｜ Soldering Conditions
｜ Dimensions｜ Land Dimensions｜ Circuit Diagram｜ Packing Specifications｜
｜
Type Surface mount
Operating force 3N
Operating direction Top push
Travel 1.05mm
Operating life
(1mA 5V DC)
300,000 cycles
Initial contact resistance 100mΩ max.
Series type Soft feeling type
Operating temperature range -40℃ to +90℃
Rating (max.) 50mA 16V DC
Rating (min.) 10μA 1V DC
Electrical
performance
Insulation resistance 100MΩ min. 100V DC for 1min.
Voltage proof 250V AC for 1min.
Durability Vibration 10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the
frequencies, in the 3 direction of X, Y and Z for 2 hours respectively
Environmental
performance
Cold -40℃ 1,000h
Dry heat 90℃ 1,000h
Damp heat 60℃, 90 to 95%RH 1,000h
Minimum order unit
(pcs.)
Japan 2,000
Export 2,000
Dimensions
Surface Mount Type TACT Switch(TM) > SKPS Series > SKPSACE010
6.0×5.9mm Low Contact Resistance Type (Surface Mount)
SKPS Series
Series Common Info
Part number
SKPSACE010
Land Dimensions
Viewed from mounting face.
Circuit Diagram
Packing Specifications
Taping
Number of packages
(pcs.)
1 reel 2,000
1 case / Japan 20,000
1 case / export
packing
20,000
Tape width (mm) 12
Export package measurements (mm) 395×395×205
Soldering Conditions
Condition for Reflow
1. Heating method
Double heating method with infrared heater.
2. Temperature measurement
Thermocouple 0.1 to 0.2 Φ CA(K) or CC(T) at solder joints (copper foil surface). A heat resisting tape should be
used for fix measurement.
3. Temperature profile
(1) The above temperature shall be measured of the top of switch. There are cases where PC board's temperature
greatly differs from that of the switch, depending on the material, size, thickness of PC board's and others. Care,
should be taken to prevent the switch's surface temperature from exceeding 260℃.
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is
highly recommended.
Manual Soldering
Items Condition
Soldering temperature 350℃ max.
Duration of soldering 3s max.
Capacity of soldering iron 15W max.
1. Do not washing the TACT Switch™.
2. Prevent flux penetration from the top side of the TACT switch™.
3. Switch terminals and a PC board should not be coated with flux prior to soldering.
4. The second soldering should be done after the switch returns to normal temperature.
Notes are common to this series/models.
1. This site catalog shows only outline specifications. When using the products, please obtain formal
specifications for supply.
2. Please place purchase orders for taping products per minimum order unit (1 reel or a case).
3. For φ330mm diameter reel requirements, please contact us.
4. This products can be used in vehicles.
Although these products are designed to perform over a wide operating temperature range, please ensure that
you receive and read the formal delivery specifications before use.
Inquiries about Products
Inquiry
Inquiries about Products
Inquiry
COPYRIGHT© 2019 ALPS ALPINE CO., LTD
COPYRIGHT© 2019 ALPS ALPINE CO., LTD Accept
About Cookies on this site：
This site uses cookies to improve your online experience. By continuing to use this site without changing your cookie preferences, we will assume that you are agreeing to our use of
cookies. For more information, visit our Terms of Use.
