1PS7010F 11/16/09
3.3V Fast CMOS Clock Driv er
Description
Pericom Semiconductor ’s PI49FCT3807 is a 3.3V 1-to-10 clock
driver. This low skew clock driver features one input and ten outputs
fanout. The large fanout from a single input line reduced loading
on input clock. TTL level outputs reduce noise levels on the part.
Typical applications are clock and signal distributon
Pin Confi guration
Pin Description
Pin Name Description
A Input
B0-B9Outputs
GND Ground
VCC Power
Block Di a gram
PI49FCT3807
Features
• 3.3V version of PI49FCT807
• Ultra low skew: 0.35ns
• Low Input Capacitance
• Minimum duty cycle distortion
• 1:10 fanout
• High speed: 3.5ns propogation
• TTL input and CMOS output compatible
– VOH =3.3V (typical)
– VOL =0.3V (typical)
• Industrial Temperature: –40°C to +85°C
• 3.3V ±10% operation
• Packaging (Pb-free & Green Available):
– 20-pin 300-mil wide SOIC (S)
– 20-pin 150-mil wide QSOP (Q)
– 20-pin 209-mil wide SSOP (H)
VCC
B9
B8
GND
B7
VCC
B6
GND
B5
B4
A
GND
B0
VCC
B1
GND
B2
VCC
B3
GND
1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
B0
B1
B2
B3
B4
B5
B6
B7
B8
B9
A
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
2PS7010F 11/16/09
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Note:
Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the
device. This is a stress rating only and functional op er a tion
of the device at these or any other con di tions above those
indicated in the operational sec tions of this spec i fi ca tion is
not implied. Ex po sure to ab so lute maximum rating condi-
tions for extended pe ri ods may affect re li abil i ty.
DC Electrical Characteristics (TA = –40°C to +85°c VCC = 3.3V ±0.3V)
Symbol Parameter Test Condition(1) Min. Typ. Max. Units
VOH Output High Voltage VCC = Min., VIN = VIL or VIH IOH = -0.1mA
IOH = -8mA VCC - 0.2
2.4 –
3.0
V
VOL Output Low Voltage VCC = Min., VIN = VIL or VIH
IOH = 0.1mA
IOH = 16mA
IOH = 24mA
–
0.2
0.3
0.2
0.4
0.5
VIH Input High Voltage Guaranteed Logic HIGH Level (Input pins) 2.0 5.5
VIL Input Low Voltage Guaranteed Logic LOW Level (Input pins) -0.5 0.8
IIH Input High Current VCC = Max. VIN = VCC 1A
IIL Input Low Current VCC = Max. VIN = GND -1
VIK Clamp Diode Voltage VCC = Min., IIN = -18mA -0.7 -1.2 V
IOH Output HIGH Current(4,5) VOUT = 1.5V, VIN =VIL or VIH, VCC = 3.3V -35 -60 -110
mAIOL Output LOW Current(4,5) VOUT = 1.5V, VIN =VIL or VIH, VCC = 3.3V 50 90 200
IOS Short Circuit Current(4,5) V
CC = Max., VOUT = GND -60 -135 -240
VHInput Hysteresis 150 mV
Storage Temperature ............................................................–65°C to +150°C
Ambient Temperature with Power Applied ...........................–40°C to +85°C
Supply Voltage to Ground Potential (Inputs & VCC Only) .....–0.5V to +7.0V
Supply Voltage to Ground Potential (Outputs & D/O Only) ..–0.5V to +7.0V
DC Input Voltage ....................................................................–0.5V to +7.0V
DC Output Current ...............................................................................120mA
Power Dissipation ...................................................................................0.5W
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, +25°C ambient and maximum loading.
3. VOH = VCC – 0.6V at rated current.
4. This parameter is determined by device characterization but is not production tested.
5. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
3PS7010F 11/16/09
Power Supply Characteristics
Parameters De scrip tion Test Conditions(1) Min. Typ(2) Max. Units
ICC Quiescent Power
Supply Current VCC = Max. VIN = GND
or VCC —3 30A
ǻICC Supply Current per
Inputs @ TTL HIGH VCC = Max. VIN = VCC
0.6V(3) — 2.0 300
ICCD Supply Current per
Input per MHz(4)
VCC = Max.,
Outputs Open
Per Output Toggling
50% Duty Cycle
VIN = VCC
VIN = GND —mA/
MHz
Notes:
1. For Max. or Min. conditions, use appropriate value specifi ed under Electrical Characteristics for the applicable device.
2. Typical values are at VCC = 3.3V, +25°C ambient.
3. Per TTL driven input (VIN = VCC – 0.6V); all other inputs at VCC or GND.
4. This parameter is not directly testable, but is derived for use in Total Power Supply Calculations.
5. Values for these conditions are examples of the IC formula. These limits are guaranteed but not tested.
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(1) De scrip tion Test Conditions Typ Max. Units
CIN Input Capacitance VIN = 0V 4.5 6.0 pF
COUT Output Capacitance VOUT = 0V 5.5 8.0
Notes:
1. This parameter is determined by device characterization but is not production tested.
Maximum Switching Characteristics (Over operating range)
Symbol Description Test
Conditions 3807 3087A 3087B 3807C Units
Com. Com. Com. Com.
Min. Max. Min. Max. Min. Max. Min. Max.
tPLH
tPHL Propagation Delay A to BN
CL = 15pF
RL = 500
1.5 4.5 1.5 4.0 1.5 3.8 1.5 3.5
ns
tSK(O) Skew between two outputs
of same package(3) 0.5 0.5 0.5 0.5
tSK(P)
Skew between opposite tran-
sitions of the same output
(tPHL - tPHL)(3) 0.5 0.5 0.35 0.35
FIN
Skew between outputs of
different packages at the
same power supply, temp.
and speed grade(3)
1.0 1.0 0.75 0.75
Notes:
1. Other loading condition is described on page 4, “Test Circuits for All Outputs.”
2. These parameters are guaranteed by design.
3. Minimum propagation delay of 1.5ns is guaranteed by design.
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
4PS7010F 11/16/09
Phase Jitter Measurement Data
Frequency Band Input Output Additive Jitter Unit
12kHz-10MHz 342 483 341 fsRMS
12kHz-20MHz 493 642 411 fsRMS
Tests Circuits for All Outputs
Pulse
Generator
f = 125MHz D.U.T.
50ΩC
L
15pF
V
CC
Switch Position
Test Switch
Disable LOW
Enable LOW 6V
Disable HIGH
Enable HIGH GND
All Other Inputs Open
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
5PS7010F 11/16/09
Switching Waveforms
Propagation Delay
Package Skew – tSK(t)
Pulse Skew – tSK(p)
Output Skew – tSK(o)
Input
tPLH
3V
1.5V
0V
Output VOH
1.5V
VOL
tPHL
2.0V
0.5V
tRtF
Input
tPLHx
3V
1.5V
0V
Ox VOH
1.5V
VOL
tPHLx
tSK(o)
Oy VOH
1.5V
VOL
tSK(o)
tPLHy tPHLy
tSK(o) = | tPLHy – tPLHx | or | tPHLy – tPHLx |
Input
tPLH
3V
1.5V
0V
Output VOH
1.5V
VOL
tPHL
tSK(p) = | tPHL – tPLH |
Input
tPLH1
3V
1.5V
0V
Package 1
Output
VOH
1.5V
VOL
tPHL1
tSK(t)
Package 2
Output
VOH
1.5V
VOL
tSK(t)
tPLH2 tPHL2
tSK(t) = | tPLH2 – tPLH1 | or | tPHL2 – tPHL1 |
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
6PS7010F 11/16/09
1
: 20-Pin, 209-Mil Wide, SSOPNOITPIRCSED
:EDOC EGAKCAP
1240-DP :# LORTNOC TNEMUCOD E:NOISIVER
80/01/40 :ETAD
H20
08-0140
1
.337
.344
.053
.069
.004
.010
SEATING
PLANE
.025
BSC
.007
.010
.228
.244
.150
.157
1
20
X.XX
X.XX DENOTES DIMENSIONS
IN MILLIMETERS
0.635
8.56
8.74
1.35
1.75
5.79
6.19
0.101
0.254
.008
.012
0.203
0.305
3.81
3.99
0.178
0.254
.058
1.47
.015 x 45˚
0.38
REF
Detail A
Detail A
.008
0.20
MIN.
Guage Plane
.010
0.254
.041
1.04
REF
.016
.035
0.41
0.89
0˚-6˚
.008
.013
0.20
0.33
DESCRIPTION: 20-Pin, 150-Mil Wide, QSOP
PACKAGE CODE: Q
DOCUMENT CONTROL NO.
PD - 1202
REVISION: H
DATE: 10/22/07
Note:
1) Controlling dimensions in inches.
2) Ref: JEDEC MO-137B/AD
3) Dimensions do not include mold flash, protrusions or gate burrs
Pericom Semiconductor Corporation
3545 N. 1st Street, San Jose, CA 95134
1-800-435-2335 • www.pericom.com
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
7PS7010F 11/16/09
3%!4).'
0,!.%
"3#
888
888
$%./4%3#/.42/,,).'
$)-%.3)/.3).-),,)-%4%23
X
2%&
$%3#2)04)/.0IN-IL7IDE3/)#
0!#+!'%#/$%3
$/#5-%.4#/.42/,./
0$
2%6)3)/.$
$!4%
.OTES
#ONTROLLINGDIMENSIONSINMILLIMETERS
2EF*%$%#-3$!#
Pericom Semiconductor Corporation
3545 N. 1st Street, San Jose, CA 95134
1-800-435-2335 • www.pericom.com
Note:
• For latest package info, please check: http://www.pericom.com/products/packaging/mechanicals.php
09-0005
PI49FCT3807
3.3V Fast CMOS Clock Driver
8PS7010F 11/16/09
Ordering Information
Ordering Code Package Code Speed Grade Package Description
PI49FCT3807AHEX H A Pb-free & Green, 20-pin 209-mil SSOP
PI49FCT3807AQEX Q A Pb-free & Green, 20-pin 150-mil QSOP
PI49FCT3807ASEX S A Pb-free & Green, 20-pin 300-mil SOIC
PI49FCT3807BHEX H B Pb-free & Green, 20-pin 209-mil SSOP
PI49FCT3807BQEX Q B Pb-free & Green, 20-pin 150-mil QSOP
PI49FCT3807BSEX S B Pb-free & Green, 20-pin 300-mil SOIC
PI49FCT3807CHEX H C Pb-free & Green, 20-pin 209-mil SSOP
PI49FCT3807CQEX Q C Pb-free & Green, 20-pin 150-mil QSOP
PI49FCT3807CSEX S C Pb-free & Green, 20-pin 300-mil SOIC
PI49FCT3807DHEX H D Pb-free & Green, 20-pin 209-mil SSOP
PI49FCT3807DQEX Q D Pb-free & Green, 20-pin 150-mil QSOP
PI49FCT3807DSEX S D Pb-free & Green, 20-pin 300-mil SOIC
PI49FCT3807HEX H Blank Pb-free & Green, 20-pin 209-mil SSOP
PI49FCT3807QEX Q Blank Pb-free & Green, 20-pin 150-mil QSOP
PI49FCT3807SEX S Blank Pb-free & Green, 20-pin 300-mil SOIC
Notes:
• Thermal characteristics can be found on the company web site at www.pericom.com/packaging/
• E = Pb-free and Green
• Adding an X suffi x = Tape/Reel
Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com
09-0005
