Thermofit Molded Parts Part Number: 101A083X-GO1 Specification Control Drawing Description : | Cap, Round End Limited Distribution NOTES inches SEE NOTE 4 1. All dimensions are in [millimeters] 2. Dimensions appearing in table are as follows: a As Supplied H DIA b - After Unrestricted Recovery 3. Coating is optional. As supplied dimensions appearing in table are for uncoated parts. When coating W is added, entry diameters will be reduced by .06 max. AS SUPPLIED AFTER UNRESTRICTED RECOVERY 4. Recovered parts may have angularity of 30 - 45. TABLE OF DIMENSIONS PART H P w NUMBER Min Max Min 20% a b b b 2.00 -90 3.50 Ak 101A083X-G01 [50,8] [22,9] [69,0] [2.8] RTE oR OR TONE Revision: A Part Number : 101A083XG01 MENTO PARK, CALIFORNIA 94028 Date: 2/25/98 Description : Cap, Round End Thermofit Molded Parts Part Number: 101A083X-GO1 Specification Control Drawing Description : Cap, Round End Limited Distribution COMPATABILITY CHART MATERIAL DASH NO} MATERIAL DESCRIPTION RT SPEC COATING SLASH NO, COATING S NO, COATING DESCRIPTION -3 Polyolefin, Semirigid RT-301 /42; /86 S-1017;S1048 Adhesive *VITON is a Registered Trademark of Dupont [| ORDERING INFORMATION | 101A083 -3 GO1 /XX ee Base part number Material dash number (See Compatability Chart) Modification number (lf necessary, see front of scd binder or a complete list) Adhesive slash number {If necessary, see Compatability Chart) THIS DRAWING IS SUBJECT TO CHANGE WITHOUT NOTICE; CONSULT YOUR NEAREST FIELD REPRESENTATIVE FOR CURRENT REVISION Se oe TORT DRIVE Revision: A Part Number : 101A083XG01 MENLO PARK, CALIFORNIA 94028 Date: 2/25/98 Description : Cap, Round End CAD FILE MP98027