P r o d u c t D a t a IPL 10530 Integrated Photodiode Amplifiers Photodiode detectors with transimpedance amplifiers * Fully-integrated construction * High interference rejection * Low thermal drift * Analogue amplified voltage output * Range of devices to suit applications in process monitoring, environmental monitoring and general industries IPL 10530 Integrated Photodiode Amplifiers IPL 10530 Integrated Photodiode Amplifiers are a Frequency Response family of light-sensitive detectors, providing a voltage 40dB output proportional to the incident light level. The devices will operate from single or dual rail power sources, allowing simple interfacing with logic circuits IPL Photodiode 10530E 30 or voltage comparators. 10530D Amplifiers consist of silicon 10530C photodiodes close-coupled to amplifiers. These are mounted on ceramic substrates and 20 hermetically sealed within T05 type metal packages to give exceptional rejection of electrical noise in arduous environments. This family provides various gain/bandwidth options to suit a wide 10 range of applications. 10530A Applications The IPL 10530 range of Integrated Photodiode Amplifiers provide positive output voltage for 1 Frequency (KHz) 10 100 increased light levels. These devices are especially suited to low light level applications, or those Amplifier Options where high sensitivity or high interference rejection Standard feedback configurations are available to is required. provide high sensitivity and high speed in various Ideal for use with the IPL range of Self-Monitoring combinations. Emitters, these devices provide the complete solution available for sensitive pulse detection. Where feasible, for the monitoring of particulate pollution in IPL will manufacture to custom requirements. Undercompensated versions are liquids and gases, water turbidity measurement or gas detection by virtue of spectral absorption Filter Options bands. Gas Eye response (BG18) or N.I.R. Bandpass (RG850). Many pollution sensing, obscuration or "clouding" (nephelometry) techniques are alternative, other filter options are available upon request. proven applications. Silicon Relative Spectral Response Normalised Response of Typical Filters 100% 100% NIR Bandpass Standard Silicon Visible Bandpass 80 80 60 Blue/UV Enhanced Silicon 60 Eye Response 40 40 20 20 200 300 400 500 Wavelength (nm) ULTRA VIOLET (UV) 600 VISIBLE 700 800 900 1000 NEAR INFRA-RED (NIR) 1100 200 300 400 500 Wavelength (nm) ULTRA VIOLET (UV) 600 VISIBLE 700 800 900 1000 NEAR INFRA-RED (NIR) 1100 P r o d u c t D a t a Pulse Response 10530A Lens and Window Options Devices are supplied in TO5 cans with flat or lensed windows. Either window option can be provided with integral filters. Typical filters are "eye response" or IR. Specialist filters such as UV transmissive or bandpass are also available on request. 2V Polar Response 0 10 20 s 10 10530D 20 20 30 30 40 40 100% Lens 20 2V Re la t 40 iv e Window Re s 60 po ns e 80 Dark Voltage Offset v Temperature Maximum Offsets for Unselected 10530A, C & D mV Vcc=15v 10530D (Available upon request) 500 400 300 Vcc=5v 200 Vcc=5v 100 10 20 30 Temperature (C) Amplifier Output (V) 40 50 60 70 80 90 Transfer Curves 14.000 12.000 10.000 CAW 8.000 AAL EAW 6.000 DAW AAW 4.000 DAL CAL 2.000 EAL HAL 0.000 0.0000 0.0200 0.0400 0.0600 0.0800 0.1000 0.1200 0.1400 0.1600 Illumination (W/cm2) 20 s P r o d u c t D a t a Typical Characteristics @25C DETECTORS HIGH FREQUENCY 10530AAL 10530AAW UNITS (with lens) (flat window) PARAMETER PULSE 10530CAL (with lens) 10530CAW (flat window) GENERAL PURPOSE 10530DAL 10530DAW (with lens) (flat window) 10530HAL (with lens) HIGH GAIN 10530EAL (with lens) 10530EAW (flat window) DC Supply Voltage (Dual Rail) Vcc V 2 to 18 2 to 18 2 to 18 2 to 18 2 to 18 2 to 18 2 to 18 2 to 18 2 to 18 DC Supply Voltage (Single Rail) Vcc V +4 to +36 +4 to +36 +4 to +36 +4 to +36 +4 to +36 +4 to +36 +4 to +36 +4 to +36 +4 to +36 4.0 4.0 4.0 4.0 4.0 4.0 1.6 4.0 4.0 Quiescent Current Dissipation (up to 55C) mA (above 55C derate linearly 6.67mW/C) mW 630 630 630 630 630 630 630 630 630 Dark Level Noise (RMS) mV 1.0 1.0 1.0 1.0 0.3 0.3 0.3 1.5 1.5 Detector Output Offset (MAX) mV 5 5 5 5 6 6 5 7 7 Detector Output Voltage Vo (LED - Wavelength 880nm) VW-1mm-2 8.0 0.8 50.0 5.0 60.0 6.0 5.0 90.0 9.0 Detector Frequency Response (-3dB) KHz 230 230 80 80 12 12 100 62 62 Detector Output Current Sink Source mA mA 10 1 10 1 10 1 10 1 10 1 10 1 1 10 10 1 10 1 Short Circuit Output Duration s Temperature Range Operating Storage C C -20 to +80 -30 to +100 -20 to +80 -30 to +100 -20 to +80 -30 to +100 -20 to +80 -30 to +100 -20 to +80 -30 to +100 -20 to +80 -30 to +100 -20 to +85 -30 to +100 -20 to +80 -30 to +100 -20 to +80 -30 to +100 Step Response 10% - 90% Rise Time Fall TIme s s 2.0 1.5 2.0 1.5 4.5 4.2 4.5 4.2 40 40 40 40 1 7 6.0 5.5 6.0 5.5 V Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 Vcc-2.0 1.75 1.75 1.75 1.75 1.75 1.75 1.75 1.75 1.75 Saturation @Peak Wavelength (mm2) Photodiode Active Area Dimensions (mm) O8.33 O9.1 Basic Circuit Pinout 4. 1. 3. +Vcc 2.1 - + 6.5 3. 2. Output Vo 4. -V 1. OV Case 2. 25.4 5.1 Basic Circuit 10530HAL O0.45 Typ. 5.84 PCD 3. +Vcc - + 2. Output Vo 4. OV Case 1. -V DS-014 ISSUE 2 Integrated Photomatrix Limited Paceycombe Way, Poundbury, Dorchester, Dorset, DT1 3SY, UK Tel: +44 (0) 1305 263673 Fax: +44 (0) 1305 263679 E-mail: sales@ipl-uk.com Website: http://www.ipl-uk.com All characteristics are approximate values. IPL reserve the right to change the product shown on this leaflet in the interest of improved specification. No responsibility is assumed for the use of information contained herein, nor for any infringement of patent of rights of others which may result from such use.