Sharp
Feeling
Soft
Feeling
Snap-in
Type
Surface
Mount Type
Radial
Type
414
Power
Push
Slide
Rotary
Encoders
Jog
Shuttle
Telephone
-hook
Detector
Vibration
Sensors
Dual-in-line
Package Type
Multi Control
Devices
TACT
1. Heating method: Double heating method with infrared heater.
2. Temperature measurement: Thermocouple 0.1 to 0.2φCA(K)or CC(T)at soldering portion(copper foil surface). A heat resisting tape
should be used for fixed measurement.
3. Temperature profile
TACT Switches
Soldering Conditions
Condition for Reflow
Available for Surface Mount Type.(Except SKHM Series)
200
100
240˚C max.
180˚C
Time
2±0.3min.( pre-heating)
3 to 4min.
Timeinsidesolderingequipment
Temperature (˚C )
20s max.
Conditions for Auto-dip
Available for Snap-in Type and Radial Type
Manual Soldering
Available for Manual Soldering Type
Flux built-up
Mounting surface should not be coated with flax
Ambient temperature of the soldered
surface of PC board.
100℃max.
45s max.
255℃max.
5s max.
Preheating temperature
Preheating time
Soldering temperature
Continuous dipping time
Items Condition Condition
2times max.
Number of soldering
Soldering temperature 350℃max.
3s max.
Continuous soldering time
Items
1. The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where
the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size,
thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
(Except a part of Variety SKRM, SKRR Series)
2. Soldering conditions differ depending on reflow soldering machines. You are requested to verify the soldering
conditions thoroughly beforehand.
3. Ask us for the specifications of lead-free products.
Notes
1. Consult with us for TACT switch washing conditions.
2. Prevent flux penetration from the top side of the TACT switch.
3. Switch terminals and a PC board should not be coated with flux prior to soldering.
4. The second soldering should be done after the switch returns to normal temperature.
5. Use the flux with a specific gravity of at least 0.83.
(MH-820V or CF220V by TAMURA Corporation, or their equivalents.)
Notes