TOSHIBA TC74HC109AP/AF/AFN TOSHIBA CMOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC TC74HC109AP, TC74HC109AF, TC74HC109AFN (Note) The JEDEC SOP (FN) is not available in DUAL J-K FLIP-FLOP WITH PRESET AND CLEAR Japan. The TC74HC109A is a high speed CMOS J-K FLIP FLOP NN fabricated with silicon gate C2MOS technology. - : ery It achieves the high speed operation similar to equivalent 16 hs ayy in LSTTL while maintaining the CMOS low power dissipation. i py SS In accordance with the logic levels applied to the J and K ' . : P ( DIP16-P-300-2.54A ) inputs, the outputs change state on the positive going Weight : 1.00g (Typ.) transition of the clock pulse. CLR and PR are independent of the clock and are accomplished by a low logic level on the corresponding input. All inputs are equipped with protection circuits against static discharge or transient excess voltage. F (SOP16-P-300-1.27) FN(SOL16-P-150-1.27) Weight : 0.18g(Typ.) = Weight : 0.13g (Typ.) FEATURES : PIN ASSIGNMENT @ High Speedeessssssseeeverssesses fax = 63MHz (typ.) at Vec =5V / Low Power Dissipation: log = 2uvA(Max.) at Ta=25C 1crR 1 16 Voc e High Noise Immunity se taeeeeeeececenes Vain = Vnit = 28% Vec (Min.) J 2 L '] 15 2CLR e Output Drive Capability ----------+-- 10 LSTTL Loads 1K 3Q r] 14 2J Symmetrical Output Impedance---| loy | =lo. = 4mA(Min.) 1cK 4 {J r] 13 2K Balanced Propagation Delays-- toLH=toHL 1PR 5 f] 12 2cK e Wide Operating Voltage Range:: Vcc (opr.) = 2V~ 6V 19 6 r]11 2PR e Pin andFunction Compatible with 74LS109 12 70 r] 10 2Q GND 8 [ rr] 9 2Q (TOP VIEW) TRUTH TABLE IEC LOGIC SYMBOL INPUTS OUTPUTS ee = = FUNCTION CLR | P J K CK Q Q L H x X x L H CLEAR IPR HT Le |x] xi{xfu te PRESET 1c L L Xx x x H H _1K H | H | L | H | _f | Qn | Qn} NO CHANGE TLR H|H|{|tI{eLe] ff edau am H | H}]}H]H]_f JH L 2cK H | H | H | L | _f | Gy | Qn TOGGLE _ H | H | X | X | L | Qn | Qn NO CHANGE X : Dont Care 1 2001-05-17TOSHIBA TC74HC109AP/AF/AFN SYSTEM DIAGRAM ck ]>4+|[>>o_ # 2 7 Vv ao - a Bi | 2 2001-05-17TOSHIBA TC74HC109AP/AF/AFN ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL VALUE UNIT *500mW in the range of Ta= Supply Voltage Range Vec 0.5~7 V 40C~65C. From Ta=65C 05~ to 85C a derating factor of DC Input Voltage Vin 0.5~Vcc + 0.5 Vv ~ 1OmW/C shall be applied DC Output Voltage Vout 0.5~Vee + 0.5 V until 300mW. Input Diode Current lik +20 mA Output Diode Current lox +20 mA Dc Output Current lout +25 mA DC Vcc /Ground Current lec +50 mA Power Dissipation Pp 500 (DIP)* / 180 (SOP) mw Storage Temperature Tstg 65~150 a Gi RECOMMENDED OPERATING CONDITIONS PARAMETER SYMBOL VALUE UNIT Supply Voltage Vec 2~6 Vv Input Voltage Vin O~Vec Vv Output Voltage Vout O~Vec Vv Operating Temperature Topr 40~85 a Gi 0~ 1000 (Vec = 2.0V) Input Rise and Fall Time tr, tr O~ 500 (Vcc = 4.5V) ns DC ELECTRICAL CHARACTERISTICS Ta=25C Ta = 40~85C PARAMETER SYMBOL TEST CONDITION Vec UNIT (V) | MIN. | TYP. | MAX. | MIN. | MAX. High - Level 2.0 | 1.50 7 7 1.50 7 Input Voltage Vig 4.5 | 3.15 3.15 V p g 6.0] 4.20] - | 420] - Low - Level 2.0 0.50 0.50 Inout Voltage ViL 4.5 1.35 1.35 V P g 60} | | 180} | 1.80 2.0 | 1.9 2.0 1.9 lop=20vA | 45] 44 | 45 | 44 - High - Level Vou | Mine 6.0| 5.9 | 6.0 5.9 Vv Output Voltage Vin or Vit lon = 4 mA] 4.5] 4.18 | 4.31 4.13 _ lon= 5.2mA | 6.0 | 5.68 | 5.80 | | 5.63] 2.0 0.0 0.1 _ 0.1 lor = 20uA 45| | 00 | 0.1 | 0.1 Low - Level Vo. | Mine 60} |o00 | 01 | [01 |] y Output Voltage Vin or Vit lo.=4 mA 45| | 0.17 | 0.26] | 0.33 lo. =5.2mA 6.0 _ 0.18 | 0.26 _ 0.33 Input Leakage Current lin Vin =Vcc or GND 6.0 _ _ +0.1 _ +1.0 A Quiescent Supply Current lec Vin=Vcc or GND 6.0 _ _ 2.0 _ 20.0 | 3 2001-05-17TOSHIBA TC74HC109AP/AF/AFN TIMING REQUIREMENTS ( Input t, = t;= 6ns ) Ta =25C Ta = -40~85C PARAMETER SYMBOL TEST CONDITION Vav) TYP. LIMIT LIMIT UNIT Minimum Pulse Width twa) ae _ 2? (CK) tw) 6.0 = 13 16 Minimum Pulse Width t ae _ 2? Dp TID W(L) : (PR, CLR ) 6.0 = 13 16 2.0 _- 75 95 Minimum Setup Time t; 4.5 _ 15 19 ns 6.0 _ 13 16 2.0 _ 0 0 Minimum Hold Time th 4.5 _ 0 0 6.0 _ ) ) Minimum Removal Time t a8 _ O 63 Dp Tip rem . (PR, CLR) 6.0 - 9 "1 2.0 _ 6 5 Clock Frequency f 4.5 _ 31 25 MHz 6.0 = 36 29 AC ELECTRICAL CHARACTERISTICS ( C, = 15pF, Vcc=5V, Ta= 25C, Input t, = t;=6ns) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT t Output Transition Time L. _ 6 12 THL Propagation Delay Time toy _ 13 26 ns (CKQ, Q) toHL Propagation Delay Time toi _ 13 26 (PR, CLRQ, Q) tout Maximum Clock Frequency | fryax 33 63 MHz AC ELECTRICAL CHARACTERISTICS ( C, = 50pF, Input t, =t;=6ns ) Ta =25C Ta = 40~85C PARAMETER SYMBOL | TEST CONDITION Vact)| MIN. | TYP. | MAX.| MIN. | MAX. UNIT t 2.0 _ 30 75 _ 95 Output Transition Time to 45 8 15 19 THL 6.0 _ 7 13 _ 16 Propagation Delay Time toy ae _ 20 130 _ 190 ns (CKQ, Q) tone 60 | 13 26 | 32 Propagation Delay Time ton ae _ 2 130 _ 130 (PR, CLRQ, Q) tpHL 6.0 13 26 = 32 2.0 6 17 _ 5 _- Maximum Clock Frequency fax 4.5 31 59 25 |MHz 6.0 36 67 = 29 _ Input Capacitance Cin _ 5 10 _ 10 FE Power Dissipation Capacitance | Cpp (1) _ 41 _ _ _ P Note (1) Cpp is defined as the value of the internal equivalent capacitance which is calculated from the operating current consumption without load. Average operating current can be obtained by the equation: lec (Opr) =Cpp + Veco * fint lec /2 (per F/F) 4 2001-05-17TOSHIBA TC74HC109AP/AF/AFN DIP 16PIN PACKAGE DIMENSIONS (DIP16-P-300-2.54A ) Unit in mm 18 moo ee & a uu + a ~2 3 3 / 19.75MAx 19.250.2 0.95:0.1 Q.735TYP | | Weight : 1.00g (Typ.) Unit in mm SOP 16PIN (200mil BODY) PACKAGE DIMENSIONS ( SOP16-P-300-1.27 ) 16 90 HHEHHEEE HEH HAHAHA oe 0.705TYP i 0.43104 10.25 0) 1.27 10.8MAX 0.1578-45 0,810.2 Weight : 0.18g (Typ.) 5 2001-05-17TOSHIBA TC74HC109AP/AF/AFN SOP 16PIN (150mil BODY) PACKAGE DIMENSIONS (SOL16-P-150 -1.27) Unit in mm Weight : 0.13g (Typ.) 0.505TYP 16 9 ARAAARE HH oH 0.42+0.07 10.25 @ | 0.17540.075 lh B7540.2 6.0+0.2 1.75MAX | wt HE L BE EAH E__4 1 8 9.9+0.1 A014) (Note) This package is not available in Japan. 2001-05-17TOSHIBA TC74HC109AP/AF/AFN RESTRICTIONS ON PRODUCT USE 000707EBA @ TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the Handling Guide for Semiconductor Devices, or TOSHIBA Semiconductor Reliability Handbook etc.. @ The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (Unintended Usage). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer's own risk. @ The products described in this document are subject to the foreign exchange and foreign trade laws. @ The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. @ The information contained herein is subject to change without notice. 7 2001-05-17