
Broadband Voltage Controlled Oscillator
13.4 - 14.4 GHz
Rev. V1
MAOC-113900
2
MACOM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
DC-0007214
ESD Rating: Class 1B
Electrical Specifications: TA = +25°C, VCC = 5.0 V4, Z0 = 50 Ω
Absolute Maximum Ratings 5,6,7
4. VCO can operate over the 4.75 V to 5.25 V supply voltage range.
Output Power RF Port, 13.4 - 14.4 GHz
RF/2 Port, 6.7 - 7.2 GHz dBm 4
-2
8
2 —
SSB Phase Noise RF Port, 10 kHz Offset, 13.4 - 14.4 GHz
RF Port, 100 kHz Offset, 13.4 - 14.4 GHz dBc/Hz — -83
-109
—
-104
Harmonics/Subharmonics
VCC = VTUNE = 5 V
RF Port, 1/2 Fo
RF Port, 2 Fo dBc — -32
-52 —
Pulling
(Sensitivity to Match)
VCC = VTUNE = 5 V
RF Port, VSWR = 1.95:1 to 2.25:1 MHz pk-pk — 5.0 —
Pushing
(Sensitivity to Supply Voltage)
RF Port, VTUNE = 5 V
RF/2 Port, VTUNE = 5 V MHz/V — 18
9 —
Frequency Drift Rate
(Sensitivity to Temperature)
RF Port, 13.4 - 14.4 GHz
RF/2 Port, 6.7 - 7.2 GHz MHz/ºC — 1.4
0.7 —
Output Return Loss RF Port, 13.4 - 14.4 GHz
RF/2 Port, 6.7 - 7.2 GHz dB — 6
3 —
Tuning Sensitivity @ RF Port VTUNE = 5 V GHz/V — 0.18 —
Supply Current ICC mA — 90 120
Tune Voltage VTUNE V 1.5 — 12.5
Tuning Current Leakage VTUNE = 13 V µA — 5 —
Parameter Absolute Maximum
Voltage 5.5 Vdc
VTUNE 0 to 15 Vdc
Storage Temperature -55ºC to +150ºC
Operating Temperature -40ºC to +85ºC
Junction Temperature8 +150ºC
5. Exceeding any one or combination of these limits may cause
permanent damage to this device.
6. MACOM does not recommend sustained operation near these
survivability limits.
7. Operating at nominal conditions with TJ ≤ +150°C will ensure
MTBF > 1 x 106 hours.
8. Junction Temperature (TJ) = TC + Өjc * (V * I)
Typical thermal resistance (Өjc) = 42° C/W.
a) For TC = 25°C, TJ = 44°C @ 5 V, 90 mA
b) For TC = 85°C, TJ = 104°C @ 5 V, 91 mA
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
These electronic devices are sensitive to
electrostatic discharge (ESD) and can be damaged
by static electricity. Proper ESD control techniques
should be used when handling these HBM Class
1B devices.