Evaluation Board Document NE5550234-EV04-A Evaluation Board o Circuit Description o Typical Performance Data o Circuit Schematic and Assembly Drawing Circuit Description The NE5550234A-EV04-A is an evaluation circuit board for Renesas' LDMOS power FET, NE5550234 optimized for the performance at 460MHz. The circuit board is RoHS compliant. Matching and Bias Circuits Refer to the schematic and assembly drawing in the two last pages for the component designation and location. The input matching circuit consists of two sections of LC low pass network. At output two sections of transmission line, TL1 and TL2, in combination with inductor L3, provide the required serial components for impedance transformation. The electrical lengths of the transmission lines labeled on the schematic are estimated and for reference only. Some bench tuning on the actual circuit board is usually required to achieve optimal performance. For applications where there is a constraint on the board space, serial inductors, instead of transmission lines, can be used for the matching circuits. Low loss inductors should be selected to maintain good efficiency of the PA circuit. The resistor, R3(=2.4ohm) at input is used to improve the stability margin. The gain is reduced by about 1-2dB when R3 is used. LDMOSFETs essentially draw no gate current under normal operation conditions. Therefore a large value resistor, in the order of k, can be used for the bias at gate so that the RF path is completely isolated from the DC line. At the drain an inductor is used as the RF choke. The current rating for this inductor should be high enough to provide the required current at the operation conditions. Bias Conditions This evaluation board was optimized at a specific drain voltage, 7.5V. For different supply voltages, the matching circuits should be adjusted to fully utilize the device capability. The quiescent current is 40mA for the data shown below. The gain is higher at higher quiescent currents, particularly when the device is not completely saturated. For many communication systems, where the PA is never at idle state, a high quiescent current might be used. PCB Material: The PCB is Getek 28mil two layer board. The dielectric constant of Getek is 4.2. 2 Typical Performance Data Test Conditions: f=460MHz Vd=7.5V, Idsq=40mA Pout, Gain, PAE and Current vs Pin are shown in the following plot. 3 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: CEL: NE5550234-EV04-A