PM500 and VM500 SERIES Single, dual and triple output Recommended for new design-ins * * * * * * * These encapsulated, PC-mountable linear power modules feature 23 single output, 14 dual output and 13 triple output models for a wide variety of printed circuit board applications. The 5V output of all models have overvoltage crowbar protection as a standard feature. For maximum safety, all power transformers are split bobbin wound, rather than layer wound, to give total isolation with low coupling capacitance between primary and secondary. Conservative design and rating of these modules results in reliable operation and long life. Standard input voltage is 115VAC; other optional inputs are 220 and 240VAC. Most models are available in standard and alternate pin configurations for second sourcing applications. This series includes 5 subminiature modules for lower power applications where minimum circuit board space is available. [ 2 YEAR WARRANTY ] VM500 Series only SPECIFICATION OVP on 5V outputs Split bobbin wound PCB mounting UL and CSA approved 115, 220 and 240VAC input Short circuit protection The VM500 Series has EN60950 approval All specifications are typical at nominal input, full load at 25C unless otherwise stated GENERAL SPECIFICATIONS OUTPUT SPECIFICATIONS Voltage accuracy Voltage adjustability 1.0% max. PM529 and PM563 only Yes Line regulation See table Load regulation See table Efficiency Isolation voltage 40% typical PM series, no suffix PM series, suffix D PM series, suffix K VM534D 700VAC 2500VAC 2500VAC 3000VAC Switching frequency Temperature coefficient Linear 0.02%/C Overvoltage protection See table on facing page for relevant models 6.2V typical Output power limit Typical 130% to 200% FL Short circuit protection Switch off/on 100% to 200% FL Approvals and standards Safety VM534D IEC950 Safety PM5xx CSA22.2-143/-154, UL478 Case material Weight Case Case Case Case Case MTBF See Note 4 INPUT SPECIFICATIONS Input voltage range Input frequency range See tables below PM500, See Note 3 VM500 47Hz to 400Hz 47Hz to 63Hz Non-conductive black plastic A 181g (6.4oz) B1 (incl. VM534D) 340g (12oz) B2 408g (14.4oz) B3 635g (22.4oz) H 227g (8oz) 710,000 hours ENVIRONMENTAL SPECIFICATIONS Safety ground leakage current Less than 3.5mA @ 50Hz Thermal performance Operating amb. -25C to +71C Non-operating amb. -25C to +85C Derating, 50C to 71C 2.5%/C Cooling Free-air convection Relative Humidity Non-condensing 20% to 95% RH Vibration Encapsulated PM500 INPUT VOLTAGE SUFFIX VM534D INPUT VOLTAGE SUFFIX 11510VAC (NONE) 200 to 233VAC D 22020VAC D 24020VAC K PAGE 1 AC/DC POWER SUPPLIES | 1.0-10.5W AC 1 to 10.5 Watt AC/DC encapsulated modules OUTPUT VOLTAGE OUTPUT CURRENT OVP REGULATION LINE LOAD RIPPLE AND NOISE CASE AVAILABLE MODELS 110VAC 220VAC 240VAC SINGLE OUTPUT 5VDC 250mA Yes 0.02% 0.04% 1mV rms B1 5VDC 500mA Yes 0.02% 0.04% 1mV rms B1 5VDC 500mA Yes 0.02% 0.04% 2.8mV rms B1 5VDC 1000mA Yes 0.02% 0.04% 1mV rms B2 PM533D PM534 PM534D PM534K PM542 PM542D PM542K PM545K VM534D 5VDC 2000mA Yes 0.02% 0.05% 1mV rms B3 PM545 PM545D 12VDC 240mA No 0.02% 0.02% 0.5mV rms B2 PM515 PM515D 12VDC 400mA No 0.02% 0.02% 1mV rms B3 PM516D 12VDC 600mA No 0.02% 0.02% 1mV rms B3 PM517D 24VDC 100mA No 0.02% 0.02% 0.5mV rms B2 PM566D 24VDC 200mA No 0.02% 0.02% 0.5mV rms B3 PM567D 24VDC 400mA No 0.02% 0.02% 1mV rms B3 PM568D (1) SUB MINIATURE SINGLE OUTPUT SERIES 5VDC 250mA No 0.05% 0.05% 0.5mV rms H PM529 PM529D 12VDC 100mA No 0.02% 0.02% 0.5mV rms A PM563 PM563D 12VDC 120mA No 0.02% 0.02% 0.5mV rms B1 PM536 PM536D 12VDC 240mA No 0.02% 0.02% 0.5mV rms B2 12VDC 400mA No 0.02% 0.02% 0.5mV rms B3 15VDC 25mA No 0.20% 0.20% 2mV rms B1 PM538 15VDC 100mA No 0.02% 0.02% 0.5mV rms B1 PM505 PM505D 15VDC 200mA No 0.02% 0.02% 0.5mV rms B2 PM565 PM565D 15VDC 350mA No 0.02% 0.02% 1mV rms B3 PM501 PM501D B2 PM595S PM595DS PM529K DUAL OUTPUT 5V/12VDC 300/180mA 5V/12VDC No 0.02% TRIPLE OUTPUT (2) .05%/.02% 0.5mV rms 3 4 5 PM597K PM501K 500/120mA No 0.02% .05%/.02% 0.5mV rms B2 Yes 0.02% .01%/.02% 1.0/0.5mV rms B3 PM592 PM592D PM591D 5V/15VDC 300/150mA Yes 0.05% .10%/.05% 0.5mV rms B2 PM594 PM594DS 5V/15VDC 500/100mA Yes 0.05% .10%/.05% 0.5mV rms B2 PM590 PM590D PM590K 5V/15VDC 1000/150mA Yes 0.02% .01%/.02% 1.0/0.5mV rms B3 PM593 PM593D PM593K VM534D Trim connection on all sub-miniature series modules provides a means of externally adjusting a units output voltage precisely to its labelled value. To raise the output voltage, connect a resistance (20k, min.) between the trim terminal and the positive (+) output terminal. To lower the output voltage, connect a resistance (20k, min.) between the trim terminal and the negative (-) output terminal. Triple output models only: on standard pin-out models the 5V output common is isolated from the 12VDC or 15VDC common. Some units should be derated for operation at 400Hz. Please contact the factory for details. M.T.B.F. figures are based on actual product performance. Consult factory for details. All models are only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. 2.50 (63.5) 0.50 (12.7) 0.60 (15.2) 0.50 (12.7) 0.60 (15.2) 0.15 (3.8) NC 0.88 (22.4) + 2 PM597D 5V/12VDC 1000/150mA Notes 1 PM537D PM597 - OUT OUT 1.60 (40.6) 3.50 (88.9) INSERTS 4.40 THREAD 0.125 (3.2) DEEP AC 1.60 (40.6) AC 2.20 (55.9) 0.040 (1.0) DIA. PINS CASE B1 0.20 (5.1) MIN. SINGLE OUTPUT MODEL ALL DIMENSIONS IN INCHES (mm) http://www.artesyn.com PAGE 2 AC/DC POWER SUPPLIES | 1.0-10.5W AC 1 to 10.5 Watt AC/DC encapsulated modules Single output PM500 series CASE A CASE H 1.75 (44.5) 0.275 (7.1) 1.00 (25.4) 0.20 (5.1) 0.20 (5.1) 0.50 (12.7) 1.60 (40.6) 0.50 (12.7) 0.20 (5.1) - OUT TRIM + OUT 0.50 (12.7) 0.60 (15.2) NC - OUT 1.60 (40.6) 3.00 (76.2) 0.40 (10.2) 3.50 (88.9) INSERT 4.40 THREAD 0.125 (3.2) DEEP 2.60 (66.0) 1.80 (45.7) AC AC AC AC INSERT 4.40 THREAD 0.12 (3.0) DEEP 0.20 (5.1) MIN. 0.040 (1.0) DIA. PINS 1.62 (41.1) 1.25 (31.8) 0.88 (22.4) OUT 1.55 (39.4) TRIM 2.25 (57.2) INSERT 4.40 THREAD 0.12 (3.0) DEEP 1.00 (25.4) 0.15 (3.8) - OUT OUT + 0.80 (20.3) 2.50 (63.5) 0.50 (12.7) 0.60 (15.2) + 0.60 (15.2) 1.20 (30.5) AC CASE B 2.00 (50.8) AC B1 B2 B3 0.20 (5.1) MIN. 0.040 (1.0) DIA. PINS 1.60 (40.6) 2.20 (55.9) 0.20 (5.1) MIN. 0.040 (1.0) DIA. PINS ALL DIMENSIONS IN INCHES (mm) R1 (20K MIN.) OR R2 (20K MIN.) - OUT + OUT TRIM SUB-MINIATURE SERIES Dual and triple output PM500 series SIDE VIEW CASE B CASE B CASE B DUAL OUTPUT MODELS TRIPLE OUTPUT MODELS STANDARD PINOUT TRIPLE OUTPUT MODELS ALTERNATE PINOUT SUFFIX '-S' AC 2.20 (55.9) INSERTS 4.40 THREAD 0.125 (3.2) DEEP AC 0.55 (14.0) + 0.55 (14.0) COM 0.55 (14.0) - 1.60 (40.6) 3.50 (88.9) INSERTS 4.40 THREAD 0.125 (3.2) DEEP 1.60 (40.6) AC 1.62 (41.1) 1.25 (31.8) 0.88 (22.4) 0.15 (3.8) 3.50 (88.9) 1.60 (40.6) AC 0.55 (14.0) 1.60 (40.6) 3.50 (88.9) INSERTS 4.40 THREAD 0.125 (3.2) DEEP COM 5V 1.60 (40.6) + 5V 0.60 (15.2) 0.15 (3.8) + 0.50 (12.7) 2.50 (63.5) + 5V 0.50 (12.7) COM 0.60 (15.2) - COM 5V 0.60 (15.2) 0.15 (3.8) + OUT 0.50 (12.7) 0.50 (12.7) 2.50 (63.5) COM - OUT 0.60 (15.2) 2.50 (63.5) AC 1.60 (40.6) AC B1 B2 B3 2.00 (50.8) 2.20 (55.9) 0.040 (1.0) DIA. PINS 0.20 (5.1) MIN. ALL DIMENSIONS IN INCHES (mm) International Safety Standard Approvals IEC950 Certificate No. IDP080 (VM534D only) UL478 Reg. File No. E131987 CSA22.2-143 and -154 Reg. File No. LR59996 PAGE 3