4：OUT1
3：OUT2
1：VDD
Switch
Dynamic
OffsetCancellation
2：VSS
Output
Stage
AMP
Chopper
SW
Hall
Element
OSC
&
TimingLogic
Schmitt
Trigger
&
Latch
0BopNBrpN
BhN
H
VOL
L
VOUT1
VOH
VOH
0
BopS BrpS
BhS
H
VOL
L
VOUT2
SorN
NorS
Packagetop
Packagebottom
N S
Magneticfluxdensity Magneticfluxdensity
●FunctionalBlockDiagram
●OperationalCharacteristics
（Npole）
 （Spole）
Item
OSC
TimingLogic

HallElement
ChopperSW
AMP
SchmittTrigger
Generatesoperatingclock
GeneratestimingsignalrequiresforChopperSW,
AMPandothercircuits
HallelementfabricatedbyCMOSprocess
Performschoppinginordertocanceltheoffset
voltageofHallsensor
ReduceoffsetvoltageandamplifiesHalloutputvoltage
Hysteresiscomparator
CMOSoutput,Duringthepowerdownmode,output
islatchedinitspreviousstate
Function
LatchLogic
OutputStage
25
MonolithicHallEffectICs AK-series
●Features
・Highsensitiveomnipolaroperation
・Dualoutput
・Micropoweroperation
 Typ.6.5μA（average:VDD=1.85V）
・UltrasmallSONpackage:1.1×1.4×t0.37mm
 Halogenfree
Notice:Itisrequestedtoreadandaccept"IMPORTANTNOTICE"writtenonthebackofthefrontcoverofthiscatalogue.
AK8789
AK8789isultra-smallHalleffectICofasinglesiliconchipcomposedofHallelementandasignalprocessingIC.
SupplyVoltage
1.6〜5.5Ｖ
HighSensitivity
Bop：2.5mT
SON
UnipolarHall
EffectSwitch
TwooutputforS
andN-pole
Shippedinpacket-tapereel(5000pcs/Reel)
HallElement
Pulse
Excitation
Output
CMOS
Twooutput
forSandN-pole
VDD
IOUT
TSTG
＋6.5
＋0.5
＋125
ー0.3
ー0.5
ー55
V
mA
℃
VDD
Ta
5.5
＋85
V
℃
1.851.6
ー30
IDD
VOH
VOL
TPD1
TPD2
9
0.4
100
220
6.5
50
146
VDD ー0.4
25
73
μA
V
V
ms
μs
IOUT =ー0.5mA
IOUT =＋0.5mA
BopN
BopS
BrpN
BrpS
BhN,BhS
3.2
ー1.4
3.0
ー1.2
2.5
ー2.5
2.0
ー2.0
0.5
1.4
ー3.2
1.2
ー3.0
0.1
mT
mT
mT
mT
mT
BopN
BopS
BrpN
BrpS
BhN,BhS
3.9
＊
ー1.3
＊
3.7
ー0.9
2.5
ー2.5
2.0
ー2.0
0.5
＊
1.3
ー3.9
0.9
＊
ー3.7
＊
0.1
mT
mT
mT
mT
mT
●ElectricalCharacteristics
●MagneticCharacteristics①
●MagneticCharacteristics②
Item
Typ.
Unit
symbol
Min. NoteMax.
Item
Typ.
Unit
symbol
Min. Max.
Item
Typ.
Unit
symbol
Min.
Max.
High level output voltage
Lowleveloutputvoltage
Pulsedriveperiod
Pulsedrivetime
Currentconsumption
Note)Theabovespecificationsareguaranteedbydesign.
Releasing points
Hysteresis
Operating points
Note)Thecharacteristicswith＊marksareguaranteedbydesign.
Releasing points
Hysteresis
Operating points
（Ta=25℃VDD =1.85V）
（Ta=25℃VDD =1.85V）
（Ta=−30〜＋85℃VDD =1.6〜5.5V）
●AbsoluteMaximumRatings
●RecommendedOperatingConditions
Item tinU.niM
symbol
Max.
Storagetemperature
Item
Typ.
Unit
symbol
Min.
Max.
Outputcurrent
Power supply voltage
Note)Stressesbeyondtheselistedvaluesmaycausepermanentdamagetothedevice.
Operating temperature
Power supply voltage
Average
26
•Please be aware that our products are not intended for use in life support equipment, devices, or systems. Use of our products in such applications requires the
advance written approval of our sales staff.
Certain applications using semiconductor devices may involve potential risks of personal injury, property damage or loss of life. In order to minimize these risks,
adequate design and operating safeguards should be provided by the customer to minimize inherent or procedural hazards. Inclusion of our products in such
applications is understood to be fully at the risk of the customer using our devices or systems.
AK8789
a
f
k
n
o
p
50ms（typ.）
Time
146μs（typ.）
IDDON
（typ＝1.8mA）
IDD
（typ＝6.5μA）
IDDOFF
（typ＝1.3μA）
I
DD
B
Bop
VOUT
High
Low
t
t
t
I
DD
B
Brp
VOUT 48.8μs（typ.）
48.8μs（typ.） High
Low
t
t
t
OperatingPointTiming ReleasingPointTiming
1.10 0.80
0.50
0.22
0.60
1.40
1.70
0.35
0.22
0.50
1.00
(0.125)
0.37
(0.23)
0.20
1.40
0.80
0.60
SensorCenter
No.
1
2
3
4
VDD
VSS
OUT2
OUT1
Function
Powersupply
Ground
Spoledetectionoutput
Npoledetectionoutput
Note
CMOSOutput
CMOSOutput
Pinname
●Package（Unit:mm)
※Note1)Sensitiveareapositionreferencedto
thecenterofpackagewithinφ0.3mmcircle.
Note2)Tolerancesofdimensionotherwisenotedis
±0.05mm.
Note3)Hatchedareaisplated.
Note4)Centerpadarea(TAB)shouldbetiedtothe
VSSorfloating
●Footprint（forreference)
●IDDTimingChart ●FunctionalTimingChart
Note)HalleffectIC'soutputisheldasinternaldatajustbeforethe
internalcircuitturnsoff.Andafter48.8ms(typ.)theoutputchanges.
27
AK8789
-30 -20 -10 0 10 20 30 40 50 60 70 80 90
-6
-4
-2
0
2
4
6
BopN
-30 -20 -10 0 10 20 30 40 50 60 70 80 90
0
2
4
6
8
10
12
14
16
18
BrpN
BrpS
BopS
VDD =1.85V
VDD =3.0V
VDD =5.5V
Bop,Brp［mT］
IDD［μA］
AmbientTemperatureTa［℃］
Bop,Brpvs.Ta(VDD=1.85V)
AmbientTemperatureTa［℃］
IDD vs.Ta
GND
VDD =1.85V
0.1μF
VDD
OUT2
VSS
AK8789
OUT1
●TypicalCharacteristicsData(forreference)
Temperaturedependenceofsensitivity
Temperaturedependenceofcurrentconsumption（Average）
●ApplicationCircuit
CMOSOutput（N）
CMOSOutput（S）
28
a
f
k
n
o
p
AK8789
IMPORTANT NOTICE
These products and thei r specifications are subject to change without notice.
When you consider any use or application of these products, please make
inquiries the sales office of Asahi Kasei Microdevices Corporation (AKM) or
authorized distributors as to current stat us of the products.
Descriptions of external circuits, application circuits, sof tware and ot her related
information contained in this document are provided only to illustrate the
operation and application examples of the semiconductor products. You are
fully responsible for the incorporation of these external circuits, application
circuits, software and other related information in the design of your
equipments. AKM assumes no responsibility for any losses incurred by you or
third parties arising from th e use of these information herein. AKM assumes no
liability for infringement of any patent, intellectual property, or other rights in
the application or use of such information contained herein.
Any export of these products, or devices or systems containing them, may
require an export license or other official approval under the law and
regulations of the country of export pertaining to customs and tariffs, currency
exchange, or strategic materials.
AKM products are neither intended nor authorized for use as critical
componentsNote1) in any safety, life support, or other hazard related device or
systemNote2), and AKM assumes no responsibility for such use, except for the
use approved with the express written consent by Representative Director of
AKM. As used here:
Note1) A critical component is one whose failure to function or perform
may reasonably be expected to result, whether directly or indirectly, in the
loss of the safety or effectiveness of the device or system containing it,
and which must therefore meet very high standards of performance and
reliability.
Note2) A hazard related device or system is one designed or intende d for
life support or maintenance of safety or for applications in medicine,
aerospace, nuclear energy, or other fields, in which its failure to function
or perform may reasonably be expected to result in loss of life or in
significant injury or damage to person or property.
It is the responsibility of the buyer or distributor of AKM products, who
distributes, disposes of, or otherwise places the product with a third party, to
notify such third party in advance of the above conten t and conditions, and th e
buyer or distributor agrees to assume any and all responsibility and liability for
and hold AKM harmless from any and all claims arising from the use of said
product in the absence of such notification.
February 21, 2013