OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG Date: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
1
OF
6
1.0 Description
The P1RX4C-SX4x-01MM (SX4 ROSA Module) is an
optical to electrical (O-E) module that receives four
video- or data-channels from one singlemode or
multimode fiber. With the TIA and Limiting Amp
embedded in the OSA and enclosed in an EMI shielded
metal housing, the SX4 ROSA module is a fully
integrated receiver versatile enough to be designed in to
a variety of systems.
2.0 Features
• Multiple signals from one Multimode fiber
• Integrated TIA and Limiting Amp
• Metal enclosure with SC optical interface
• CML outputs
This device is EXTREMELY SENSITIVE to Electrostatic Discharge (ESD). At a minimum, all handling must be
performed in accordance with an ANSI-compliant ESD Control Program (ANSI/ESD S20.20-2007) to mitigate
possible ESD-induced damage. Reliability and life of the device will be adversely affected if these precautions are
not met.
This device is a Class 3R Laser device (per IEC 60825-1:2007) and can cause damage to eye sight if used improperly. Refer to ANSI
Z136 for proper handling and usage of Class 3R devices.
OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG DATE: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
2
OF
6
3.0 Absolute Maximum Ratings
Parameter Symbol
Min
Typ Max
Units
Storage Temperature
1, 3
Tst -40 85 °C
3.3V Supply Voltage VCC1 -0.3 3.6 V
Operating Surface Temperature
2
Ta 0 65 °C
Operating Humidity
3
RH 80 %
Durability – SC Connector 200 cycles
Durability – Plug-down Connector 50 cycles
4.0 Optical Characteristics
Parameter (per channel) Symbol
Min Typ Max
Units
Wavelength – Lane 0 778 nm
Wavelength – Lane 1 800 nm
Wavelength – Lane 2 825 nm
Wavelength – Lane 3 850 nm
Data Rate per Channel
4
P1RX4C-SX4V-01
P1RX4C-SX4D-01
D
R
1.65
3.50 Gb/s
Peak Optical Input Power Pin 4.0 dBm
OMA Sensitivity
5
-14.25 -16.00 dBm
1
Stresses listed may be applied without causing damage. Functionality at or above the values listed is not implied. Exposure to these
values for extended periods may affect reliability.
2
See outline drawing for measurement point.
3
Non condensing, 80% RH.
4
Requires DC-balanced data pattern and max run rate of 80 bits. Measured with input signals conforming to HDMI rev 1.3a, section
4.2.5, figure 4-20.
5
Optical Modulation Amplitude. Based on an unstressed input signal.
OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG DATE: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
3
OF
6
5.0 Electrical Specifications
6
Based on a jitter-free source
7
CML interface through a 100-ohm differential load.
8
This output is asserted low when a loss of signal is detected on all Lanes
Parameter Symbol
Min Typ Max
Units
Low Frequency Cutoff F
CUTOFF
175 kHz
Total Jitter (RMS), per lane
6
T
J1
10 ps
Differential Output Voltage
7
V
OD
500 mVp-p
Loss of Signal Assert Sensitivity LOS
SEN-ON
-14.50 dBm
Loss of Signal De-Assert Sensitivity LOS
SEN-OFF
-13.00 dBm
Loss of Signal Output Low
8
V
LOS
0.7 V
Loss of Signal Output High V
LOS
2 V
Operating Supply Voltage V
CC
3.15 3.30 3.54 V
Operating Supply Current I
CC
127 mA
OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG DATE: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
4
OF
6
6.0 Pin Numbers and Descriptions
The RX-SX4 plugs into a 30 pin connector. For information on the specifications
of the connector, contact Hirose (DF12(4.0)-30DP-0.5V(86)).
Pin # Signal Description
1 GND Ground
2 LOS Global Loss of Signal Indicator
3 +TD0 Positive Data Output (778nm)
4 NC No Connect
9
5 -TD0 Negative Data Output (778nm)
6 NC No Connect
9
7 +TD1 Positive Data Output (800nm)
8 NC No Connect
9
9 -TD1 Negative Data Output (800nm)
10 NC No Connect
9
11 +TD2 Positive Data Output (825nm)
12 NC No Connect
9
13 -TD2 Negative Data Output (825nm)
14 NC No Connect
9
15 +TD3 Positive Data Output (850nm)
16 NC No Connect
9
17 -TD3 Negative Data Output (850nm)
18 NC No Connect
9
19 GND Ground
20 NC No Connect
9
21 NC No Connect
9
22 NC No Connect
9
23 NC No Connect
9
24 NC No Connect
9
25 NC No Connect
9
26 NC No Connect
9
27 NC No Connect
9
28 VCC 3.3 volt input.
29 GND Ground
30 VCC 3.3 volt input.
7.0 Laser Safety
The P1RX4-SX4x-01 meets Class-3 requirements.
9
NC = No Connect. Do not connect anything to this pin.
OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG DATE: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
5
OF
6
8.0 Environmental Standards
Omron Network Products designs and manufactures its products to minimize the
negative impact on our environment. As such, the P1RX4C-SX4-01MM
conforms to a variety of environmental and safety standards
Standard Compliant Certificate Available
RoHS Yes Yes
OMRON
®
O
MRON
N
ETWORK
P
RODUCTS
ORIGINATOR: C. ENG DATE: 7/8/2011
DOCUMENT NO.
DOC002107
REV
A
OMRON
P1RX4C-SX4x-01MM Product Specification
SHEET
6
OF
6
Dimensions
The SX4 ROSA is designed to work with a standard SC ferrule only. Insertion of
any other type may result in damage.
Dimensions (mm) and orientation are for reference only.
Temperature measurement point
