OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com
Issue A.4 8/09
Page 2 of 4
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Photologic® Reflective Object Sensor
OPB715Z, OPB716Z, OPB717Z, OPB718Z
Electrical Characteristics
(TA = 25°C unless otherwi se note d, see OPL560 series for additional electrical informatio n)
SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS
VCC Operating Supply Voltage 4.75 - 5.25 V -
ICCL Low-Level Supply Current: - - 30 mA VCC = 5.0 V, output open
ICCH High-Level Suppl y Current - - 50 mA VCC = 5.0 V, output open
IOH High Level Output Current
OPB716
OPB718
-
- -
- 100
100 µA
µA VOH = 30 V, EE = 1 mW/cm2
VOH = 30 V, EE = 0
IOS Short Circuit Output Current
OPB715
OPB717
-
-
-
-
100
100
µA
µA VCC = 5.0 V, VCH = 5 V
VOH High Level Output Voltage
OPB715, OPB717
OPB716, OPB718
VCC -
2.1
VCC -
2.1
-
-
-
-
V
V
IOH = -1 µA, EE = 1 mW/cm2
IOH = -1 µA, EE = 0
VOL Low Level Output Voltage
OPB715, OPB717
OPB716, OPB718
-
-
-
-
.4
.4
V
V
IOL = 16 mA, EE = 0
IOL = 16 mA, EE = 1 mW/cm2
EeT(+)/EeT(-) Hysteresis Ratio 11.20 1.55 2 - -
Notes:
(1) Derate linearly at 5.0 mW / °C above 25° C.
(2) Terminating wire is 7 strand, 26 AWG, UL 1429.
(3) Tested at d = 0.55” (12.7 mm) from a 90% diffuse, white test surface. Reference: Eastman Kodak Catalog #E 152 7795.
(4) No reflective surface.
Absolute Maximum Ratings (TA=25°C unless otherwise noted)
Storage & Operating Temperature Range -40° C to +85° C
Supply Voltage, VCC (not to exceed 2 seconds) 10 V
Power Dissipation(1) 300 mW
Output Voltage (Open-Collector only) 35 V