https://www.phoenixcontact.com/us/products/1020775
02/15/2021Page1/5
Connector-PV-C4M-S 2,5-6 (-)-1020775
Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's
documentation. Our General Terms of Use for Downloads are valid
(http://phoenixcontact.com/download)
Photovoltaic connector, Range of articles: PV-C4M-S, Connector, housing material: PPE, color: black, min.
conductor cross section: 2.5 mm², max. conductor cross section: 6 mm², rated current: 20 A, Connection method:
Spring-cage, Type of contact: Pin
Key Commercial Data
Packing unit 1 pc
Minimum order quantity 50 pc
GTIN
GTIN 4055626511283
Weight per Piece (excluding packing) 19.600 g
Custom tariff number 85359000
Country of origin India
Technical data
Dimensions
External cable diameter 5 mm ... 8 mm
Ambient conditions
Degree of protection (when plugged in) IP66 /IP68 (2 m / 24 h)
Ambient temperature (operation) -40 °C ... 85 °C
Ambient temperature (assembly) -25 °C ... 50 °C
General
Design Pin
Tightening torque nut 2 Nm ±0.1 Nm
Insertion force 45 N ±10 N
https://www.phoenixcontact.com/us/products/1020775
02/15/2021Page2/5
Connector-PV-C4M-S 2,5-6 (-)-1020775
Technical data
General
Disconnect force 250 N ±50 N (when locked)
Pull-out force of cable >= disconnect force > 80 N
Insertion/withdrawal cycles 100
Degree of pollution 2
Degree of protection IP66 /IP68 (2 m / 24 h)
Voltage 1500 V
Current 35 A
Rated surge voltage (III/3) 16 kV
pluggable Yes
Nominal cross section 6 mm²
Protection class II
Material
Color black
Insulating material mPPE
Contact material Cu
Contact surface material Ag
Connection data
Connection method Spring-cage
Connection capacity 2.5 mm² ... 6 mm²
Contact resistance with connected conductor 0.45 mΩ
Stripping length 15 mm
Cable type H1Z2Z2-K cable
Type of contact Pin
Standards and Regulations
Flammability rating according to UL 94 V0
Safety note
• WARNING: Commission properly functioning products only. The products
must be regularly inspected for damage. Decommission defective products
immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate
the product. They must observe the following safety notes. The qualified
personnel must be familiar with the basics of electrical engineering. They
must be able to recognize and prevent danger. The relevant symbol on the
packaging indicates that only personnel familiar with electrical engineering
are allowed to install and operate the product.
WARNING: The connectors may not be plugged in or disconnected under
load. Ignoring the warning or improper use may damage persons and/or
property.
• The products are suitable for applications in plant, controller, and
electrical device engineering.
https://www.phoenixcontact.com/us/products/1020775
02/15/2021Page3/5
Connector-PV-C4M-S 2,5-6 (-)-1020775
Technical data
Standards and Regulations
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the
standards listed (e.g. the ones listed in the product accessories online at
phoenixcontact.com/products).
• When using the product in direct connection with third-party
manufacturers, the user is responsible.
• For operating voltages > 50V AC, conductive connector housings must
be grounded
• Ensure that the protective or functional ground has been properly
connected.
• Observe the corresponding technical data. You will find information:
o On the product
o On the packing label
o In the supplied documentation
o Online at phoenixcontact.com/products under the product
• The installation notes/Design In documents online on the download page
at phoenixcontact.com/products must be observed for this product.
• Use a protective cap to protect connectors that are not in use. The
suitable accessories are available online in the accessory section of the
product at phoenixcontact.com/products
• The connector warms up in normal operation. Depending on the ambient
conditions, the surface of the connector can continue to warm up. In
this case, the user is responsible for posting warnings (e.g. DIN EN ISO
13732-1:2008-12).
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors
does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable without
twisting it.
Environmental Product Compliance
China RoHS Environmentally friendly use period: unlimited = EFUP-e
No hazardous substances above threshold values
Drawings
Dimensional drawing
82,6
15 16
27,4
Ø20
https://www.phoenixcontact.com/us/products/1020775
02/15/2021Page4/5
Connector-PV-C4M-S 2,5-6 (-)-1020775
Classifications
eCl@ss
eCl@ss 10.0.1 27440102
eCl@ss 11.0 27440102
eCl@ss 8.0 27440102
eCl@ss 9.0 27440102
Accessories
Accessories
Photovoltaic connector
Protective cap-PV-C PROTECTION CAP-1785430
Photovoltaic connector, Range of articles: SUNCLIX, Protective cap, color: black. self-sealing, without interlock, set
consisting of: 1protective cap for connector side and1protective cap for coupling side
Filler plugs-PV-C-PLUG-HV-1623478
Photovoltaic connector, Filler plugs, housing material: PA 6
Screwdriver tools
Screwdriver-SZF 1-0,6X3,5-1204517
Actuation tool, for ST terminal blocks, also suitable for use as a bladed screwdriver, size: 0.6 x 3.5 x 100 mm, 2-
component grip, with non-slip grip
Stripping tool
https://www.phoenixcontact.com/us/products/1020775
02/15/2021Page5/5
Connector-PV-C4M-S 2,5-6 (-)-1020775
Accessories
Stripping pliers-QUICK WIREFOX 6 SC-1207637
Stripping tool for short-circuit proof conductors, stripping range: 1.5 up to 6 mm², wire cutting up to 6 mm² cable stopper
up to 18 mm²
Stripping tool-WIREFOX-D SR 6-1-1212511
Stripping tool, for standard 2.5, 4, and 6 mm² solar cables, with 15 mm length stop, for SUNCLIX field connectors
Phoenix Contact 2021 © - all rights reserved
http://www.phoenixcontact.com
