RNV Series Stackpole Electronics, Inc. High Voltage Anti-moisture Metal Film Resistor Features: * * * Resistive Product Solutions High voltage surge handling per IEC 60065.14.1, up to 7KV High tolerance to prolonged exposure to temperature and humidity stress Ideal for applications requiring high stability, reliability and voltage handling; including power inverters, AC adapters and switching power supplies Electrical Specifications Type / Code Power Rating (Watts) @ 70C Maximum Working Voltage Maximum Overload Voltage Resistance Temperature Coefficient Ohmic Range () and Tolerance 1% and 5% RNV14 0.25W 1600V (DC 1150V (RMS) 3200V (DC) 2300V (RMS) 200 ppm/C 100K - 15M Mechanical Specifications L 0.236 0.012 6.00 0.30 Type / Code RNV14 D 0.094 0.008 2.40 0.20 Power Derating Curve: Percent Rated Power (%) 100 d 0.022 0.002 0.55 0.05 H 1.102 0.012 28.00 0.30 -55C Unit inches mm 70C 80 60 40 20 155C 0 -60 -40 -20 0 20 40 60 80 100 Ambient Temperature (C) 120 140 160 180 How to Order 1 2 3 4 5 6 7 8 9 10 11 12 R N V 1 4 F T L 1 0 0 K Product Series High Voltage Metal Film RNV Size 14 Power 0.25W Tolerance Code Tol F 1% J 5% Code A T Packaging Description Tape Box (52mm) Tape and Reel Size 14 Quantity 2,000 5,000 TCR Code ppm L 200 Resistance Value Four characters with the multiplier used as the decimal holder. 100 Kohm = 100K 1 Mohm = 1M00 15 Mohm = 15M0 Rev Date: 06/19/2012 This specification may be changed at any time without prior notice Please confirm technical specifications before you order and/or use. 1 www.seielect.com marketing@seielect.com RNV Series Stackpole Electronics, Inc. High Voltage Anti-moisture Metal Film Resistor Resistive Product Solutions Performance Characteristics Item Performance Test Method Solvent Resistance No serious scratches on the insulating surface Resistor was dipped into solvent for 5 0.5 minutes Temperature Coefficient Resistance (TCR) Within 200ppm/C Measured resistance (R0 ohm) at room temperature (t C) then measured again at 100C higher than room temperature 6 ppm/C = (R-R0)/R0 X 10 /{(T + 100)-t} Overload (short time) Resistance variation within (1% + 0.05 ohm) Applied DC voltage 2.5 times the rated voltage for 5 seconds ON, 45 seconds OFF. Repeated cycle 10 times. Maximum Overload voltage is not more than 2 x Max Working Voltage Voltage Proof Resistance variation within (0.5% + 0.05 ohm) Resistor was clamped in the through of a 90C metallic V-block and was tested at provided AC potential voltage for 1 minute. Test voltage: max overload voltage. Test voltage: 500V (AC) Vibration Resistance variation within (0.5% + 0.05 ohm) Applied 1.5mm amplitude vibration to two directions, perpendicular to each other, for 6 hours each. Total 12 hours. Vibrating frequency is 10HZ - 2000HZ - 10HZ cycle in 20 minutes. Repeat cycle. Insulation Resistance 10 M ohm or more Resistor was clamped in the through of a 90C metallic V-block at DC 100V for 1 minute Robustness of Terminations Resistance variation within (0.5% + 0.05 ohm) and no mechanical damage Tensile test: The body of the part is fixed. The tensile force was applied gradually up to 10N. Twist test: Terminal lead was rotated 360 of the original axis of the bent terminal, alternating direction for 3 rotations. Resistance to Soldering Heat No mechanical and electrical deterioration Resistance to wave soldering condition: Temperature/Time-Profile in accordance to the CECC00802. Max Temperature/Time: 260C, 10 seconds Solderability 4 More than 95% of the lead surface was covered by Dipped the lead into a solder bath (temperature 245C 5C) up to 4 new solder after the leads were dipped in the solder 0.8mm from the resistor body and held for 5 0.5 seconds. Rapid Change of Temperature Resistance variation within (0.5% + 0.05 ohm) Test: -55C for 30 min., 25C for 30 sec., 155C for 30 min. 25C for 30 sec. Resistance changed after continuous 5 cycles. Damp Heat Resistance variation within (1.5% + 0.05 ohm) Temperature 40C 2C, relative humidity 90~95%, inside bath for 1.5 hour and shut voltage 0.5 hour. Repeated cycle for 1,000 hours. Room temperature for 1 hour after test, then measured Endurance at 70C Resistance variation within (1.5% + 0.05 ohm) In constant temperature chamber 70C 2C, applied rated DC voltage for 1.5 hour and shut voltage for 0.5 hour. Cycle repeated for 1,000 hours. Cold Resistance Resistance variation within (1.5% + 0.05 ohm) Resistor was put into a bath at fixed temp of -55C 3C for 2 hours. After measured, left at room temp for 1 hour, then measured again. Heat Resistance Resistance variation within (1.5% + 0.05 ohm) Resistor was put into a bath at fixed temp of 155C 3C for 16 hours. After measured, left at room temp for 1 hour, then measured again. In accordance with IEC60065.14.1, 50 discharges from a 1nF capacitor charged to Vmax; Figure 2. 12 discharges/minute 10 High Voltage Surge Test Resistance variation within (1% + 0.05 ohm) Vmax (kV) 9 8 7 6 5 4 0.01 0.1 1 Rx (M) 10 100 Operating Temperature Range: -55C to +155C Rev Date: 06/19/2012 This specification may be changed at any time without prior notice Please confirm technical specifications before you order and/or use. 2 www.seielect.com marketing@seielect.com