
150W Constant Current Mode LED Driver HLG-120H-C series
File Name:HLG-120H-C-SPEC 2018-09-30
SPECIFICATION
MODEL
RATED CURRENT
CURRENT TOLERANCE
CURRENT RIPPLE
RATED POWER
CURRENT ADJ. RANGE
SET UP TIME Note.4
FREQUENCY RANGE
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS Note.6
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
OVER VOLTAGE
OVER TEMPERATURE
Adjustable for A/AB-Type only (via built-in potentiometer)
47 ~ 63Hz
<0.75mA / 277VAC
Compliance to ,GB17743 and GB17625.1, EAC TP TC 020EN55015, EN61000-3-2 Class C ( ) ; EN61000-3-3@ load 50%≧
Compliance to light , EAC TP TC 020EN61000-4-2,3,4,5,6,8,11, EN61547, industry level (surge immunity Line-Earth 4KV, Line-Line 2KV)
10 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH
℃
±℃ ℃
0.03%/ (0 ~ 50 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
652.2K hrs min. Telcordia SR-332 (Bellcore) ; 191.1K hrs min. MIL-HDBK-217F (25 )℃
Shut down o/p voltage with auto-recovery or re-power on to recovery
Shut down o/p voltage, recovers automatically after temperature goes down
ENVIRONMENT
SAFETY &
EMC
PROTECTION
SHORT CIRCUIT
±5%
8.0% max. @rated current
EMC IMMUNITY
EMC EMISSION Note.6
COLD START 50A(t =600 s measured at 50% I ) at 230VAC;width peak Per NEMA 410
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
CONSTANT CURRENT REGION
Note.2
PACKING
NOTE
μ
MAX. No. of PSUs on 16A
CIRCUIT BREAKER 4 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
VOLTAGE RANGE Note.3 90 ~ 305VAC 127 ~ 431VDC
(Please refer to "STATIC CHARACTERISTIC" section)
OUTPUT
POWER FACTOR (Typ.)
TOTAL HARMONIC DISTORTION
INPUT
WORKING TEMP. Tcase=-40 ~ +90 (Please refer to "OUTPUT LOAD vs TEMPERATURE" section)℃
MAX. CASE TEMP. Tcase=+90℃
1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25 of ambient temperature.℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
4. Length of set up time is measured at first cold start. Turning ON/OFF the may lead to increase of the set up time.driver
5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED can only be used behind a switch without permanentlydriver
connected to the mains.
7. This series meets the typical life expectancy of >62,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 80 or less.℃
8. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
9. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
10. For any application note and IP water proof function installation caution, please refer our user manual before using.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
PF 0.9 / VAC, PF 0.96/2 VAC full load≧≧≧8 115 30 , PF 0.93/277VAC @
(Please refer to " " )POWER FACTOR (PF) CHARACTERISTIC section
THD< 20% (@ load 50% /115VAC, 230VAC; @ load 75%/277VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION (THD)” section)
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃
HLG-120H-C350 HLG-120H-C500 HLG-120H-C700 HLG-120H-C1050 HLG-120H-C1400
350mA 500mA 700mA 1050mA 1400mA
150.5W 150W 150.5W 155.4W 151.2W
215 ~ 430V 150V ~ 300V 107V ~ 215V 74V ~ 148V 54V ~ 108V
175 ~ 350mA 250 ~ 500mA 350 ~ 700mA 525 ~ 1050mA 700 ~ 1400mA
1000ms / 115VAC 500ms / 230VAC
94% 94% 94% 94% 93.5%
1.6A / 115VAC 0.8 A / 230VAC 0.7A / 277VAC
Constant current limiting, recovers automatically after fault condition is removed
475 ~ 495V 335 ~ 355V 240 ~ 260V 165 ~ 175V 120 ~ 130V
UL8750, CSA C22.2 No. 250.13-12, EN/AS/NZS 61347-1, EN/AS/NZS 61347-2-13, EN62384 independent,GB19510.1,GB19510.14,
, J61347-1, J61347-2-13 approvedIP65 or IP67 , EAC TP TC 004
220*68*38.8mm (L*W*H)
1.04Kg; 12pcs/13.5Kg/0.8CUFT