Thyristors Surface Mount - 250V > MAC3030-8 MAC3030-8 Pb Description Designed primarily for full-wave AC control applications, such as light dimmers, motor controls, heating controls and power supplies; or wherever full-wave silicon gate controlled solid-state devices are needed. Triac type thyristors switch from a blocking to a conducting state for either polarity of applied main terminal voltage with positive or negative gate triggering. Features * Blocking Voltage to 250 Volts * All Diffused and Glass Passivated Junctions for Greater Parameter Uniformity and Stability * Small, Rugged, Thermowatt Construction for Low Thermal Resistance, High Heat Dissipation and Durability * Gate Triggering Guaranteed in Four Modes (Quadrants) * Pb-Free Packages are Available Functional Diagram Pin Out MT 2 MT 1 G CASE 221A STYLE 4 1 Additional Information 2 Datasheet Resources Samples (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 Maximum Ratings (TJ = 25C unless otherwise noted) Symbol Value Unit Peak Repetitive Off-State Voltage (Note 1) (- 40 to 1125C, Sine Wave, 50 to 60 Hz, Gate Open) Rating VDRM, VRRM 250 V On-State RMS Current (TC = +70C) Full Cycle Sine Wave, 50 to 60 Hz IT 8.0 A (RMS) Peak Non-Repetitive Surge Current (One Full Cycle Sine Wave, 60 Hz, TC = +25C) Preceded and followed by rated current ITSM 80 A Circuit Fusing Consideration (t = 8.3 ms) I2t 26 Asec Peak Gate Current, (TC = +70C, Pulse Width = 10 s) IGM 2.0 A Peak Gate Power (TC = +70C, Pulse Width = 10 s) PGM 20 PG (AV) 0.35 W W Operating Junction Temperature Range TJ -40 to +125 C Storage Temperature Range Tstg -40 to +150 C Average Gate Power (TC = +70C, t = 8.3 ms) Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1.VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. Thermal Characteristics Rating Symbol Value Unit RJC RJA 2.0 62.5 C/W TL 260 C Junction-to-Case (AC) Junction-to-Ambient Thermal Resistance, Maximum Lead Temperature for Soldering Purposes, 1/8" from case for 10 seconds Electrical Characteristics - OFF (TJ = 25C unless otherwise noted ; Electricals apply in both directions) Characteristic Peak Repetitive Blocking Current (VD = VDRM = VRRM; Gate Open) Symbol Min IDRM, IRRM - - 1.0 - - 2.0 TJ = 25C TJ = 125C Typ Max Unit mA Electrical Characteristics - ON (TJ = 25C unless otherwise noted; Electricals apply in both directions) Characteristic Symbol Min Typ Max Unit VTM - 1.2 1.65 V MT2(+), G(+) - 12 50 MT2(+), G(-) - 12 50 - 20 50 Peak On-State Voltage (ITM = 11 A Peak, Pulse Width 2 ms, Duty Cycle 2%) Gate Trigger Current (Continuous dc) (VD = 12 V, RL = 100 Ohms) Gate Trigger Voltage (Continuous dc) (VD = 12 V, RL = 100 ) MT2(-), G(-) IGT MT2(-), G(+) - 35 75 MT2(+), G(+) - 0.9 2.0 MT2(+), G(-) mA - 0.9 2.0 - 1.1 2.0 - 1.4 2.5 VGD 0.2 - - V Holding Current (VD = 12 Vdc, Gate Open, Initiating Current = 200 mA)) IH - 6.0 50 mA Turn-On Time (Rated VDRM, ITM = 11 A) (IGT = 120 mA, Rise Time = 0.1 s, Pulse Width = 2 s) tgt - 1.5 - s MT2(-), G(-) VGT MT2(-), G(+) Gate Non-Trigger Voltage (Continuous DC), (VD = 12 V, TC = 110C, RL = 100 ) All Four Quadrants V (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 Dynamic Characteristics Characteristic Critical Rate of Rise of Commutation Voltage (VD = Rated VDRM, ITM = 14 A, Commutating di/dt = 5.0 A/ms, Gate Unenergized, TC = 70C) Critical Rate of Rise of Off-State Voltage (VD = Rated VDRM, Exponential Waveform, Gate Open, TC = 70C) Symbol Min Typ Max Unit (di/dt)c - 5.0 - A/ms dv/dt - 100 - V/s Voltage Current Characteristic of SCR Symbol Parameter VDRM Peak Repetitive Forward Off State Voltage IDRM Peak Forward Blocking Current VRRM Peak Repetitive Reverse Off State Voltage IRRM Peak Reverse Blocking Current VTM Maximum On State Voltage IH +C urrent V TM on stat e I RR M at V RR M Holding Current Quadrant Definitions for a Triac IH Quadrant 3 Main Terminal 2 MT2 POSITIVE (Positive Half Cycle) + +V oltage I DR M at V DR M V TM MT 1 MT 1 RE F RE F ( ) MT 2 ( ) MT 2 I GT Q u a dr a n t III off stat e Q ua dr a nt I (+) I GT GA TE ( ) I GT GA TE IH (+) MT 2 (+) MT 2 Q u a dr a n t II Quadrant 1 Main Terminal 2 + +I GT Q u a dr a n t IV (+) I GT GA TE ( ) I GT GA TE MT 1 MT 1 RE F RE F MT2 NEGA TIVE (Negative Half Cycle) All polarities are referenced to MT1. With in phase signals (using standard AC lines) quadrants I and III are used (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 Figure 2. Power Dissipation TC, Maximum Allowable Case Temperature (C) Figure 1. Current Derating IT(RMS), RMS On-State Current (AMPS) Figure 4. Maximum Non-Repetitive Surge Current Figure 5. Typical Gate Trigger Voltage VGT, GATE TRIGGER VOLTAGE (NORMALIZED) Figure 3. Maximum On-State Characteristics 2.0 1.6 OFF-STATE VOLTAGE = 12 Vdc ALL MODES 1.2 0.8 0.4 0 04 0 20 TC, CASE TEMPERATURE (C) 60 80 (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 Figure 7. Typical Holding Current 2.8 2.0 IH, HOLDING CURRENT (NORMALIZED) I GT, GATE TRIGGER CURRENT (NORMALIZED) Figure 6. Typical Gate Trigger Current OFF-STATE VOLTAGE = 12 Vdc ALL MODES 1.6 1.2 0.8 0.4 0 2.4 OFF-STATE VOLTAGE = 12 Vdc ALL MODES 2.0 1.6 1.2 0.8 0.4 0 20 00 20 40 TC, CASE TEMPERATURE (C) 60 8 40 20 40 60 80 TC, CASE TEMPERATURE (C) Figure 8. Thermal Response (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19 Thyristors Surface Mount - 250V > MAC3030-8 Dimensions Part Marking System 4 SEATING PLANE B F 4 Q 12 C T S A U 3 1 H 2 3 MAC30308G YMAXX TO 220AB CASE 221A STYLE 12 K Z x =D, M, or N Y =Year M =Month A =Assembly Site XX =Lot Serial Code G =Pb-Free Package R L V J G D N Dim Inches Millimeters Pin Assignment Min Max Min Max 1 Main Terminal 1 A 0.590 0.620 14.99 15.75 2 Main Terminal 2 B 0.380 0.420 9.65 10.67 3 Gate C 0.178 0.188 4.52 4.78 4 No Connection D 0.025 0.035 0.64 0.89 F 0.142 0.147 3.61 3.73 G 0.095 0.105 2.41 2.67 H 0.110 0.130 2.79 3.30 J 0.018 0.024 0.46 0.61 K 0.540 0.575 13.72 14.61 L 0.060 0.075 1.52 1.91 N 0.195 0.205 4.95 5.21 Q 0.105 0.115 2.67 2.92 R 0.085 0.095 2.16 2.41 S 0.045 0.060 1.14 1.52 T 0.235 0.255 5.97 6.47 U 0.000 0.050 0.00 1.27 V 0.045 --- 1.15 --- Z --- 0.080 --- 2.04 Ordering Information Device Package Shipping MAC3030-8 TO-220AB 500 Units/ Box MAC3030-8G TO-220AB (Pb-Free) 500 Units/ Box 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2.CONTROLLING DIMENSION: INCH. 3.DIMENSION Z DEFINES A ZONE WHERE ALL BODY AND LEAD IRREGULARITIES ARE ALLOWED. Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and test each product selected for their own applications. Littelfuse products are not designed for, and may not be used in, all applications. Read complete Disclaimer Notice at http://www.littelfuse.com/disclaimer-electronics. (c) 2019 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 07/12/19