DC Electrical Characteristics: (TA = –30° to +60°C unless otherwise specified)
Parameter Symbol Test Conditions Min Typ Max Unit
Key Contact Resistance RKI – – 1 kΩ
Keyboard Capacitance CKI – – 30 pF
Input Voltage K1H 2–of–7 input mode, Note 4 0.8VDD –VDD V
GND –0.2VDD V
Key Pull–Up Resistance KIRU VDD = 6.0V, VIN = 4.8V –4–kΩ
Key Pull–Down Resistance KIRD –100 –kΩ
MUTE Sink Current IMVDD = 2.5V, VOUT = 0.5V, Note 5 500 – – µA
Pulse Output Sink Current IPVDD = 2.5V, VOUT = 0.5V, Note 6 1.0 – – mA
VDD–VRFF Value VREF ISUPPLY = 150µA, Note 7 1.5 2.5 3.5 V
Memory Retention Current IMR All outputs in no–load state –0.7 –µA
Operating Current IOP All outputs in no–load state –100 150 µA
MUTE, PULSE Leakage ILKG VDD = 6.0V, VOUT = 6.0V, Note 5, Note 6 –0.001 1 µA
Note 4. Applies to key input pins (ROW1–ROW4 COL1–COL3)
Note 5. Applies to MUTE output pin.
Note 6. Applies to PULSE output pin
Note 7. Applies to VREF pin.
AC Electrical Characteristics:
Parameter Symbol Test Conditions Min Typ Max Unit
Oscillator Frequency fOSC Note 8 –480 –kHz
Keyboard Debounce Time tDB –10 –ms
Time for Valid Key Entry tKD 40 – – ms
Oscillator Start–Up Time tON Note 9 –6–ms
Pulse Rate PR–10 –pps
Break Time tBPin9 tied to V+ –61 –ms
Pin9 tied to V– – 67 –ms
Inter–Digital Pause tIDP –800 –ms
Note 8. Typical values are exact with a nominal 480kHz frequency reference (except for oscillator
start–up time)
Note 9. Ceramic resonator should have the following equivalent values: R < 20Ω, RA ≥ 70kΩ, CO
≤ 500pF.