HRF-SW1030
2 www.honeywell.com/microwave
DC ELECTRICAL SPECIFICATIO NS @ + 25°C
Parameter Minimum Typical Maximum Units
VDD 3.31 5.0 5.5 V
VSS -5.0 V
IDD <5 35 uA
CMOS Logic Level (0) 0 0.8 V
CMOS Logic Level (1) VDD – 0.8 VDD V
Input Leakage Current 10 uA
Note 1 - Performance curves are for VDD = +5.0 +/- 10%
ABSOLUTE MAXIMUM RATINGS1
Parameter Absolute Maximum Units
VDD +6.0 V
VSS -5.5 V
Vin Digital Logic 0 -0.6 V
Vin Digital Logic 1 VDD + 0.6 V
Input Power > 35 dBm
ESD Voltage2 400 V
Moisture Sensitivity Level Level 3 @ 260OC
Operating Temperature Range -40 to +85 °C
Storage Temperature Range -65 to +125 °C
Note 1 - Operation of this device beyond any of these parameters may cau se p ermanent damage.
Note 2 - Although the HRF-SW1030 contains ESD protection circuitry on all digital inputs, precautions should be taken to
ensure that the Absolute Maximum Ratings are not exceeded.
Latch-Up: Unlike conventional CMOS digital switches, Honeywell’s HRF-SW1030 is immune to latch-up.
TRUTH TABLE
C2 C1 C0 RF Output
1 RF Output
2 RF Output
3 RF Output
4 RF Output
5 RF Output
6
0
0
0
1
1
1
0
1
1
0
0
1
1
0
1
0
1
0
RFINPUT
RFINPUT
RFINPUT
RFINPUT
RFINPUT
RFINPUT
"0" = CMOS Low, "1” = CMOS High
Note: For codes 000 and 111 all outputs are in the terminated isolation state.
PIN CONFIGURATIONS
Pin Function Pin Function Pin Function
1 GROUND 7 VDD 13 GROUND 19 GROUND
2 GROUND 8 C2 14 GROUND 20 GROUND
3 RFOUTPUT5 9 C1 15 RFOUTPUT2 21 RFINPUT
4 GROUND 10 C0 16 GROUND 22 GROUND
5 GROUND 11 VSS 17 GROUND 23 GROUND
6 RFOUTPUT4 12 RFOUTPUT3 18 RFOUTPUT1 24 RFOUTPUT6
Note: Bottom ground plate must be grounded for prop er RF performance.