 35 40 48 55 60 75 90 600 500 700 700 700 700 700 700 700 700 700 700 700 700 750 750 750 750 750 750 750 1000 1000 1000 1000 1500 1500 1500 2000 2000 2000 2000 5.1 5.6 6.2 6.8 7.5 8.2 9.1 10 11 12 13 14 15 16 17 18 19 20 22 24 27 30 33 36 39 43 47 51 56 62 68 75 98 89.5 80.5 73.5 66.5 61 55 50 45.5 41.5 38.5 35.7 33.4 31.2 29.4 27.8 26.3 25 22.8 20.8 18.5 16.6 15.1 13.9 12.8 11.6 10.6 9.8 9.0 8.1 7.4 6.7 1 1 1 1 0.5 0.5 0.5 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 Leakage Current IR uA Max 5.0 5.0 5.0 5.0 5.0 5.0 3.0 3.0 1.0 1.0 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 VR Volts 1.0 2.0 3.0 4.0 5.0 6.0 7.0 7.6 8.4 9.1 9.9 10.6 11.4 12.2 13.0 13.7 14.4 15.2 16.7 18.2 20.6 22.5 25.1 27.4 29.7 32.7 35.8 38.8 42.6 47.1 51.7 56.0 Maximum Zener Current IZM mA 356 324 292 266 242 220 200 182 166 152 138 130 122 114 107 100 95 90 82 76 68 60 55 50 47 43 39 36 32 29 27 24 1. TOLERANCES - Suffix indicates 5% tolerance any other tolerance will be considered as a special device. 2. ZENER VOLTAGE (Vz) MEASUREMENT - guarantees the zener voltage when measured at 40 ms from the diode body, and an ambient temperature of 25 3.ZENER IMPEDANCE (Zz) DERIVATION - The zener impedance is derived from the 60 cycle ac voltage, which results when an ac current having an rms falue equal to 10% of the dc zener current (I ZT or IZK) is . superimposed on IZT or IZK . Revision: B www.mccsemi.com 2 of 5 2011/05/12 MCC RATING AND CHARACTERISTICS CURVES TM 2EZ5.1 D5 THRU 2EZ75D5 Micro Commercial Components JL (t,D) TRANSIENT THERMAL RESISTANCE JUNCTION-TO-LEAD(/W) 30 D = 0.5 20 10 0.2 7 5 0.1 3 2 0.05 1 0.02 0.7 0.5 0.01 0.3 0.0001 NOTE BELOW 0.1 SECOND, THERMAL RESPONSE CURVE IS APPLICABLE TO ANY LEAD LENGTH (L) D=0 0.0002 0.0005 0.001 0.002 0.005 0.01 0.02 0.05 SINGLE PULSE TJL = JL(t)PPK REPETITIVE PULSES TJL = JL(t,D)PPK 0.1 0.2 0.5 1 2 5 10 Fig. 2-TYPICAL THERMAL RESPONSE PPK, PEAK SURGE POWER(WATTS) 500 150 IR, REVERSE LEADAGE(uAdc) @VR AS SPECIFIED IN ELEC. CHAR. TABLE 250 RECTANGULAR NONREPETITIVE WAVEFORM TJ = 25 PRIOR TO INITIAL PULSE 100 50 30 20 10 .1 .2 .3 5 1 2 3 5 10 20 50 100 0.005 0.003 0.002 0.001 0.0005 0.0003 0.0002 0.0001 1 2 5 10 20 50 100 200 500 1K P.W. PULSE WIDTH (ms) NOMINAL VZ (VOLTS) Fig. 3-MAXIMUM SURGE POWER Fig. 4-TYPICAL REVERSE LEAKAGE 8 200 6 VZ, TEMPERATURE C OEFFICIENT(mV) @ IZT VZ, TEMPERATURE COEFFICIENT(mV/) @ IZT 0.1 0.05 0.03 0.02 0.01 4 2 0 RANGE -2 -4 3 4 6 8 10 12 VZ, ZENER VOLTAGE @IZT (VOLTS) 100 RANGE 50 40 30 20 10 0 20 40 60 80 100 120 140 160 180 200 VZ, ZENER VOLTAGE @IZT (VOLTS) Fig. 5-UNITS 3.9 TO 12 VOLTS Revision: B Fig. 6-UNITS 10 TO 200 VOLTS www.mccsemi.com 3 of 5 2011/05/12 MCC RATING AND CHARACTERISTICS CURVES 2EZ5.1 D5 THRU 2EZ75D5 Micro Commercial Components 100 IZ, ZENER CURRENT (mA) IZ, ZENER CURRENT (mA) 100 50 30 20 10 5 3 2 1 0.5 0.3 0.2 0.1 0 1 2 3 4 5 6 7 8 50 30 20 10 5 3 2 1 0.5 0.3 0.2 0.1 0 9 10 10 100 50 30 20 10 5 3 2 1 0.5 0.3 0.2 120 140 160 180 70 80 90 100 Fig. 8-VZ = 12 THRU 82 VOLTS JL, JUNCTION-LEAD THERMAL RESISTANCE (/W) Fig. 7-VZ = 3.9 THRU 10 VOLTS 0.1 100 20 30 40 50 60 VZ, ZENER VOLTAGE (VOLTS) VZ, ZENER VOLTAGE (VOLTS) IZ, ZENER CURRENT (mA) TM 80 70 60 PRIMARY PATH OF CONDUCTION IS THROUGH THE CATHODE LEAD 50 40 30 20 10 0 0 200 1/8 1/4 3/8 1/2 5/8 3/4 7/8 1 L, LEAD LENGTH TO HEAT SINK (INCH) Fig. 9-VZ = 100 THRU 200 VOLTS Fig. 10-TYPICAL THERMAL RESISTANCE PD, MAXIMUM DISSIPATION (WATTS) VZ, ZENER VOLTAGE (VOLTS) 2.5 L = 3/8" (9.5mm) 2.0 1.5 1.0 0.5 0 0 25 50 75 100 125 150 175 TL, LEAD TEMPERATURE ( C) Fig. 11- POWER TEMPERATURE DERATING CURVE Revision: B www.mccsemi.com 4 of 5 2011/05/12 MCC TM Micro Commercial Components Ordering Information : Device Packing Part Number-TP Tape&Reel: 5Kpcs/Reel Part Number-AP Ammo Packing: 5Kpcs/Ammo Box Part Number-BP Bulk: 50Kpcs/Carton ***IMPORTANT NOTICE*** Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***LIFE SUPPORT*** MCC's products are not authorized for use as critical components in life support devices or systems without the express written approval of Micro Commercial Components Corporation. ***CUSTOMER AWARENESS*** Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. www.mccsemi.com Revision: B 5 of 5 2011/05/12 2