Memory Module Specifications KVR21R15D8/8 8GB 2Rx8 1G x 72-Bit PC4-2133 CL15 Registered w/Parity 288-Pin DIMM DESCRIPTION ValueRAM's KVR21R15D8/8 is a 1G x 72-bit (8GB) DDR4-2133 CL15 SDRAM (Synchronous DRAM) registered w/ parity, 2Rx8, ECC, memory module, based on eighteen 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2133 timing of 15-15-15 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: SPECIFICATIONS CL(IDD) 15 cycles Row Cycle Time (tRCmin) 47.05ns(min.) Refresh to Active/Refresh Command Time 1x mode (tRFCmin) 260ns(min.) Row Active Time (tRASmin) 33.00ns(min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C FEATURES *Power will vary depending on the SDRAM used. * Power Supply: VDD=1.2V (1.14V to 1.26V) * VDDQ = 1.2V (1.14V to 1.26V) * VPP - 2.5V (2.375V to 2.75V) * VDDSPD=2.25V to 2.75V * Functionality and operations comply with the DDR4 SDRAM datasheet * 16 internal banks * Bank Grouping is applied, and CAS to CAS latency (tCCD_L, tCCD_S) for the banks in the same or different bank group accesses are available * Data transfer rates: PC4-2133, PC4-1866, PC4-1600 * Bi-Directional Differential Data Strobe * 8 bit pre-fetch * Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop) * Supports ECC error correction and detection * On-Die Termination (ODT) * Temperature sensor with integrated SPD * This product is in compliance with the RoHS directive. * Per DRAM Addressability is supported * Internal Vref DQ level generation is available * Write CRC is supported at all speed grades * CA parity (Command/Address Parity) mode is supported Continued >> kingston.com Document No. VALUERAM1470-001.A00 04/27/15 Page 1 MODULE DIMENSIONS Front Back kingston.com Document No. VALUERAM1470-001.A00 Page 2