FS1AE
THRU
FS1ME
1 Amp Fast Recovery
Silicon Rectifier
50 to 1000 Volts
Features
• Easy Pick And Place
• High Temp Soldering: 260°C for 10 Seconds At Terminals
• Superfast Recovery Times For High Efficiency
MCC
Catalog
Number
Device
Marking
Maximum
Recurrent
Peak Reverse
Voltage
Maximum
RMS
Voltage
Maximum
DC
Blocking
Voltage
FS1AEFS1A 50V 35V 50V
FS1BEFS1B 100V 70V 100V
FS1DEFS1D 200V 140V 200V
FS1GEFS1G 400V 280V 400V
FS1JEFS1J 600V 420V 600V
FS1KEFS1K 800V 560V 800V
FS1MEFS1M 1000V 700V 1000V
Electrical Characteristics @ 25°C Unless Otherwise Specified
Average Forward
current
IF(AV) 1.0A Ta= 90°C
Peak Forward Surge
Current
IFSM 30A 8.3ms, half sine
Maximum
Instantaneous
Forward Voltage
VF1.30V
IFM = 1.0A;
TJ = 25°C*
Maximum DC
Reverse Current At
Rated DC Blocking
Voltage
IR5µA
200µA
TJ = 25°C
TJ = 125°C
Maximum Reverse
Recovery Time
FS1AE-GE
FS1JE
FS1KE-ME
Trr 150ns
250ns
500ns
IF=0.5A, IR=1.0A,
Irr=0.25A
Typical Junction
Capacitance
CJ15pFMeasured at
1.0MHz, VR=4.0V
*Pulse test: Pulse width 200 µsec, Duty cycle 2%
omponents
20736 Marilla Street Chatsworth
!"#
$% !"#
MCC TM
Micro Commercial Components
www.mccsemi.com
1 of 4
(SMAE)
0.070”
0.090”
0.085”
SUGGESTED SOLDER
PAD LAY
OU
T
H
J
E
G
A
B
D
C
Cathode Band
DIMENSIONS
INCHES MM
DIM MIN MAX MIN MAX NOTE
A .079 .096 2.01 2.44
B .050 .075 1.27 1.90
C .002 .008 .05 .20
D --- .02 --- .51
E .030 .060 .76 1.52
G .189 .208 4.80 5.30
H .157 .180 4.00 4.57
J .090 .115 2.29 2.92
Maximum Ratings
• Operating Temperature: -50°C to +150°C
• Storage Temperature: -50°C to +150°C
• Maximum Thermal Resistance; 15 °C/W Junction To Lead
• Maximum Thermal Resistance; 88°C/W Junction To Ambient
Revision: C 2013/10/18
Note: 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.
• Moisture Sensitivity Level 1
• Halogen free available upon request by adding suffix "-HF"
• Epoxy meets UL 94 V-0 flammability rating
• Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates
Compliant. See ordering information)
FS1AE thru FS1ME
Average Forward Rectified Current - Amperes versus
Ambient Temperature - °C
Figure 2
Forward Derating Curve
015025 50 75 100
0
.2
.4
.6
.8
1.0
1.2
1.4
Single Phase, Half Wave
60Hz Resistive or Inductive Load
Amps
°C
125
1.6
1.8
2.0
2.2
2.4
Figure 3
Junction Capacitance
.1 .2 1.4 2 10 20 404 100 200
1
2
6
10
20
100
Junction Capacitance - pF versus
Reverse Voltage - Volts
pF
Volts
60
40
4
400 1000
TJ=25°C
Instantaneous Forward Current - Amperes versus
Instantaneous Forward Voltage - Volts
Figure 1
Typical Forward Characteristics
4
6
20
10
Amps
.6 .8 10 1.2 1.4 1.6
.01
.02
.04
.06
.1
.2
.4
.6
1
2
25°C
Volts
MCC TM
Micro Commercial Components
www.mccsemi.com
2 of 4
Revision: C 2013/10/18
FS1AE thru FS1ME
Figure 5
New SMA Assembly
Round Lead
Process
1 100
4
0
6
12
18
8
Figure 4
Peak Forward Surge Current
Peak Forward Surge Current - Amperes versus
Number Of Cycles At 60Hz - Cycles
Amps
Cycles
2610 20 60 80
40
24
30
36
trr
+0.5A
0
-0.25
-1.0
1cm
Set Time Base for 20/100ns/cm
25Vdc
1Ω
50Ω10Ω
Oscilloscope
Note 1
Pulse
Generator
Note 2
Notes:
1. Rise Time = 7ns max.
Input impedance = 1 megohm, 22pF
2. Rise Time = 10ns max.
Source impedance = 50 ohms
3. Resistors are non-inductive
Figure 6
Reverse Recovery Time Characteristic And Test Circuit Diagram
MCC TM
Micro Commercial Components
www.mccsemi.com
3 of 4
Figure 7
Typical Reverse Characteristics
Volts
4
6
20
10
µAmps
20 120
40 60 80 100
.01
.02
.04
.06
.1
.2
.4
.6
1
2
TA=25°C
40
60
100
140
TA=125°C
Instantaneous Reverse Leakage Current - MicroAmperes versus
Percent Of Rated Peak Reverse Voltage - Volts
Revision: C 2013/10/18
MCC
TM
Micro Commercial Components
www.mccsemi.com
4 of 4
Revision: C 2013/10/18
Device Packing
Part Number-TP Tape&Reel: 6Kpcs/Reel
Ordering Information :
***IMPORTANT NOTICE***
Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to
make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components
Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it
convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all
risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are
represented on our website, harmless against all damages.
***LIFE SUPPORT***
MCC's products are not authorized for use as critical components in life support devices or systems without the express written
approval of Micro Commercial Components Corporation.
***CUSTOMER AWARENESS***
Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking
strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages
customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on
our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine
parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty
coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global
problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized
distributors.
Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF
