1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel DC/DC (5V) AC/DC (5V) AC/AC TTL (5V) AC/AC PECL (5V) OPT-1062A1 Series OPT-1062A1G1 A/B/C/D OPT-1062A1G3 A/B/C/D OPT-1062A3G2 A/B/C/D OPT-1062A1G2 A/B/C/D Feature Compliant with Fibre Channel Standard SC Duplex Multimode Transceiver Industrial Standard 1x9 Footprint, Cost Effective Design 850 nm Vertical Cavity Surface Emitting Laser (VCSEL) Source Technology Data Link up to 550 Meters in 50/125 MMF, 300 Meters in 62.5/125 MMF. Single + 5V Power Supply. Available for PECL and TTL Logic Interface. Class 1 FDA and IEC laser safety compliant (Laser Class 1 Product) Absolute Maximum Ratings Parameter Storage Temperature Symbol Min. Ts -40 Typ. Max. Unit 85 o C o C Lead Soldering Temperature TSOLD 260 Lead Soldering Time tSOLD 10 sec. Supply Voltage Vcc 0 6 V Symbol Min. Max. Unit TA 0 Reference Recommended Operating Conditions Parameter Ambient Operating Temperature Supply Voltage Typ. 70 o C Vcc 4.75 5.25 V Transmitter Data Input Voltage - Low VIL - VCC -1.810 -1.475 V Transmitter Data Input Voltage - High VIH - VCC -1.165 -0.880 V Transmitter Differential Input Voltage VD 0.3 1.6 V Data Output Load RDL 50 DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 43 Reference 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series Transmitter Electro - Optical Performance Specifications: Parameter Symbol Supply current Icc Launched power (avg.) P0 Min. Typ. Max. Unit 180 mA -4 dBm -10 Optical extinction ratio 9 Center wavelength c 830 Reference dB 850 Spectral width 860 nm 0.85 nm rms Optical risetime tr 0.45 ns Note (1) Optical falltime tf 0.45 ns Note (1) RIN -116 DB/Hz Max. Unit Relative Intensity Noise Note (1). These are 20-80% values and include the effect of a fourth order filter. Receiver Electro - Optical Performance Specifications: Parameter Symbol Supply current Min. Typ. Icc Reference 130 mA Data output voltage - Low VOL - Vcc -1.950 -1.620 Vcc Data output voltage - High VOH - Vcc -1.045 -0.740 VCC -17 dBm Note (1) dBm Note (1) Optical input sensitivity (avg.) PIN Optical input saturation (avg.) PSAT -3 Optical wavelength 850 nm Output Data risetime tr 0.4 ns Note (2) Output Data falltime tf 0.4 ns Note (2) Signal detect - Assert PA -18 dBm Signal detect - Deassert PD -30 PA -PD 1 Signal detect - Hysteresis -12 dBm dB 23 Note (1). With BER better than orequal to 1x10 , measured in the center of the eye opening with 2 -1 NRZ PRBS. Note (2). These are 20%~80% values. DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 44 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series Recommended Circuit Schematic (For OPT-1062A1G1) Multimode 850nm Gigabit Ethernet / Fiber Channel 1x9 Transceiver, DC/DC, 5V Transceiver Version VCC SerDes 5V / 3.3V 8 R2 TxD VCC R1 9 TX+ C4 R4 R3 C5 VCCSerDes 5V / 3V 6 VCCRx 5 SD 4 RD- RxD 3 RD+ RxD C1 Signal detect SD to upper level R13 RDC6 C7 PLL etc. R12 1 RD+ R11 RxGND Receiver 2 R7 LIMITING Amplifier Gigabit Transceiver Chip L1 R8 PreAmp Serializer/ Deserializer L2 C3 C2 ECL/PECL DRIVER TX- R10 VCCTx Delta Transceiver R6 7 R5 TxD Driver R9 Laser TXGND C1/2/3 = 4.7 uF C4/5/6/7 = 10 nF L1/2 = 1 uH R1/2 = 68 R3/4 = 191 R7/8 = 270 R5/6/9/10/11/12 Depend on SerDes chip used and desired line termination (50 R13 = 510 When we want PECL output in SD pin we use R13=510. Strip line) Value of R5/6/9/10/11/12 may very as long as proper 50 termination to VEE ,it depend on SerDes chip used and desired line termination.All the transceiver of Delta contains an automatic shutdown circuit.Reset depends on the power OFF and then ON. For good EMI performance the power supply filter is require.Use short tracks from the inductor L1/2 to the module VccTx/VccRx . This recommend Circuit assume Gigabit Ethernet / Fiber Channel using 5V power supply and SerDes Chip using 3.3 / 5 V power supply. DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 45 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series Recommended Circuit Schematic (For OPT-1062A1G3) Multimode 850nm Gigabit Ethernet / Fiber Channel 1x9 Transceiver, AC/DC, 5V Transceiver Version VCC SerDes 5V / 3.3V 7 VCCTx 6 VCCRx 5 SD 4 RxD 3 Delta Transceiver RD- L2 Serializer/ Deserializer C2 L1 Gigabit Transceiver Chip SD to upper level R13 RDC6 RxGND Receiver 2 1 RD+ C7 PLL etc. R12 RxD R11 RD+ ECL/PECL DRIVER C3 R7 LIMITING Amplifier VCCSerDes 5V / 3V C1 Signal detect PreAmp TXR6 TxD TX+ R10 8 R5 Driver TxD VCC R9 100R 9 R8 Laser TXGND C1/2/3 = 4.7 uF C4/5/6/7 = 10 nF L1/2 = 1 uH R7/8 = 270 R5/6/9/10/11/12 Depend on SerDes chip used and desired line termination (50 R13 = 510 When we want PECL output in SD pin we use R13=510. Strip line) Value of R5/6/9/10/11/12 may very as long as proper 50 termination to VEE ,it depend on SerDes chip used and desired line termination.All the transceiver of Delta contains an automatic shutdown circuit.Reset depends on the power OFF and then ON. For good EMI performance the power supply filter is require.Use short tracks from the inductor L1/2 to the module VccTx/VccRx. This recommend Circuit assume Gigabit Ethernet / Fiber Channel using 5V power supply and SerDes Chip using 3.3 / 5 V power supply. DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 46 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series Recommended Circuit Schematic (For OPT-1062A1G2 or OPT-1062A3G2) Multimode 850nm Gigabit Ethernet / Fiber Channel 1x9 Transceiver, AC/AC, 5V Transceiver Version VCC SerDes 5V / 3.3V TXGND 9 TxD 8 TxD 7 VCC TX+ Laser VCCSerDes 5V / 3V 6 Delta Transceiver C1 Signal detect LIMITING 5 SD 4 RxD 3 RxD 2 RxGND 1 L2 Serializer/ Deserializer C3 C2 L1 SD to upper level Gigabit Transceiver Chip R13 RD- Amplifier Receiver PLL etc. R12 RD+ R11 PreAmp VCCRx R10 VCCTx ECL/PECL DRIVER R6 TXR5 Driver R9 100R C1/2/3 = 4.7 uF L1/2 = 1 uH R7/8 = 270 R5/6/9/10/11/12 Depend on SerDes chip used and desired line termination (50 Strip line) When we want PECL output in SD pin we use R13=510, and no connector R13 = 510 when we want TTL output. Value of R5/6/9/10/11/12 may very as long as proper 50 termination to VEE ,it depend on SerDes chip used and desired line termination.All the transceiver of Delta contains an automatic shutdown circuit.Reset depends on the power OFF and then ON. For good EMI performance the power supply filter is require.Use short tracks from the inductor L1/2 to the module VccTx/VccRx. This recommend Circuit assume Gigabit Ethernet / Fiber Channel using 5V power supply and SerDes Chip using 3.3 / 5 V power supply. DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 47 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series TYPE: A (Flush Shielding) MECHANICAL DIMENSIONS Unit: mm 39.50 0.20 1.0 25.40 0.20 29.70 0.20 25.80 0.20 10.25 0.20 22 0.20 9.50 0.20 20.32 15.83 2.54 20.32 20.32 DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 48 12.70 0.10 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series TYPE: B (Protruding Shielding) MECHANICAL DIMENSIONS Unit: mm 20.32 2.54 20.32 3.80 0.10 15.83 0.20 20.32 1.30 0.50 max. 9.50 0.20 2.02 39.50 25.40 0.20 12.70 0.10 29.60 DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 49 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series TYPE: C (Entirely Wrap-Up) MECHANICAL DIMENSIONS Unit: mm 20.32 20.32 15.83 0.20 2.54 20.32 1.30 3.80 0.10 9.50 0.20 10.20 0.20 2 12.70 0.10 29.60 DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 50 1x9 SC Duplex VCSEL 850nm Optical Transceiver Module for 1.0625 GBd Fibre Channel OPT-1062A1 Series TYPE: D (Clamp Shielding) MECHANICAL DIMENSIONS Unit: mm 20.32 20.32 15.83 0.20 2.54 1.30 3.80 0.10 0.50 max. 9.50 0.20 12.70 0.10 25.40 0.20 27.47 DELTA ELECTRONICS, INC. (CHUNGLI PLANT CPBU) 3, TUNG YUAN ROAD, CHUNGLI INDUSTRIAL ZONE, TAOYUAN SHIEN, TAIWAN, R.O.C. TEL: 886-3-4526107 FAX: 886-3-4527314 www.deltaca.com 51