EB01-FS150R12KE3G
IGBT-Driver.com Page 1
Data Sheet EB01-FS150R12KE3G
Basic Board for Infineon E conoPAC K+
Module s F S150R12 K E 3G
Abstract
The EB01-FS150R12KE3G is a basic board to be used with six-channel driver 6SD312EI
for reliab l e driving and safe operation of Infineon IGBT m odules FS150R12KE3G .
The basic board EB01-FS150R12KE3G (with driver 6SD312EI) is fully matched to IGBT
module FS150R12KE3G. Its plug-and-play capability makes it ready to operate
immediately after mounting. The user needs invest no effort in designing or adjusting it
to a specific application.
Product Highlights Applications
Plug-and-play solution Three-phase inverters
Suitable for FS150R12KE3G Motor drives
No electro lytic capacit ors UPS
Extremely reliable; long service life Power-factor correctors
Shortens application development time Wind-power converters
Welding
SMPS
and many others
EB01-FS150R12KE3G
Basic Boa r d Da ta Sheet
Page 2 CT-Concept.com
Important: Pl ea se ref er t o t he relevant manua l s!
This data sheet contains only product-specific data for the basic board.
Information specific to the relevant driver can be found in the
corresponding data sheet.
A detailed description, must-read application notes and general data
applicable to this driver family are found in: “Description and Application
Manual, Six-Channel Driver 6SD312EI for the EconoPACK+ Modules ”.
Dimensions
Dimensio ns: 162 x 100 mm.
Height including driver : 21 mm (30 mm with connector X1 and flat cable).
Mounting principle: soldered onto an EconoPACK+ IGBT module FS150R12KE3G.
Absolute Maximum Ratings
Parameter Remarks Min Max Units
Input power per channel Note 1 3 W
Switching fr equency Note 2 69 kHz
DC link voltage Note 3 800 V
Operating temperature -40 +85 °C
Storage temperature -40 +90 °C
All data refer to +25°C unless otherwise specif i ed
EB01-FS150R12KE3G
Basic Board Data Sheet
IGBT-Driver.com Page 3
Electrical Characteristics
Short-circuit protection Remarks Min Typ. Max Units
Vce-monito r i ng threshold Betw. aux. terminals 3.4 V
Respon se time Note 4 10 µs
Gate ou tp ut Remarks Min Typ. Max Units
Turn-on gate resistor Rg(on) 8.2 Ω
Turn-off gate resi stor Rg(off) 10 Ω
Electrical insulation Test conditions Min Typ. Max Units
Creep path between channels 9 mm
All data refer to +25°C unless otherw ise specified
Footnotes to the key data
1) The input power is limited by the on-board gate resistors.
2) If the specified max. switching frequency is exceeded, the gate resistors may overheat.
3) This limit is due to active clamping. Refer to the “Description and Appli cation Manual, Six-Channel
Driver 6SD312EI for the EconoPACK+ Modules”.
4) Pulse width of the direct output of the gate drive unit (excluding the gate-resistor delay).
EB01-FS150R12KE3G
Basic Boa r d Da ta Sheet
Page 4 CT-Concept.com
Important Notice
The data contained in this product data sheet is intended exclusively for technically
trained staff. Handling all high-voltage equipment involves risk to life. Strict compliance
with the respec tive safety regulations is mandatory!
Any handling of electronic devices is subject to the general specifications for protecting
electrostatic-sensitive devices according to international standard IEC 747-1, Chapter IX
or European standard EN 100015 (i.e. the workplace, tools, etc. must comply with
these standards). Otherwise, this product may be damaged.
Disclaimer
This data sheet specifies devices but cannot promise to deliver any specific
characteristics. No warranty or guarantee is given – either expressly or implicitly –
regarding delivery, performance o r suitability.
CT-Concept Technology AG reserves the right to make modifications to its technical
data and product specifications at any time without prior notice. The general terms and
conditi ons of delivery of C T-Concept Technology AG apply.
EB01-FS150R12KE3G
Basic Board Data Sheet
IGBT-Driver.com Page 5
Ordering In f orma t i o n
The general terms and conditions of delivery of CT-Concept Technologie AG apply.
Related IGBT CONCEPT Driver Type #
Infineon (eupec) FS150R12KE3G 6SD312EI
Connection CONCEPT Modular Cable Type #
6SD312EI to EB01-FS150R12KE3G MIC 01A (6 it ems per d river)
Related IGBT CONCEPT Basic Board Type #
Infineon (eupec) FS150R12KE3G EB01-FS150R12KE3G
Information about Other Products
For drivers adapte d to other high-voltag e or high-power IGBT modules
Direct link: www.IGBT-Driver.com/go/plug-and-play
For other drivers and evaluation systems
Please click: www.IGBT-Driver.com
© Manufacturer
CT-Concept Technologie AG
Intelligent Power Electronics
Renferst ra sse 15
CH-2504 Biel-Bienne
Switzerland
Tel. +41 - 32 - 344 47 47
Fax +41 - 32 - 344 47 40
E-mail Info@IGBT-Driver.com
Internet www.IGBT-Driver.com
Copyright 1998…2007 by CT-Con cept Technologie AG - Switzerland. All rights reserved.
We reserve the right to make any technical modifications without prior notice. Version of 2016-05-20
