75 South Street, Hopkinton, MA 01748 • 800-982-5737 • 508-497-6377 • FAX 508-435-5289 • www.valpeyfisher.com • RevA_1007
2
M2000 series
H2000 series
VCXO 5.0V
Full/Half size
Thru-hole
HCMOS/TTL
Parameter Specification
Shock 1000 Gs, 0.35 ms, 1/2 sine wave, 3 shocks in each plane
Vibration 10-2000 Hz of .06" d.a. or 20 Gs, whichever is less
Humidity Resistant to 85° R.H. at 85°C
Gross Leak Each unit checked in 125°C fluorocarbon
Fine Leak Mass spectrometer leak rate less than 2 X 10-
atm, cc/sec of helium
Pins Kovar, nickel plated with 60/40 solder coat
Bend Test Will withstand two bends of 90° from reference
Header Steel, with nickel plate
Case Stainless steel, type 304
Marking Printing is black epoxy ink or laser marked
Resistance to Solvents MIL STD 202, Method 215
DESCRIPTIONS
M2001,H2001
±175 ppm, min. deviation
when using 0.3 to 10V control-voltage
M2002,H2002
±75 ppm, min. deviation
when using 0.3 to 4.0V control-voltage
M2003, H2003
±175 ppm to ±300 ppm deviation when using
0.3 to 10V control-voltage
M2004,H2004
±125 ppm min. deviation
when using 0.3 to 4.0V control-voltage
M2005,H2005
±75 ppm to ±300 ppm deviation when using
1.0 to 4.0V control-voltage, for use where the
control voltage is 1 volt off both rails
M2006,H2006
±150 ppm, min. deviation when using
0 to 5.0V rail-to-rail control-voltage
M2007,H2007
±125 ppm to ±250 ppm deviation when using
0.5 to 4.5V control-voltage
M2021,H2021
±75 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±50 ppm
stability
M2022,H2022
±100 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±50 ppm
stability
M2023,H2023
±150 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±50 ppm
stability
M2031,H2031
±75 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±25 ppm
stability
M2032,H2032
±100 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±25 ppm
stability
M2033,H2033
±150 ppm capture when using using 0.5 to 4.5V
control-voltage and 2.5V center with ±25 ppm
stability
Environmental and Mechanical Conditions
Center Frequency is Between Two Voltages
Center Frequency is at 2.5V with ±50 ppm stability
Center Frequency is at 2.5V with ±25 ppm stability