Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
Radial Lead
NPCAPTM-PSGSeries
・Super low ESR, high ripple current capability
・Endurance: 15,000 to 20,000 hours at 105℃
・Rated voltage : 16 to 35Vdc
・RoHS2 Compliant
・Halogen Free
◆SPECIFICATIONS
Items Characteristics
Category
Temperature Range -55 to +105℃
Rated Voltage
16 to 35Vdc
Capacitance Tolerance
±20% (M) (at 20℃, 120Hz)
Leakage Current
*Note
I=0.2CV or 500μA, whichever is greater
Where, I : Leakage current (μA), C : Nominal capacitance (μF), V : Rated voltage (V) (at 20℃ after 2 minutes)
Dissipation Factor
(tanδ)0.12 max. (at 20℃, 120Hz)
Low Temperature
Characteristics
(Max.Impedance Ratio)
Z(-25℃)/Z(+20℃)≦1.15
Z(-55℃)/Z(+20℃)≦1.25 (at 100kHz)
Endurance The following specifications shall be satisfied when the capacitors are restored to 20℃ after the rated voltage is applied for 20,000 hours
(20 to 35V : 15,000 hours) at 105℃.
Appearance No significant damage
Capacitance change ≦±20% of the initial value
D.F. (tanδ)≦150% of the initial specified value
ESR ≦150% of the initial specified value
Leakage current ≦The initial specified value
Bias Humidity Test The following specifications shall be satisfied when the capacitors are restored to 20℃ after subjecting them to DC voltage at 60℃,
90 to 95% RH for 1,000 hours.
Appearance No significant damage
Capacitance change ≦±20% of the initial value
D.F. (tanδ)≦The initial specified value
ESR ≦150% of the initial specified value
Leakage current ≦The initial specified value
Surge Voltage Test The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105℃ for 30 seconds
through a protective resistor(R=1kΩ) and discharge for 5 minutes 30 seconds.
Rated voltage (Vdc) 16 20 25 35
Surge voltage (Vdc) 18 23 29 40
Appearance No significant damage
Capacitance change ≦±20% of the initial value
D.F. (tanδ)≦The initial specified value
ESR ≦150% of the initial specified value
Leakage current ≦The initial specified value
Failure Rate 0.5% per 1,000 hours maximum (Confidence level 60% at 105℃)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105℃.
◆DIMENSIONS [mm]
Size code
φ
D
φd
F
φD'
L'
0.45
6.3
2.5
8.0
0.6
3.5
HB5H08F08F05 H16 H20 JB5 J16 J20
10.0
5.0
L+1.5max.L+1.0max. (Note1)
φD+0.5max.
Coated Case
L'
15min. 4min.
φ
D'
φd
F±0.5 F±0.5
Coated Case
L'
15min. 4min.
φ
D'
φd
F05,F08,H08
HB5,H16,H20,JB5,J16,J20
●
Terminal Code : E
Note1 : L+1.2 max. for 16V270μF (Rated ripple current 5,080mArms).
Downsized
PSG
PSF
◆MARKING
G
6D6
150
16V
EX) 16V150µF
CAT. No. E1001U
CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
Radial Lead
NPCAPTM-PSGSeries
◆PART NUMBERING SYSTEM
Supplement code (Note2)
Size code
Capacitance tolerance code
Capacitance code (ex. 150µF:151,1,000µF:102)
Lead forming·Taping code
Terminal code
Voltage code (ex. 16V:160,20V:200)
Series code
Category
A P S G E M
1 3 42 6 7 8 9 10 13125 18171611 1514
Please refer to “Product code guide (conductive polymer type)”
◆STANDARD RATINGS
WV
(Vdc)
Cap
(µF)
Case size
φD×L (mm)
ESR
(mΩ max./20℃, 100k to 300kHz)
Rated ripple current
(mArms/105℃, 100kHz) Part No.
16
150 6.3×5 20 3,200 APSG160E□□151MF05S
270 6.3×8 10 5,080 APSG160E□□271MF08J
270 6.3×8 15 3,800 APSG160E□□271MF08S
470 8×8 8 5,400 APSG160E□□471MH08J
470 8×8 16 4,000 APSG160E□□471MH08S
560 8×11.5 8 6,100 APSG160E□□561MHB5J
560 8×11.5 14 4,970 APSG160E□□561MHB5S
820 8×16 8 7,000 APSG160E□□821MH16S
820 10×11.5 12 5,400 APSG160E□□821MJB5S
1,000 8×20 8 7,500 APSG160E□□102MH20S
1,000 10×11.5 12 5,400 APSG160E□□102MJB5S
1,200 8×20 8 7,500 APSG160E□□122MH20S
1,500 10×16 8 7,700 APSG160E□□152MJ16S
1,800 10×20 8 8,100 APSG160E□□182MJ20S
2,200 10×20 8 8,100 APSG160E□□222MJ20S
20
120 6.3×5 20 3,200 APSG200E□□121MF05S
180 6.3×8 18 3,460 APSG200E□□181MF08S
330 8×8 17 3,880 APSG200E□□331MH08S
390 8×11.5 14 4,970 APSG200E□□391MHB5S
680 10×11.5 12 5,400 APSG200E□□681MJB5S
25
56 6.3×5 30 2,600 APSG250E□□560MF05S
82 6.3×8 28 2,780 APSG250E□□820MF08S
100 6.3×8 28 2,780 APSG250E□□101MF08S
120 6.3×8 28 2,780 APSG250E□□121MF08S
180 8×8 18 3,770 APSG250E□□181MH08S
180 8×11.5 16 4,650 APSG250E□□181MHB5S
220 8×8 18 3,770 APSG250E□□221MH08S
220 8×11.5 16 4,650 APSG250E□□221MHB5S
270 8×11.5 16 4,650 APSG250E□□271MHB5S
330 8×11.5 16 4,650 APSG250E□□331MHB5S
330 10×11.5 14 5,000 APSG250E□□331MJB5S
390 10×11.5 14 5,000 APSG250E□□391MJB5S
470 10×11.5 14 5,000 APSG250E□□471MJB5S
560 10×11.5 14 5,000 APSG250E□□561MJB5S
35 68 8×11.5 18 4,380 APSG350E□□680MHB5S
120 10×11.5 16 4,670 APSG350E□□121MJB5S
□□ : Enter the appropriate lead forming or taping code.
◆RATED RIPPLE CURRENT MULTIPLIERS
・Frequency Multipliers
Frequency
（Hz）120 1k 10k 50k 100k to 500k
Radial lead type 0.10 0.35 0.60 0.80 1.00
(Note2) : PSG series, 16V270μF (Rated ripple
current 5,080mArms) ,16V470μF (Rated ripple
current 5,400mArms) ,16V560μF (Rated ripple
current 6,100mArms)have supplement code “J”.
Terminal and terminal plating are the same as all
other in PSG series.
CAT. No. E1001U
CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
