TS79L09CYRM - Taiwan Semiconductor Co., Ltd.

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

1/7

Version: C07

TO

-

92

SOT

-

89

SOP

-

8

General Description

The TS79L00 Series of negative voltage regulators are inexpensive, easy-to-use devices suitable for a multitude

of applications that require a regulated supply of up to 100mA. Like their higher power TS7900 and TS79M00

Series cousins, these regulators feature internal current limiting and thermal shutdown making them remarkably

rugged. No external components are required with the TS79L00 devices in many applications.

These devices offer a substantial performance advantage over the traditional zener diode-resistor combination, as

output impedance and quiescent current are substantially reduced.

Features

● Output Voltage Range -5V, -9V, -12V

● Output current up to 100mA

● Internal thermal overload protection

● Internal short-circuit current limiting

● Output transistor safe-area compensation

● Output voltage offered in 4% tolerance

Standard Application Circuit

A common ground is required between the input and the

output voltages. The input voltage must remain typically

2.0V above the output voltage even during the low point on

the Input ripple voltage.

XX = these two digits of the type number indicate voltage.

* = Cin is required if regulator is located an appreciable

distance from power supply filter.

** = Co is not needed for stability; however, it does improve

transient response.

Ordering Information

Part No. Package

Packing

TS79LxxCT B0 TO-92 1Kpcs / Bulk

TS79LxxCT A3 TO-92 2Kpcs / Ammo

TS79LxxCY RM SOT-89 1Kpcs / 7” Reel

TS79LxxCS RL SOP-8 2.5Kpcs / 13” Reel

Note: Where xx denote voltage option

05=-5V, 09=-9V, 12=-12V

Absolute Maximum Rating

(Ta = 25

o

C unless otherwise noted)

Parameter Symbol Limit Unit

Input Voltage V

IN

-35 V

Power Dissipation P

D

Internal Limited W

Operating Temperature range T

OPR

0~+125

o

C

Junction Temperature T

J

+150

o

C

Storage Temperature Range T

STG

-65~+150

o

C

Thermal Resistance - Junction to Case TO-92 RӨ

JC

--

o

C/W

SOT-89 18

SOP-8 20

Thermal Resistance - Junction to Ambient TO-92 RӨ

JA

210

o

C/W

SOT-89 --

SOP-8 60*

Note: * Considering 6cm2 of copper board heat-sink

Definition

:

1. Output 8. N/C

2. Input 7. Input

3. Input 6. Input

4. N/C 5. Ground

Definition

:

1. Ground

2. Input

3. Output

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

2/7

Version: C07

TS79L05 Electrical Characteristics

(Vin=-10V, Iout=40mA, 0

o

C≤Tj≤125

o

C, Cin=0.33uF, Cout=0.1uF; unless otherwise specified.)

Parameter Symbol Test Condition Min Typ Max

Unit

Output voltage Vout Tj=25

o

C -4.80

-5 -5.20

V

-7.5V≤Vin≤-20V,

5mA≤Iout≤100mA -4.75

-5 -5.25

Line Regulation REGline Tj=25

o

C

-7.5V≤Vin≤-20V -- 50 150 mV

Load Regulation REGload Tj=25

o

C

5mA≤Iout≤100mA -- 20 60

5mA≤Iout≤40mA -- 10 30

Quiescent Current Iq Iout=0, Tj=25

o

C -- 3 6 mA

Quiescent Current Change ∆Iq -7.5V≤Vin≤--25V -- -- 1.5

5mA≤Iout≤40mA -- -- 0.1

Output Noise Voltage Vn 10Hz≤f≤100KHz, Tj=25

o

C -- 40 -- µV

Ripple Rejection Ratio RR f=120Hz, -8V≤Vin≤-18V 41 49 -- dB

Voltage Drop Vdrop Iout=100mA, Tj=25

o

C -- 1.7 -- V

Peak Output Current Io peak Tj=25

o

C -- 0.15 -- A

Temperature Coefficient of

Output Voltage ∆Vout/ ∆Tj

Iout=5mA, 0

o

C≤Tj≤125

o

C -- -0.65

-- mV/

o

C

TS79L09 Electrical Characteristics

Vin=-15V, Iout=40mA, 0

o

C≤Tj≤125

o

C, Cin=0.33uF, Cout=0.1uF; unless otherwise specified.)

Parameter Symbol Test Condition Min Typ Max Unit

Output voltage Vout Tj=25

o

C -8.65

-9 -9.36

V

-11.5V≤Vin≤-24V,

5mA≤Iout≤100mA -8.57

-9 -9.45

Line Regulation REGline Tj=25

o

C

-11.5V≤Vin≤-24V -- 90 180 mV

Load Regulation REGload Tj=25

o

C

5mA≤Iout≤100mA -- 30 90

5mA≤Iout≤40mA -- 15 45

Quiescent Current Iq Iout=0, Tj=25

o

C -- 3 6 mA

Quiescent Current Change ∆Iq =11V≤Vin≤=23V -- -- 1.5

5mA≤Iout≤40mA -- -- 0.1

Output Noise Voltage Vn 10Hz≤f≤100KHz, Tj=25

o

C -- 60 -- µV

Ripple Rejection Ratio RR f=120Hz, =13V≤Vin≤=24V 37 57 -- dB

Voltage Drop Vdrop Iout=100mA, Tj=25

o

C -- 1.7 -- V

Peak Output Current Io peak Tj=25

o

C -- 0.15 -- A

Temperature Coefficient of

Output Voltage ∆Vout/ ∆Tj

Iout=5mA, 0

o

C≤Tj≤125

o

C -- -0.9 -- mV/

o

C

 Pulse testing techniques are used to maintain the junction temperature as close to the ambient temperature as

possible, and thermal effects must be taken into account separately.

 This specification applies only for DC power dissipation permitted by absolute maximum ratings.

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

3/7

Version: C07

TS79L12 Electrical Characteristics

Vin=-19V, Iout=40mA, 0

o

C≤Tj≤125

o

C, Cin=0.33uF, Cout=0.1uF; unless otherwise specified.)

Parameter Symbol Test Condition Min Typ Max Unit

Output voltage Vout Tj=25

o

C -11.53

-12 -12.48

V

-14.5V≤Vin≤-27V,

5mA≤Iout≤100mA -11.42

-12 -12.60

Line Regulation REGline Tj=25

o

C

-14.5V≤Vin≤-27V -- 120 240 mV

Load Regulation REGload Tj=25

o

C

5mA≤Iout≤100mA -- 40 120

5mA≤Iout≤40mA -- 20 60

Quiescent Current Iq Iout=0, Tj=25

o

C -- 3 6.5 mA

Quiescent Current Change ∆Iq -16V≤Vin≤-27V -- -- 1.5

5mA≤Iout≤40mA -- -- 0.1

Output Noise Voltage Vn 10Hz≤f≤100KHz, Tj=25

o

C -- 80 -- µV

Ripple Rejection Ratio RR f=120Hz, -11V≤Vin≤-23V 37 42 -- dB

Voltage Drop Vdrop Iout=100mA, Tj=25

o

C -- 1.7 -- V

Peak Output Current Io peak Tj=25

o

C -- 0.15 -- A

Temperature Coefficient of

Output Voltage ∆Vout/ ∆Tj

Iout=5mA, 0

o

C≤Tj≤125

o

C -- -1.0 -- mV/

o

C

 Pulse testing techniques are used to maintain the junction temperature as close to the ambient temperature as

possible, and thermal effects must be taken into account separately.

 This specification applies only for DC power dissipation permitted by absolute maximum ratings.

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

4/7

Version: C07

TO-92 Mechanical Drawing

Marking Diagram

XX

= Output Voltage

(05=-5V, 09=-9V, 12=-12V)

Y

= Year Code

M

= Month Code

(A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep,

J=Oct, K=Nov, L=Dec)

L

= Lot Code

TO-92 DIMENSION

DIM

MILLIMETERS INCHES

MIN MAX MIN MAX

A 4.30 4.70 0.169 0.185

B 4.30 4.70 0.169 0.185

C 14.30(typ) 0.563(typ)

D 0.43 0.49 0.017 0.019

E 2.19 2.81 0.086 0.111

F 3.30 3.70 0.130 0.146

G 2.42 2.66 0.095 0.105

H 0.37 0.43 0.015 0.017

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

5/7

Version: C07

SOT-89 Mechanical Drawing

Marking Diagram

XX

= Output Voltage

(05=-5V, 09=-9V, 12=-12V)

Y

= Year Code

M

= Month Code

(A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep,

J=Oct, K=Nov, L=Dec)

L

= Lot Code

SOT-89 DIMENSION

DIM

MILLIMETERS INCHES

MIN MAX MIN MAX

A 4.40 4.60 0.173 0.181

B 1.50 1.7 0.059 0.070

C 2.30 2.60 0.090 0.102

D 0.40 0.52 0.016 0.020

E 1.50 1.50 0.059 0.059

F 3.00 3.00 0.118 0.118

G 0.89 1.20 0.035 0.047

H 4.05 4.25 0.159 0.167

I 1.4 1.6 0.055 0.068

J 0.35 0.44 0.014 0.017

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

6/7

Version: C07

SOP-8 Mechanical Drawing

Marking Diagram

XX

= Output Voltage

(05=-5V, 09=-9V, 12=-12V)

Y

= Yea

r Code

M

= Month Code

(A=Jan, B=Feb, C=Mar, D=Apl, E=May, F=Jun, G=Jul, H=Aug, I=Sep,

J=Oct, K=Nov, L=Dec)

L

= Lot Code

SOP-8 DIMENSION

DIM

MILLIMETERS

INCHES

MIN

MAX

MIN

MAX.

A

4.80

5.00

0.189

0.196

B

3.80

4.00

0.150

0.157

C

1.35

1.75

0.054

0.068

D

0.35

0.49

0.014

0.019

F

0.40

1.25

0.016

0.049

G

1.27BSC

0.05BSC

K

0.10

0.25

0.004

0.009

M

0º

7º

0º

7º

P

5.80

6.20

0.229

0.244

R

0.25

0.50

0.010

0.019

TS79L00 Series

3-Terminal 100mA Negative Voltage Regulator

7/7

Version: C07

Notice

Specifications of the products displayed herein are subject to change without notice. TSC or anyone on its behalf,

assumes no responsibility or liability for any errors or inaccuracies.

Information contained herein is intended to provide a product description only. No license, express or implied, to

any intellectual property rights is granted by this document. Except as provided in TSC’s terms and conditions of

sale for such products, TSC assumes no liability whatsoever, and disclaims any express or implied warranty,

relating to sale and/or use of TSC products including liability or warranties relating to fitness for a particular purpose,

merchantability, or infringement of any patent, copyright, or other intellectual property right.

The products shown herein are not designed for use in medical, life-saving, or life-sustaining applications.

Customers using or selling these products for use in such applications do so at their own risk and agree to fully

indemnify TSC for any damages resulting from such improper use or sale.