KBPC800G THRU KBPC810G SINGLE PHASE 8.0 AMPS. GLASS PASSIVATED BRIDGE RECTIFIERS VOLTAGE RANGE 50 to 1000 Volts CURRENT 8.0 Amperes KBPC 8/10 ! FEATURES | 800(7.6) i] 250(6.35) * Surge overload rating 200 amperes peak Lt | x Low forward voltage drop 2 . . . . -750 * Small size, simple installation in * Leads solderable per MIL-STD-202, method 208 +050 TYP (7.3) DA ~| ~ 5213.2) _.770(19.56) 4882.2) 1730(1 8.54) 6) | +0 6 6 770(19.56) -730(18.54) Dimensions in inches and. (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating. at 25C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% TYPE NUMBER SYMBOLS | ee eee ee ae ere | oe | grog (UNITS Maximum Recurrent Peak Reverse Voltage Verm 50 100 | 200 800 | 1000) V Maximum RMS Bridge Input Voltage Vrms 35 70 140 | 280 | 42 560 700 Vv Maximum D.C Blocking Voltage Voc 50 100 |. 200 | 400 | 6&0 | 800 | 1000 Vv Maximum Average Forward Rectified Current @ Tc = 50C lFAV) 8.0 A Peak Forward Surge Current, 8.3 ms single half sine-wave Isa 175 A superimposed on rated load( JEDEC method) Maximum Forward Voltage Drop per element @ 4,.0A Ve 1.10 Vv Maximum Reverse Current at Rated @ T, = 25C \ 10 | pA D.C. Blocking Voltage per element @ T, = 125C R 500 pA Operating Temperature Range Ty - 55 to + 150 c Storage Temperature Range Tstc - 55 to+ 150 c NOTE: (1)Bolt down on heat - sink with silicone thermal compound between bridge and mounting surface for maximum heat transfer with # 6 screw . (2) Unit mounted on 6.0x 6.0 0. 11"thick(15 x 15x 0.3cm) Cu. Plate JINAN GUDE ELECTRONIC DEVICE Co., LTD.JGD eH RATINGS AND CHARACTERISTIC CURVES (KBPC800G THRU KBPC810G) FIG. 1 - MAXIMUM NON - REPETITIVE FORWARD SURGE CURRENT ~ PER ELEMENT 250 PEAK FORWARD SURGE CURRENT AMPERES , ~N ne haba 2 4 6810 20 40 60 80100 NUMBER OF CYCLES AT 60 Hz FiG -3- TYPICAL FORWARD CHARACTERISTICS - PER ELEMENT oe Qo a INSTANTANEOUS FORWARD CURRENT (A) = Qo as a 2 = a 8 10 12 14 16 18 20 FORWARD VOLTAGE (V) FIG.2- TYPICAL FORWARD CURRENT DERATING CURVE & HEAT-SINK MOUNTING o 6.0 x 6.0% 0.11" THK. (15* 15 *0.3em) Cu.PLATE AVERAGE FORWARD OUTPUT CURRENT(AMPERES) N 0 50 100 150 Te,CASE TEMPERATURE () FIG.4- TYPICAL REVERSE CHARACTERISTICS - PER ELEMENT ae INSTANTANEOUS REVERSE CURRENT CURRENT (MICROAMPERES) Q. 20 40 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE (%) JINAN GUDE ELECTRONIC DEVICE CO., LTD.