MAC3030-8G - LITTELFUSE - Datasheet.Directory

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

• Blocking Voltage to 250

Volts

• All Diffused and Glass

Passivated Junctions

for Greater Parameter

Uniformity and Stability

• Small, Rugged,

Thermowatt Construction

for Low Thermal

Resistance, High Heat

Dissipation and Durability

• Gate Triggering

Guaranteed in Four

Modes (Quadrants)

• Pb−Free Packages are

Available

Features

Designed primarily for full-wave AC control applications,

such as light dimmers, motor controls, heating controls

and power supplies; or wherever full−wave silicon gate

controlled solid−state devices are needed. Triac type

thyristors switch from a blocking to a conducting state

for either polarity of applied main terminal voltage with

positive or negative gate triggering.

Description

MAC3030-8

Additional Information

Samples

Resources

Datasheet

Functional Diagram

MT 1

MT 2

Pin Out

CASE 221A

STYLE 4

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

Rating Symbol Value Unit

Peak Repetitive Off−State Voltage (Note 1)

(− 40 to 1125°C, Sine Wave, 50 to 60 Hz, Gate Open) VDRM,

VRRM

250 V

On-State RMS Current (TC = +70°C) Full Cycle Sine Wave, 50 to 60 Hz IT (RMS) 8.0 A

Peak Non-Repetitive Surge Current (One Full Cycle Sine Wave, 60 Hz, TC = +25°C)

Preceded and followed by rated current ITSM 80 A

Circuit Fusing Consideration (t = 8.3 ms) I2t 26 A²sec

Peak Gate Current, (TC = +70°C, Pulse Width = 10 μs) IGM 2.0 A

Peak Gate Power (TC = +70°C, Pulse Width = 10 μs) PGM 20 W

Average Gate Power (TC = +70°C, t = 8.3 ms) PG (AV) 0.35 W

Operating Junction Temperature Range TJ-40 to +125 °C

Storage Temperature Range Tstg -40 to +150 °C

Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied.

Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability.

1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative

potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.

Maximum Ratings (TJ = 25°C unless otherwise noted)

Thermal Characteristics

Rating Symbol Value Unit

Thermal Resistance, Junction−to−Case (AC)

Junction−to−Ambient RƟJC

RƟJA

2.0

62.5 °C/W

Maximum Lead Temperature for Soldering Purposes, 1/8” from case for

10 seconds TL260 °C

Characteristic Symbol Min Ty p Max Unit

Peak On−State Voltage (ITM = ±11 A Peak, Pulse Width ≤2 ms,

Duty Cycle ≤2%) VTM −1.2 1.65 V

Gate Trigger Current

(Continuous dc)

(VD = 12 V, RL = 100 Ohms)

MT2(+), G(+)

IGT

−12 50

MT2(+), G(−) − 12 50

MT2(−), G(−) − 20 50

MT2(−), G(+) − 35 75

Gate Trigger Voltage

(Continuous dc)

(VD = 12 V, RL = 100 Ω)

MT2(+), G(+)

VGT

− 0.9 2.0

MT2(+), G(−) − 0.9 2.0

MT2(−), G(−) − 1.1 2.0

MT2(−), G(+) − 1.4 2.5

Gate Non−Trigger Voltage (Continuous DC), (VD = 12 V, TC = 110°C, RL = 100 Ω) All

Four Quadrants VGD 0.2 − − V

Holding Current (VD = 12 Vdc, Gate Open, Initiating Current = ±200 mA)) IH− 6.0 50 mA

Turn-On Time (Rated VDRM, ITM = 11 A)

(IGT = 120 mA, Rise Time = 0.1 s, Pulse Width = 2 s) tgt –1.5 – μs

Electrical Characteristics - ON (TJ = 25°C unless otherwise noted; Electricals apply in both directions)

Electrical Characteristics - OFF (TJ = 25°C unless otherwise noted ; Electricals apply in both directions)

Characteristic Symbol Min Ty p Max Unit

Peak Repetitive Blocking Current

(VD = VDRM = VRRM; Gate Open) TJ = 25°C

TJ = 125°C IDRM,

IRRM

- - 1.0 mA

- - 2.0

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

Characteristic Symbol Min Ty p Max Unit

Critical Rate of Rise of Commutation Voltage

(VD = Rated VDRM, ITM = 14 A, Commutating di/dt = 5.0 A/ms, Gate Unenergized, TC =

70°C) (di/dt)c − 5.0 − A/ms

Critical Rate of Rise of Off-State Voltage

(VD = Rated VDRM, Exponential Waveform, Gate Open, TC = ±70°C) dv/dt − 100 − V/µs

Voltage Current Characteristic of SCR

Quadrant Deﬁnitions for a Triac

Symbol Parameter

VDRM Peak Repetitive Forward Off State Voltage

IDRM Peak Forward Blocking Current

VRRM Peak Repetitive Reverse Off State Voltage

IRRM Peak Reverse Blocking Current

VTM Maximum On State Voltage

IHHolding Current

Dynamic Characteristics

+C urrent

+V oltage

VTM

IDR M at VDR M

on stat e

off stat e

IRR M at VRR M

Quadrant 1

Main Terminal 2 +

Quadrant 3

Main Terminal 2 VTM

All polarities are referenced to MT1.

With in phase signals (using standard AC lines) quadrants I and III are used

MT 1

(+) IGT

GA TE

(+) MT 2

RE F

MT 1

() IGT

GA TE

(+) MT 2

RE F

MT 1

(+) IGT

GA TE

() MT 2

RE F

MT 1

() IGT

GA TE

() MT 2

RE F

MT2 NEGA TIVE

(Negative Half Cycle)

MT2 POSITIVE

(Positive Half Cycle)

VItnardauQIIItnardauQ

ItnardauQIItnardauQ

IGT +I GT

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

IT(RMS), RMS On-State Current (AMPS)

, Maximum Allowable

Case Temperature (°C)

Figure 1. Current Derating Figure 2. Power Dissipation

Figure 4. Maximum Non−Repetitive Surge CurrentFigure 3. Maximum On−State Characteristics

Figure 5. Typical Gate Trigger Voltage

60 80

2.0

OFF-STATE VOLTAGE = 12 Vdc

ALL MODES

04 0

TC, CASE TEMPERATURE (ϒC)

0.4

0.8

1.2

1.6

V , GATE TRIGGER VOLTAGE (NORMALIZED)

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

Figure 8. Thermal Response

02 00 20 40 60 8

0.4

0.8

1.2

1.6

2.0

OFF-STATE VOLTAGE = 12 Vdc

ALL MODES

TC, CASE TEMPERATURE (ϒC)

I , GATE TRIGGER CURRENT (NORMALIZED)

Figure 6. Typical Gate Trigger Current Figure 7. Typical Holding Current

2.4

0.4

0.8

1.2

1.6

2.0

2.8

OFF-STATE VOLTAGE = 12 Vdc

ALL MODES

TC, CASE TEMPERATURE (ϒC)

06040204

I , HOLDING CURRENT (NORMALIZED)

Speciﬁcations are subject to change without notice.

Revised: 07/12/19

Thyristors

Surface Mount – 250V > MAC3030-8

Device Package Shipping

MAC3030-8 TO-220AB 500 Units/ Box

MAC3030-8G TO-220AB

(Pb-Free) 500 Units/ Box

Dimensions Part Marking System

12 3

SEATING

PLANE

Pin Assignment

1Main Terminal 1

2Main Terminal 2

3 Gate

4 No Connection

Ordering Information

TO 220AB

CASE 221A

STYLE 12

123

1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982.

2. CONTROLLING DIMENSION: INCH.

3. DIMENSION Z DEFINES A ZONE WHERE ALL BODY AND LEAD IRREGULARITIES ARE

ALLOWED.

Dim Inches Millimeters

Min Max Min Max

A0.590 0.620 14.99 15.75

B0.380 0.420 9.65 10.67

C0.178 0.188 4.52 4.78

D0.025 0.035 0.64 0.89

F0.142 0.147 3.61 3.73

G0.095 0.105 2.41 2.67

H0.110 0.130 2.79 3.30

J0.018 0.024 0.46 0.61

K0.540 0.575 13.72 14.61

L0.060 0.075 1.52 1.91

N0.195 0.205 4.95 5.21

Q0.105 0.115 2.67 2.92

R0.085 0.095 2.16 2.41

S0.045 0.060 1.14 1.52

T0.235 0.255 5.97 6.47

U0.000 0.050 0.00 1.27

V0.045 --- 1.15 ---

Z--- 0.080 --- 2.04

Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and

test each product selected for their own applications. Littelfuse products are not designed for, and may not be used in, all applications.

Read complete Disclaimer Notice at http://www.littelfuse.com/disclaimer-electronics.

MAC30308G

YMAXX

x =D, M, or N

Y =Year

M =Month

A =Assembly Site

XX =Lot Serial Code

G =Pb-Free Package