ADAFRUIT FLORA WEARABLES
Get started with the fabulous Adafruit Flora platform
with this lovely starter kit. Included are plenty of
parts to make a few different fun projects! There's a
Flora motherboard, a GPS module that can also
perform location datalogging, eight ultra-bright
chainable RGB pixels, a battery holder and
batteries, two types of our high quality stainless
steel thread, alligator clips to help you test out your
parts, a USB cable for reprogramming the Flora, and
some parts to make a wearable remote control
Kit Contents
FLORA main board
Flora Wearable Ultimate GPS module
Eight Flora RGB NeoPixels V2
3xAAA Battery holder with JST connector
and on/off switch
Stainless Thin Conductive Thread - 2 ply -
25 meter/85 ft
Stainless Medium Conductive Thread - 3 ply
- 18 meter/60 ft
Needle set with 20 pieces
Small Alligator Clip Test Lead (set of 12)
USB cable - A/MiniB - 3ft
4x Alkaline AAA batteries
2x NPN Bipolar Transistors (PN2222)
2x Super-bright 5mm IR LEDs
2x 100-ohm resistors
FLORA GPS Starter Pack
Tactile On/Off Switch with Leads
Magnetic Pin Back
Flora Lux Sensor - TSL2561 Light Sensor
Flora Accelerometer/Compass Sensor - LSM303
JST-PH Battery Extension Cable - 500mm
Flora Color Sensor - TCS34725
Woven Conductive Fabric - Silver 20cm square