T-1 (3mm) SOLID STATE LAMP PRELIMINARY SPEC Part Number: WP7104SEC/J3 Hyper Red Features Description zLow power consumption. The Hyper Red device is based on light emitting diode chip zPopular T-1 diameter package. made from AlGaInP. zGeneral purpose leads. zReliable and rugged. zLong life - solid state reliability. zAvailable on tape and reel. zRoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 1 OF 4 ERP: 1101024770 Selection Guide Part No. Dice WP7104SEC/J3 Lens Type Hyper Red (AlGaInP) WATER CLEAR Viewing Angle [1] Iv (mcd) [2] @ 20mA Min. Typ. 21/2 3300 7000 34 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. Luminous intensity/ luminous Flux: +/-15%. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. peak Peak Wavelength Hyper Red D [1] Dominant Wavelength 1/2 Max. Units Test Conditions 640 nm IF=20mA Hyper Red 625 nm IF=20mA Spectral Line Half-width Hyper Red 25 nm IF=20mA C Capacitance Hyper Red 27 pF VF=0V;f=1MHz VF [2] Forward Voltage Hyper Red 2.2 2.8 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. Absolute Maximum Ratings at TA=25C Parameter Hyper Red Units Power dissipation 84 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 3 Seconds Lead Solder Temperature [3] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 2 OF 4 ERP: 1101024770 RED Hyper Red WP7104SEC/J3 SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 3 OF 4 ERP: 1101024770 PACKING & LABEL SPECIFICATIONS SPEC NO: DSAI9666 REV NO: V.3 APPROVED: WYNEC CHECKED: Allen Liu WP7104SEC/J3 DATE: MAR/05/2009 DRAWN: Y.F.Lu PAGE: 4 OF 4 ERP: 1101024770