SOLID TANTALUM ELECTROLYTIC CAPACITORS F98 Face down Terminals Chip, Specifications Item Category Temperature Range Capacitance Tolerance Performance Characteristics -- 55 ~ +125C (Rated temperature : 85C) 20% (at 120Hz) 4.7F 6% Dissipation Factor(120Hz) 10F 8% 22F 15% After 5 minute's application of rated voltage, leakage current at Leakage Current 20C is not more than 0.1CV or 0.5A, whichever is greater. Type numbering system (Example : 6.3V 10 F) 1 2 3 4 5 6 7 8 9 10 F 9 8 0 J 1 0 6 M M Damp Heat At 40C, 90 ~ 95% R.H., For 500hours (No voltage applied) Capacitance Change Within 30% of initial value Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value Temperature Cycles At --55C / +125C, For 30 minutes each, 5 cycles Capacitance Change Within 30% of initial value Dissipation Factor 150% or less of initial specified value Leakage Current Initial specified value or less Resistance to Soldening Heat At 240C, For 10 seconds, Reflow, Capacitance Change Within 30% of initial value Leakage Current Initial specified value or less Leakage Current Initial specified value or less Surge After application of surge in series with a 1k resistor at the rate of 30 seconds ON, 30 seconds OFF, for 1000 successive test cycles at 85C, capacitors meet the characteristics requirements listed below. Capacitance Change Within 30% initial value Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value 11 Taping code (Refer to page 211 for details) Case code Capacitance tolerance Rated Capacitance Rated voltage Series Drawing L W1 Endurance H W2 Shear Test S1 S2 S1 (mm) Cace Code M W2 W1 L H S2 S1 1.6 0.1 0.85 0.1 0.65 0.1 0.8 0.1 0.5 0.1 0.6 0.1 Terminal Strength After applying the pressure load of 5N for 101 seconds horizontally to the center of capacitor side body which has no electrode and has been soldered beforehand on an aluminum substrate, there shall be found neither exfoliation nor its sign at the terminal electrode. 5N (0.51kg * f) For 10 1seconds Keeping a capacitor surface-mounted on a substrate upside down and supporting the substrate at both of the opposite bottom points 45mm apart from the center of the capacitor, the pressure strength is applied with a specified jig at the center of the 20 R230 substrate so that the substrate may bend by 1mm as illustrated. Then, there shall be found no 45 45 remarkable abnormality on the capacitor terminals. 1mm Marking After 1000 hours' application of rated voltage in series with a 3 resistor at 85C, capacitors meet the characteristic requirements listed below Capacitance Change Within 30% of initial value Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value J As for the surge and derated voltage at 125C, refer to page 210 for details. Rated voltage (Voltage code) Standard ratings Code 4 0G 475 106 226 M V Cap. (F) 4.7 10 22 6.3 0J 10 1A M M Wider range of rating. CAT.8100R