ADAFRUIT FLORA WEARABLES Get started with the fabulous Adafruit Flora platform with this lovely starter kit. Included are plenty of parts to make a few different fun projects! There's a Flora motherboard, a GPS module that can also perform location datalogging, eight ultra-bright chainable RGB pixels, a battery holder and batteries, two types of our high quality stainless steel thread, alligator clips to help you test out your parts, a USB cable for reprogramming the Flora, and some parts to make a wearable remote control Kit Contents FLORA main board Flora Wearable Ultimate GPS module Eight Flora RGB NeoPixels V2 3xAAA Battery holder with JST connector and on/off switch Stainless Thin Conductive Thread - 2 ply 25 meter/85 ft Stainless Medium Conductive Thread - 3 ply - 18 meter/60 ft Needle set with 20 pieces Small Alligator Clip Test Lead (set of 12) USB cable - A/MiniB - 3ft 4x Alkaline AAA batteries 2x NPN Bipolar Transistors (PN2222) 2x Super-bright 5mm IR LEDs 2x 100-ohm resistors FLORA GPS Starter Pack Tactile On/Off Switch with Leads Magnetic Pin Back Flora Lux Sensor - TSL2561 Light Sensor Flora Accelerometer/Compass Sensor - LSM303 JST-PH Battery Extension Cable - 500mm Flora Color Sensor - TCS34725 Woven Conductive Fabric - Silver 20cm square