Memory Module Specifications KVR24R17D4/32I 32GB 2Rx4 4G x 72-Bit PC4-2400 CL17 Registered w/Parity 288-Pin DIMM DESCRIPTION ValueRAM's KVR24R17D4/32I is a 4G x 72-bit (32GB) DDR4-2400 CL17 SDRAM (Synchronous DRAM) registered w/ parity, 2Rx4, ECC, Intel(R) Compatibility Tested, memory module, based on thirty six 2G x 4-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows: SPECIFICATIONS CL(IDD) 17 cycles Row Cycle Time (tRCmin) 46.16ns(min.) Refresh to Active/Refresh Command Time 1x mode (tRFCmin) 350ns(min.) Row Active Time (tRASmin) 32.00ns(min.) Maximum Operating Power TBD W* UL Rating 94 V - 0 Operating Temperature 0o C to +85o C Storage Temperature -55o C to +100o C FEATURES *Power will vary depending on the SDRAM used. * * * * * * * * * * * * * * * * * * * Power Supply: VDD=1.2V (1.14V to 1.26V) VDDQ = 1.2V (1.14V to 1.26V) VPP - 2.5V (2.375V to 2.75V) VDDSPD=2.25V to 2.75V Functionality and operations comply with the DDR4 SDRAM datasheet 16 internal banks Bank Grouping is applied, and CAS to CAS latency (tCCD_L, tCCD_S) for the banks in the same or different bank group accesses are available Data transfer rates: PC4-2400, PC4-2133, PC4-1866, PC4-1600 Bi-Directional Differential Data Strobe 8 bit pre-fetch Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop) Supports ECC error correction and detection On-Die Termination (ODT) Temperature sensor with integrated SPD This product is in compliance with the RoHS directive. Per DRAM Addressability is supported Internal Vref DQ level generation is available Write CRC is supported at all speed grades CA parity (Command/Address Parity) mode is supported Continued >> kingston.com Document No. VALUERAM1558-001.A00 06/29/16 Page 1 MODULE DIMENSIONS kingston.com Document No. VALUERAM1558-001.A00 Page 2