ASSP VCXO Application Specific Voltage Controlled Crystal Oscillator 7.0 x 5.0mm YNWMAX153 3.3V CMOS 153.6MHz WiMAX VCXO ASSP VCXOTM 7.0 x 5.0mm Ceramic SMD for WiMAX Package: Product Features Recommended Land Pattern: * Very low Pk to Pk jitter - 40ps Max * Low supply current - 30mA Max * Low power standby mode * RoHS Compliant Product Description CREATED USING CADSTD LITE FREEWARE FROM WWW.CADSTD.COM. NON-COMMERCIAL USE ONLY. This is an enhanced 3.3V, 153.6MHz with superb jitter and low operating current for providing clock references in telecom applications. Pin Functions: Pin Function 1 Voltage Control 2 Enable/Disable 3 Ground * E1 4 Output * CEPT1(x8) 5 N/C * Modems 6 V DD Applications CREATED USING CADSTD LITE FREEWARE FROM WWW.CADSTD.COM. NON-COMMERCIAL USE ONLY. *Extended high frequency power decoupling is recommended (see test circuit for minimum recommendation). To ensure optimal performance, do not route RF traces beneath the package. Part Ordering Information: YNWMAX153 SaRonix-eCeraTM is a Pericom(R) Semiconductor company * US: +1-408-435-0800 TW: +886-3-4518888 * www.pericom.com 11-0008 All specifications are subject to change without notice. YNWMAX153 Rev 05 03/04/11 1 3.3V CMOS 153.6 MHz WiMAX VCXO YNWMAX153 ASSP VCXO Application Specific Voltage Controlled Crystal Oscillator 7.0 x 5.0mm Electrical Performance Parameter Min. Output Frequency Typ. Max. Units 153.6 3.135 Supply Voltage V DD 3.465 3.3 V Supply Current, Output Enabled 30 mA Frequency Stability 35 ppm Operating Temperature Range -40 Output Logic 0, VOL Output Logic 1, VOH +85 C 10% V DD V 15 pF 90% V DD See Note 1 below V Output Load Duty Cycle Notes MHz 45 55 % Measured 50% V DD 5 ns Measured 20/80% of waveform Jitter, Phase 1 ps, RMS(1-s) 12kHz~20 MHz Frequency Band Jitter, Peak to Peak 40 ps, Pk-Pk Rise and Fall Time 100.000 Random Periods Phase Noise -65 -50 dBc/Hz At 10Hz offset Phase Noise -90 -85 dBc/Hz At 100Hz offset Phase Noise -120 -115 dBc/Hz At 1kHz offset Phase Noise -135 -130 dBc/Hz At 10kHz offset Notes: 1. Stability includes all combinations of operating temperature, load changes, rated input (supply) voltage changes, initial calibration tolerance (25C), aging (10 years at +40C average effective ambient temperature), shock and vibration. 2. For specifications other than those listed, please contact sales. Voltage Control Function Parameter Min. Typ. Max. Units Notes Pullability 75 110 ppm Control Voltage Range 0.3 3.0 V As rated V For RMT Nominal Frequency % Positive Transfer Slope k Control Voltage Pin Center Control Voltage 1.65 Monotonic Linearity 10 Input Impedance 130 Output Enable / Disable Function Parameter Min. Input Voltage (pin 2), Output Enable Typ. Max. Units 3.0 Input Voltage (pin 2), Output Disable (low power standby) 0.3 Notes V or open V Output is Hi-Z Absolute Maximum Ratings Parameter Storage Temperature Min. Typ. -55 Max. Units +125 C Notes For the latest product information visit: http://www.pericom.com/products/timing/oscillators/YNWMAX153/ For test circuit go to: http://www.pericom.com/pdf/sre/tc_vc6cmos.pdf For soldering reflow profile and reliability test ratings go to: http://www.pericom.com/pdf/sre/reflow.pdf For tape and reel information go to: http://www.pericom.com/pdf/sre/tr_7050_xo.pdf SaRonix-eCeraTM is a Pericom(R) Semiconductor company * US: +1-408-435-0800 TW: +886-3-4518888 * www.pericom.com 11-0008 All specifications are subject to change without notice. YNWMAX153 Rev 05 03/04/11 2