MCC TM Micro Commercial Components SM2EZ5.6D5 THRU SM2EZ75D5 omponents 20736 Marilla Street Chatsworth !"# $ % !"# Features * Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates Compliant. See ordering information) * * * * Glass Passivated Junction Excellent Clamping Capability Built-in Strain Relief Low Inductance 2 W Glass Passivated Junction Silicon Zener Diode 5.6-75 Volts Mechanical Data DO-214AC (SMA) (LEAD FRAME) * Case Material: Molded Plastic. UL Flammability Classification Rating 94V-0 and MSL rating 1 TERMINALS : Solder plated, solderable per MIL-STD-750, method 2026 POLARITY : Color band denotes positive end (cathode) H J Maximum Ratings @ 25oC Unless Otherwise Specified Peak Pulse Power Dissipation (Note 2) o Derate above 75 C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) (Note 3) Operating And Storage Temperature Range PD 2 24 Watts mW/ oC A E C D B F IFSM 15 G Amps DIMENSIONS TJ , TSTG DIM A B C D E F G H J o -55 C to +150o C NOTES: 1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7. 2. Mounted on 5.0mm2(.013mm thick) land areas. INCHES MIN .079 .050 .002 --.030 .065 .189 .157 .090 MM MIN 2.00 1.27 .05 --.76 1.65 4.80 4.00 2.25 MAX .096 .064 .008 .02 .060 .091 .220 .181 .115 MAX 2.44 1.63 .20 .51 1.52 2.32 5.59 4.60 2.92 NOTE SUGGESTED SOLDER PAD LAYOUT 0.085 " MA X 3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. 0.058 " MI N 0.05 MI N Revision: 3 www.mccsemi.com 1 of 5 2008/01/30 MCC SM2EZ5.6D5 THU SM2EZ75D5 TM Micro Commercial Components 0 ELECTRICAL CHARACTERISTICS (T A=25 C unless otherwise noted) VF=1.2 V max , IF=500 mA for all types Type No. Nominal Zener (Note 1.) Voltage Vz @ IZT volts (Note 2.) SM2EZ5.6D5 5.6 6.2 6.8 7.5 8.2 9.1 10 11 12 13 14 15 16 17 18 19 20 22 24 27 30 33 36 39 43 47 51 56 62 68 75 SM2EZ6.2D5 SM2EZ6.8D5 SM2EZ7.5D5 SM2EZ8.2D5 SM2EZ9.1D5 SM2EZ10D5 SM2EZ11D5 SM2EZ12D5 SM2EZ13D5 SM2EZ14D5 SM2EZ15D5 SM2EZ16D5 SM2EZ17D5 SM2EZ18D5 SM2EZ19D5 SM2EZ20D5 SM2EZ22D5 SM2EZ24D5 SM2EZ27D5 SM2EZ30D5 SM2EZ33D5 SM2EZ36D5 SM2EZ39D5 SM2EZ43D5 SM2EZ47D5 SM2EZ51D5 SM2EZ56D5 SM2EZ62D5 SM2EZ68D5 SM2EZ75D5 Notes: Test Maximum Surge Current Maximum Zener Impedance (Note 3) Leakage Current Zener Current o current @ TA = 25 C DEVICE IZT ZZT @ IZT ZZk @ IZK IZK IR VR IZM Izsm - A MARKING mA Ohms 89.5 80.5 73.5 66.5 61 55 50 45.5 41.5 38.5 35.7 33.4 31.2 29.4 27.8 26.3 25 22.8 20.8 18.5 16.6 15.1 13.9 12.8 11.6 10.6 9.8 9 8.1 7.4 6.7 uA Max Volts mA (Note 4.) 5 2 324 292 266 242 220 200 182 166 152 138 130 122 114 107 100 95 90 82 76 68 60 55 50 47 43 39 36 32 29 27 24 3.3 3.1 2.9 2.66 2.44 2.2 2 1.82 1.66 1.54 1.43 1.33 1.25 1.18 1.11 1.05 1 0.91 0.83 0.74 0.67 0.61 0.56 0.51 0.45 0.42 0.39 0.36 0.32 0.29 0.27 Ohms mA 2.5 500 1 1.5 700 1 5 3 2 700 1 5 4 2 700 0.5 5 5 2.3 700 0.5 5 6 2.5 700 0.5 3 7 3.5 700 0.25 3 7.6 4 4.5 5 5.5 7 8 9 10 11 11 12 13 18 20 23 25 30 35 40 48 55 60 75 90 700 700 700 700 700 700 750 750 750 750 750 750 750 1000 1000 1000 1000 1500 1500 1500 2000 2000 2000 2000 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 0.25 1 1 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 0.5 8.4 9.1 9.9 10.6 11.4 12.2 13 13.7 14.4 15.2 16.7 18.2 20.6 22.5 25.1 27.4 29.7 32.7 35.8 38.8 42.6 47.1 51.7 56 2E5.6 2E6.2 2E6.8 2E7.5 2E8.2 2E9.1 2E10 2E11 2E12 2E13 2E14 2E15 2E16 2E17 2E18 2E19 2E20 2E22 2E24 2E27 2E30 2E33 2E36 2E39 2E43 2E47 2E51 2E56 2E62 2E68 2E75 1. TOLERANCES - Suffix indicates 5% tolerance any other tolerance will be considered as a special device. 2. ZENER VOLTAGE (Vz) MEASUREMENT - guarantees the zener voltage when measured at 40 ms from the diode body, and an ambient temperature of 25 3.ZENER IMPEDANCE (Zz) DERIVATION - The zener impedance is derived from the 60 cycle ac voltage, which results when an ac current having an rms falue equal to 10% of the dc zener current (I ZT or IZK) is superimposed on IZT or IZK . NON-REPETITIVE - The rating listed in the electrical characteristics table 4. SURGE CURRENT (Izsm) is maximum peak, non-repetitive, reverse surge current of 1/2 square wave or equivalent sine wave pulse of 1/120 second duration superimposed on the test current, IZT, per JEDEC standards, however, actual device capability is as described in Figure 3. Revision: 3 www.mccsemi.com 2 of 5 2008/01/30 MCC RATING AND CHARACTERISTICS CURVES TM SM2EZ5.6 D5 THRU SM2EZ75D5 Micro Commercial Components JL (t,D) TRANSIENT THERMAL RESISTANCE JUNCTION-TO-LEAD(/W) 30 D = 0.5 20 10 0.2 7 5 0.1 3 2 0.05 1 0.02 0.7 0.5 0.01 0.3 0.0001 NOTE BELOW 0.1 SECOND, THERMAL RESPONSE CURVE IS APPLICABLE TO ANY LEAD LENGTH (L) D=0 0.0002 0.0005 0.001 0.002 0.005 0.01 0.02 0.05 SINGLE PULSE TJL = JL(t)PPK REPETITIVE PULSES TJL = JL(t,D)PPK 0.1 0.2 0.5 1 2 5 10 Fig. 2-TYPICAL THERMAL RESPONSE PPK, PEAK SURGE POWER(WATTS) 500 150 IR, REVERSE LEADAGE(uAdc) @VR AS SPECIFIED IN ELEC. CHAR. TABLE 250 RECTANGULAR NONREPETITIVE WAVEFORM TJ = 25 PRIOR TO INITIAL PULSE 100 50 30 20 10 .1 .2 .3 5 1 2 3 5 10 20 50 100 0.005 0.003 0.002 0.001 0.0005 0.0003 0.0002 0.0001 1 2 5 10 20 50 100 200 500 1K P.W. PULSE WIDTH (ms) NOMINAL VZ (VOLTS) Fig. 3-MAXIMUM SURGE POWER Fig. 4-TYPICAL REVERSE LEAKAGE 8 200 6 VZ, TEMPERATURE C OEFFICIENT(mV) @ IZT VZ, TEMPERATURE COEFFICIENT(mV/) @ IZT 0.1 0.05 0.03 0.02 0.01 4 2 0 RANGE -2 -4 3 4 6 8 10 12 VZ, ZENER VOLTAGE @IZT (VOLTS) 100 RANGE 50 40 30 20 10 0 20 40 60 80 100 120 140 160 180 200 VZ, ZENER VOLTAGE @IZT (VOLTS) Fig. 5-UNITS 3.9 TO 12 VOLTS Revision: 3 Fig. 6-UNITS 10 TO 200 VOLTS www.mccsemi.com 3 of 5 2008/01/30 MCC RATING AND CHARACTERISTICS CURVES SM2EZ5.6 D5 THRU SM2EZ75D5 Micro Commercial Components 100 IZ, ZENER CURRENT (mA) IZ, ZENER CURRENT (mA) 100 50 30 20 10 5 3 2 1 0.5 0.3 0.2 0.1 0 1 2 3 4 5 6 7 8 50 30 20 10 5 3 2 1 0.5 0.3 0.2 0.1 0 9 10 10 50 30 20 10 5 3 2 1 0.5 0.3 0.2 0.1 100 120 140 160 180 70 80 90 100 Fig. 8-VZ = 12 THRU 82 VOLTS JL, JUNCTION-LEAD THERMAL RESISTANCE (/W) Fig. 7-VZ = 3.9 THRU 10 VOLTS 100 20 30 40 50 60 VZ, ZENER VOLTAGE (VOLTS) VZ, ZENER VOLTAGE (VOLTS) IZ, ZENER CURRENT (mA) TM 80 70 60 PRIMARY PATH OF CONDUCTION IS THROUGH THE CATHODE LEAD 50 40 30 20 10 0 0 200 1/8 1/4 3/8 1/2 5/8 3/4 7/8 1 VZ, ZENER VOLTAGE (VOLTS) L, LEAD LENGTH TO HEAT SINK (INCH) Fig. 9-VZ = 100 THRU 200 VOLTS Fig. 10-TYPICAL THERMAL RESISTANCE Revision: 3 www.mccsemi.com 4 of 5 2008/01/30 MCC TM Micro Commercial Components Ordering Information Device Packing (Part Number)-TP Tape&Reel; 7.5Kpcs/Reel ***IMPORTANT NOTICE*** Micro Commercial Components Corp . reserves the right to make changes without further notice to any product herein to make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are represented on our website, harmless against all damages. ***APPLICATIONS DISCLAIMER*** Products offer by Micro Commercial Components Corp . are not intended for use in Medical, Aerospace or Military Applications. www.mccsemi.com Revision: 3 5 of 5 2008/01/30