www.RFM.com E-mail: info@rfm.com Page 1 of 5
©2009-2010 by RF Monolithics, Inc. SF2186E - 4/21/10
Electrical Characteristics
Electrical Connections
Characteristic Sym Notes Min Typ Max Units
Center Frequency fC1268.52 MHz
Insertion Loss, 1258.29 to 1278.75 MHz IL 1.7 3.2 dB
Amplitude Ripple, 1258.29 to 1278.75 MHz 0.5 1.8
2 dB Bandwidth 20.46 38.3 MHz
Attenuation, Referenced from Minimum IL:
1227.52 MHz 39 45.5 dB
1309.52 MHz 50 67
Input/Output VSWR, 1258.29 to 1278.75 MHz 1.3 2.1
Source Impedance ZS50 Ω
Load Impedance ZL50
Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 874, YWWS
Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel
Reel Size 13 Inch 3000 Pieces/Reel
Connection Terminals
Inp u t 2
Output 5
Case Ground All others
SM3030-6
• Surface Mount 3.0 x 3.0 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating Value Units
Input Power Level 10 dBm
DC V oltage on any Non-ground Terminal 3 V
Operating Temperature Range -40 to +85 °C
Storage Temperature Range in Tape and Reel -40 to +85 °C
Suitable for Lead-free Soldering - Maximum Soldering Profile 260°C for 30 s
1268.52 MHz
SAW Filter
SF2186E
1. Unless note d otherwis e , all spe cifica tions apply over the operati ng t emperat ure ra nge with f ilter s oldered t o t he specif ied demonstra tio n boa rd with imped ance
match ing to 50 Ω and measured with 50 Ω network analyz er.
2. Unless noted otherwise, all freque ncy specifications are ref erenced to the nominal center frequency, fc.
3. Rejection i s measur ed as a ttenu at ion bel ow t he minimum I L point in th e p assb and. Reje ctio n i n fi nal u ser a pplica tio n i s dep end ent on P CB l ay out a nd ex ternal
impedance matching des ign. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part numb er indicates "l ow rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The desi gn, manufact uring process , and specifications of this filter ar e subject to change.
6. Eith er Port 1 or P ort 2 ma y be us ed for eit he r inp ut or outp ut i n t he des ign. However, impedances and imp edan ce mat chi ng may vary bet ween Por t 1 and P ort
2, so that t he filter must always be installed in one direction per t he circuit des ign.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
Pb
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
5 . & $ -
50 ohm 50 ohm
2 5
1 , 3 , 4 , 6