2
+SENSE (8)
TRIM (7)
- SENSE (6)
TR IM UP
TR IM D OWN
+SENSE (8)
TRIM (7)
- SENSE (6)
10K ohms
TRIMPOT
SPECIFICATIONS
All Specifications Typical At Nominal Line, Full Load, and 25℃ Unless Otherwise Noted
INPUT SPECIFICATIONS: GENRAL SPECIFICATIONS:
Input Voltage Range ....…………….................... 12V ................. 9-18V Efficiency ........................…………................................................ See Table
24V ............... 18-36V Isolation Voltage ..................... Input/Output ……..….........… 1500VDC min.
48V ............... 36-75V Input/Case …..………….……. 1500VDC min.
Input Surge Voltage (100ms max.) …………. 12V …...... 25Vdc max. Output/Case ……...………….. 1500VDC min.
24V ........….50Vdc max. Isolation Capacitance ………………..………………………….… 1000pF Typ.
48V .......... 100Vdc max. Isolation Resistance ................................……………............... 107 ohm min.
Undervoltage lockout: Switching Frequency ....... (12/24)Vin. .........………….............. 400KHz, Typ.
12Vin ……….…… power up ---->8.8V, power down ----->8V 48Vin .....……….….….................... 300KHz, Typ.
24Vin …………… power up ---->17V, power down ----->16V Operating Case Temperature …..……………..................... –40℃ to 100℃
48Vin ……….… power up ---->34V, power down ----->32.5V Storage Temperature …………………………..................... -55℃ to +105℃
Positive Logic Remote ON/OFF ( see note 3 & 4 ) Thermal Shutdown, Case Temp. ………………….………..……. 100℃ Typ.
Input Filter ………………………………………............………... PI Type Humidity .................................................... 95% RH max. Non condensing
OUTPUT SPECIFICATIONS: MTBF ……. MIL-STD-217F, GB, 25℃, Full Load ……..…… 1000KHrs Typ.
Voltage Accuracy: ................................................................ ±1% max. Dimensions .............................. 2.28×2.40x0.50 inches (57.9 x61.0×12.7 mm)
Transient Response:25% Step Load Change …….........… <500u sec. Case Material .................................................………………….….. Aluminum
External Trim Adj. Range ……………………………………………
±10%
Weight …………………………………………………………………………. 88g
Ripple & Noise, 20MHz BW(see note 5) NOTE:
2.5 & 3.3V & 5V ………….. 20mV RMS, max. 1. Measured From High Line to Low Line
75mV pk-pk, max. 2. Measured From Full Load to Zero Load
12V & 15V …………......…. 30mV RMS, max. 3. Logic Compatibility ……... Open Collector ref to –Input
100mV pk-pk, max Module ON ………………………………………..… …. Open Circuit
24V …………………..……100mV RMS, max. Module OFF ………………………………………….…….. < 0.8Vdc
240mV pk-pk, max. 4. Suffix "N" to the Model Number with Negative Logic Remote ON/OFF
Temperature Coefficient ..............................................…..... ±0.03%/°C 5. Output Ripple and Noise measured with 10uF tantalum and 1uF Ceramic
Short Circuit Protection ...........…...................................... Continuous capacitor across output
Line Regulation ( see note 1 ) ……................................…. ±0. 2% max. 6. Suffix “-C” to the Model Number with Clear Mounting Insert (3.2mm DIA.)
Load Regulation ( see note 2 ) ……............…........ ............ ±0.2% m ax.
Over Voltage Protection trip Range, % Vo nom. .................. 115-140%
Current Limit ........................................ 110% ~150% Nominal Output
Start up time …………………………….…………..……..…... 5ms Typ.
6Trim
+Sense
+Vout
9
7
8
BOTTOM VIEW
M3*0.5 Through 4pl.
Function
ON/OFF
CASE
-Vin
-Vout
-Sense
+Vin
3
4
5
Pin
1
2
Mounting Inserts
Millimeters: X.X= ±0.5 , X.XX=±0.25
All Dimensions In Inches(mm)
CASE HB
Tolerances Inches: X.XX= ±0.02 , X.XXX= ±0.010
REMOTE ON/OFF CONTROL EXTERNAL OUTPUT TRIM
ON/ OFF (2)
-V IN (4)
HIGH S IGNAL HERE
D ISA BLE OUTPUT