24 MAD00020KEM
MN101C62 Series
Type MN101C62D MN101C62F MN101CF62G
Internal ROM type Mask ROM FLASH
ROM (byte) 64K96K128K
RAM (byte) 2K4K10K
Package (Lead-free) LQFP080-P-1414A
Minimum Instruction
Execution Time
[Standard]
0.10 µs (at 4.5 V to 5.5 V, 20 MHz)
0.25 µs (at 2.7 V to 5.5 V, 8 MHz)
1.00 µs (at 2.0 V to 5.5 V, 2 MHz)*
125 µs (at 2.0 V to 5.5 V, 32 kHz)*
[Double speed]
0.125 µs (at 4.5 V to 5.5 V, 8 MHz)
0.25 µs (at 3.0 V to 5.5 V, 4 MHz)
62.5 µs (at 2.0 V to 5.5 V, 32 kHz)*
*: The lower limit for operation guarantee for flash memory built-in type is 2.5 V.
Interrupts
Watchdog. External 0 to 4. Timer 0 to 4. Timer 6. Timer 7 (2 systems). Timer 8 (2 systems). Time base. Automatic transfer finish. Serial 0
(2 systems). Serial 1 (2 systems). Serial 2. A/D conversion finish. Key interrupt
Timer Counter
8-bit timer × 6
Timer 0 ..................Square-wave/8-bit PWM output. Event count. Remote control carrier output. Simple pulse width measurement
Timer 1 ..................Square-wave output. Event count. Synchronous output event. Serial baud rate timer
Timer 2 ..................Square-wave output. Event count. Synchronous output event. Simple pulse width measurement. Real time output
control. Serial baud rate timer
Timer 3 ..................Square-wave output. Event count. Remote control carrier output. Serial baud rate timer
Timer 4 ..................Square-wave/8-bit PWM output. Event count. Remote control carrier output. Simple pulse width measurement
Timer 6 ..................8-bit freerun timer
Timer 0, 1 can be cascade-connected
Timer 2, 3 can be cascade-connected
16-bit timer × 2
Timer 7 ..................Square-wave output. 16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output
event. Pulse width measurement. Input capture. Real time output control
Timer 8 ..................Square-wave output. 16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output
event. Pulse width measurement. Input capture. Real time output control
Watchdog timer × 1
Serial interface
Synchronous type/UART (full-duplex) × 2: Serial 0, 1
Synchronous type/Single-master I2C × 1: Serial 2
I/O Pins
I/O 68 : Common use. Specified pull-up resistor available. Input/output selectable (bit unit)
A/D converter
10-bit × 8 channels (with S/H)
Special Ports
Buzzer output. Remote control carrier output. High-current drive port
ROM Correction
Correcting address designation: Up to 3 addresses possible