PDB260 Series 260 W 260 W Programmable Constant Current LED Driver with 0-10 V Dimming Input Voltage Max. Output Power Efficiency Max. Case Temperature THD Power Factor Dimming Type and Range Startup Time 120 to 277 Vac nominal 260 W up to 93% typical 90C (measured at the hot spot) < 20% (from 100% to 50% of max rated power > 0.9 (from 100% to 50% of max rated power) 0 - 10V, 1 -100% (% of Iout) 500 ms typical Dim + Dim - PDB260 series Aux + Aux - 0-10 V Dimmer Sensor LEDs + LEDs - Nominal Max Input Output Iout 1 Vout 1 Iout 2 Vout 2 Voltage Power (mA) (Vdc) (mA) (Vdc) (Vac) (W) PDB260W-0860-400 120 to 277 260 430 to 860 228 to 300 325 to 650 304 to 400 PDB260W-1300-280 120 to 277 260 650 to 1300 152 to 200 465 to 930 213 to 280 PDB260W-1700-210 120 to 277 260 850 to 1700 114 to 150 620 to 1240 160 to 210 Ordering Part Number For additional options of output current and output voltage, contact your sales representative or send an email to: SaveEnergy@erp-power.com PROGRAMMING Aluminum Case L 217/240.5 x W 50.8 x H 38.5 mm (L 8.54/9.47 x W 2.00 x H 1.52 in) BASE FEATURES * Non-linear 0-10V dimming profile with dim-to-off (10V to 9.1V=100%, 1.5V to 0.6V=1%, <0.6V=dim-to-off) * Auxiliary output 12 V/100 mA * IP66-rated case with silicone-based potting * Surge protection: * IEC61000-4-5: 4 kV line to line/4 kV line to earth * 2.5 kV ring wave: ANSI/IEEE c62.41.1-2002 & c62.41.2-2002 category A * Ripple: 25% * Protections: Output open load, over-current and short-circuit (hiccup), over-power, over-temperature with foldback and autorecovery * Conducted and radiated EMI: Compliant with FCC CFR Title 47 Part 15 Class A at 120 Vac & 277 Vac and EN55015 (CISPR 15) at 220/230/240 Vac * Lifetime: 50,000 hours @ Tc = 70C * 90C maximum case hot spot temperature * UL Class P CHINA Operations tel: +86-756-6266298 No. 8 Pingdong Road 2 Zhuhai, Guangdong, China 519060 www.erp-power.com * Dual output voltage range selection * Serial port programming * Current: 100% to 50% in each voltage range * Data log read: SKU, S/N, lot code, hours of operation, FW rev., fault events: power failure, transients (short or surge), thermal OPTIONS * Ripple <10% @ 120 Hz & <8% @ 120 Hz (IEEE1789) * Auxiliary output: up to 24 V / down to 3.3 V / up to 500 mA * Alternate 0-10V dimming profiles: Linear, Logarithmic, Ballast type Mark7 (IEC60929, ANSI C82.11) * Energy metering (as part of future software upgrade) APPLICATIONS * Street Lights * Wide-area Lighting ! Industrial LED Lighting ! Outdoor lighting 5 SaveEnergy@erp-power.com USA Headquarters tel: +1-805-517-1300 893 Patriot Drive, Suite E Moorpark, CA 93021, USA