FTR-K1 SERIES COMPACT POWER RELAY 1 POLE - 30A (For Automotive Applications) FBR51, 52 Series n FEATURES Compact and light weight structure l High current contact capacity (carrying current: 35 A/10 minutes, 30 A/1 hour) l High resistance to vibration and shock l Improved heat resistance and extended operation range l Two contact gap options (FBR51: 0.3 mm, FBR52: 0.6 mm) l Three types of contact material l n PARTNUMBER INFORMATION FBR51 N D12 - W1 ** [Example] (a) (b) (c) (d) (e) (a) Relay type FBR51 : FBR51 Series - Standard type (contact gap 0.3 mm) FBR52 : FBR52 Series - Wide contact gap type (contact gap 0.6 mm) (b) Enclosure N : Plastic sealed type (c) Coil rated voltage D12 : 6.....12 VDC Coil rating table at page 3 (d) Contact material W1 WL WF : Silver-tin oxide indium (high power type) : Silver-tin oxide indium (lamp loads, see applications table) : Silver-tin oxide indium (flasher loads) (e) Special type To be assigned custom specification 1 FTR-K1 SERIES FBR51, 52 SERIES n SPECIFICATION Item Contact Data Life Coil Data Timing Data Other W1 contact WL contact WF contact Configuration 1 form C (SPDT) 1 form A (SPST) 1 form A (SPST) Material Silver-tin oxide indium (high power type) Silver-tin oxide indium Voltage drop (resistance) Max. 100mV at 1A/12VDC Max. 100mV at 2A/12VDC Contact rating 14VDC, 25A 120 Watt lamp, (motor free load) at 14VDC Max. carrying current 35A / 10 minutes, 30A / 1hr (25 C, 100% rated coil voltage) Max. inrush current (reference) 60A Max. switching voltage (reference) 16VDC Max. switching current (reference) 35A Min. switching load (reference) * 6 VDC, 1A Mechanical Min. 10 x 106 operations Electrical Min. 2 x 105 operations 4VDC, 25A (Locked motor load) Rated power FBR51: 600mW, FBR52: 800mW Operate power FBR51: 220mW, FBR52: 300mW Operating temperature range -40 C to +85 C (no frost) Storage temperature range -40 C to +100 C (no frost) Operate (at nominal voltage) Max. 10 ms Release (at nominal voltage) Max. 5 ms Vibration resistance 10 to 55Hz double amplitude 1.5mm Shock Weight Misoperation 10m/s Endurance 1,000m/s 80 Watt lamp at 14VDC 80A 105 Min. 1 x operations 115 Watt lamp, 14VDC Min. 2.5 X 106 operations Inrush 11A, 14VDC (0.35 sec - ON/ 0.35 sec - OFF) Approximately 6 g * Minimum switching loads mentioned above are reference values. Please perform the confirmation test with actual load before production since reference values may vary according to switching frequencies, environmental contions and expected reliability levels. 2 FBR51, 52 SERIES FTR-K1 SERIES n COIL RATING FBR51 Series Coil Code Rated Coil Voltage (VDC) Coil Resistance +/- 10% (Ohm) Must Operate Voltage (VDC) * D06 6 60 3.6 (at 20 C) Thermal resistance (K / W) 4.5 (at 80 C) D09 9 135 D10 10 180 5.4 (at 20 C) 6.8 (at 80 C) 6.3 (at 20 C) 73 7.9 (at 80 C) D12 12 240 7.3 (at 20 C) 9.2 (at 80 C) FBR52 Series Coil Code Rated Coil Voltage (VDC) Coil Resistance +/- 10% (Ohm) Must Operate Voltage (VDC) * D06 6 45 3.6 (at 20 C) Thermal resistance (K / W) 4.5 (at 85 C) D09 9 100 D10 10 135 5.4 (at 20 C) 6.8 (at 85 C) 6.3 (at 20 C) 65 7.9 (at 85 C) D12 12 180 7.3 (at 20 C) 9.2 (at 85 C) Note: All values in the table are valid for 20C and zero contact current. * Specified operate values are valid for pulse wave voltage. 3 FBR51, 52 SERIES FTR-K1 SERIES n SUITABLE APPLICATIONS Recommended model (example) Normal load current (12 VDC system) Description For 16V or less motor load voltage For instantaneous 20V or more load voltage Power windows 20A to 25A (switching at motor locking forward and reverse motor control FBR51N ( ) -W1 FBR52N ( ) - W1 Automatic door lock 18A to 25A (switching at motor locking forward and reverse motor control FBR51N ( ) - W1 FBR52N ( ) - W1 Tilt-lock wheel 20A (switching at motor locking) forward and reverse motor control FBR51N ( ) -W1 FBR52N ( ) - W1 Sunroof 20A to 30A (switching at motor locking) forward and reverse motor control FBR51N ( ) - W1 FBR52N ( ) - W1 Adjustable door mirror 3A to 5A (switching at motor locking) forward and reverse motor control FBR51N ( ) - W1 8A to 12A (Inrush) break 2A forward and reverse maximum (motor-free) motor control FBR51N ( ) - W1 Application Automatic antenna Auto-cruise 2A to 3A power shutoff and solenoid FBR51N ( ) - W1 Lamp loads 120 Watts up to 100K operations FBR51N ( ) - WL Others: Car audio systems, etc. FBR51N ( ) - W1 * For the load condition where higher voltage would be encountered during contact break, FBR52 series with wider contact gap is recommended. n CHARACTERISTIC DATA 4 FBR51, 52 SERIES FTR-K1 SERIES 5 FBR51, 52 SERIES FTR-K1 SERIES 6 FTR-K1 SERIES FBR51, 52 SERIES n REFERENCE DATA 7 FTR-K1 SERIES FBR51, 52 SERIES n DIMENSIONS (pokayoke) 45pcs/tube Unit: mm 8 FTR-K1 SERIES FBR51, 52 SERIES RoHS Compliance and Lead Free Information 1. General Information All automotive relays produced by Fujitsu Components are compliant with RoHS directive 2002/95EC including amendments. l Cadmium as used in electrical contacts is exempted from the RoHS directives on October 21st, 2005. (Amendment to Directive 2002/95/EC) l All of our automotive relays are lead-free. l Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified. This material has been verified to be compatible with PbSn assembly process. l 2. Recommended Lead Free Solder Profile Recommended solder Sn-3.0Ag-0.5Cu. l Flow Solder condition: Pre-heating: Soldering: maximum 120C dip within 5 sec. at 260C solder bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity Moisture Sensitivity Level standard is not applicable to electromechanical relays, unless otherwise indicated. l 4. Tin Whiskers Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length whisker was found by our in house test. l 9 FTR-K1 SERIES FBR51, 52 SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: promothq@ft.ed.fujitsu.com Web: www.fcl.fujitsu.com Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: info@fceu.fujitsu.com Web: emea.fujitsu.com/components/ North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: components@us.fujitsu.com Web: http://us.fujitsu.com/components Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: fcal@fcal.fujitsu.com Web: http://www.fujitsu.com/sg/services/micro/components/ (c)2010 Fujitsu Components Europe B.V. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. The contents, data and information in this datasheet are provided by Fujitsu Component Ltd. as a service only to its user and only for general information purposes. The use of the contents, data and information provided in this datasheet is at the users' own risk. Fujitsu has assembled this datasheet with care and will endeavor to keep the contents, data and information correct, accurate, comprehensive, complete and up to date. Fujitsu Components Europe B.V. and affiliated companies do however not accept any responsibility or liability on their behalf, nor on behalf of its employees, for any loss or damage, direct, indirect or consequential, with respect to this datasheet, its contents, data, and information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Nor do Fujitsu Components Europe B.V. and affiliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or fitness for particular use, with respect to these datasheets, its contents, data, information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Rev. December 10, 2010 10