APEM www.apem.com B1-29
IHS series
Hall effect pushbutton switches - bushing Ø 12 mm - momentary
Distinctive features and specifications
B1
❑Momentary pushbutton (NO)
❑5 million cycles
❑Low behind-panel depth
❑Standard and high actuator
❑Sealed to IP67
ENVIRONMENTAL SPECIFICATIONS
• Front panel sealing : IP67 according to IEC 60529
• Operating temperature : -40°C to +85°C
ELECTRICAL SPECIFICATIONS
• Supply voltage : 3,5VDC to 24VDC
• Supply current : VDC = 12V : 2,5mA Typ. to 5mA max.
(current consumption in OFF position)
• Max. output current : 50mA
• Max. output voltage : 24VDC
• Output type : NPN
MATERIALS
• Case : PBT, UL94-V0
• Actuator :
polyamide
6/6
• Bushing/bezel : zinc die-cast
(zamac), black painted
•
Multi-wire lead : AWG26, 150 mm
GENERAL SPECIFICATIONS
• Panel thickness : 1,5 mm (.059) min.
4 mm (.157) max.
• Total travel : 1,80 mm (.070)
+/- 0,3 mm
• Typical operating force : 6N +/- 2N
• Mechanical life : 5 million cycles
• Torque : 1,5 Nm max. applied to nut
MOUNTING
Panel cut-out Matrix mounting
Back of panel space requirement
WIRING DIAGRAM
(.570)
14.50
Ø13.60
(.535DIA)
(.531DIA)
Ø13.50
12.90
(.507)
1
1.50min-4Max
(.059 min-.157max)
20.00
(.787)
20.00
(.787)(.787)
20.00
➀O-ring
+Vout
LOAD
WHITE wire
OUTPUT
GND
BLACK wire
RED wire
VDD
The company reserves the right to change specifications without notice.
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page29
UG1410A
B1-30 APEMwww.apem.com
IHS series
Hall effect pushbutton switches - bushing Ø 12 mm - momentary
Overview
B1
IHS
SERIES
Actuator shapes
RRound
HRound, high
Operating force
66N
Electrical function
3Normally open
(NO)
Actuator colours
1Blue
2Black
3Green
4Grey
5Yellow
6Red
7White
9Orange
BDark blue
Terminals
FFlying leads
Options
Blank None
100 Satin chrome bezel
101 Bright chrome bezel
ABOUT THIS SERIES
On the following pages, you will find successively :
model structure of switches and options in the same order as in above chart
Dimensions : first dimensions are in mm while inches are shown as bracketed numbers.
A sealing boot is available to protect the switches against frost and sand (P/N U5125). It is presented after the IA series
and in section H.
Mounting accessories : Standard hardware supplied : 1 hex nut 14 mm (.551) across flats and 1 O-ring.
Hex nut part number U166.
Packaging unit : 25 pieces
NOTICE : please note that not all combinations of above numbers are available.
Refer to the following pages for further information.
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page30
Function 3 (NO)
APEM www.apem.com B1-31
IHS series
Hall effect pushbutton switches - bushing Ø 12 mm - momentary
Round - non-illuminated
B1
MODEL
STRUCTURE
• Standard or high actuator
Standard actuator
(5.905)
150.00
Ø17.50
(.688DIA)
(.059 Min)
1.50 Min
2.00
(.078)
Ø12.00x0.75SI
Ø12.00
(.472DIA)
(.472DIAx0.75IS)
(.267)(.251)
6.806.40 5.00
(.196)
➞Flat
IHSR36F Normally Open
High actuator
(.196)
5.006.40 6.80
(.251) (.267)
(.472DIAx0.75IS)
(.472DIA)
Ø12.00
Ø12.00x0.75SI
(.185)
4.70
1.50 Min
(.059 Min)
(.688DIA)
Ø17.50
150.00
(5.905)
➞Flat
IHSH36F Normally Open
ACTUATOR COLOURS
1: blue - 2: black - 3: green - 4: grey - 5: yellow - 6: red - 7: white - 9: orange - B: dark blue
OPTIONS
100 : Satin chrome bezel
101 : Bright chrome bezel
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page31
B1-32 APEMwww.apem.com
IHL series
Hall effect pushbutton switches - bushing Ø 12 mm - linear
Distinctive features and specifications
B1
❑Linear output pushbutton
❑0,5 to 4,5 volt output
❑Different operating force
❑5 million cycles
❑Sealed to IP67
ENVIRONMENTAL SPECIFICATIONS
• Front panel sealing : IP67 according to IEC 60529
• Operating temperature : -40°C to +85°C
• EMC testing : 10V per meter extend to radiated fields in freq. range of
80 Mhz to 1.000 MHz. 1KHz 80 % sine wave modulation according to
IEC/EN 61000-4-3
ELECTRICAL SPECIFICATIONS
• Supply voltage : 4,5VDC to 5,5VDC without regulator
6,5VDC to 24VDC with 5V regulator
• Supply current : 9mA max.
• Max. output current : 1,25mA
• Max. output voltage with or without regulator : see graph below.
MATERIALS
• Case : PA46, UL94-V0
• Actuator :
polyamide 6/6
• Bushing : polyamide 6/6
•
Multi-wire lead : AWG26, 150 mm
GENERAL SPECIFICATIONS
• Panel thickness : 1,5 mm (.059) min.
10 mm (.393) max.
• Total travel : 4 mm (.160) +/- 0,3 mm
• Mechanical life : 5 million cycles
• Torque : 1 Nm max. applied to nut
MOUNTING
Panel cut-out Matrix mounting
Back of panel space requirement
WIRING DIAGRAM
Ø13.60
(.535DIA)
12.90
(.507)
(.689)
17.50
17.50
(.689) (.689)
17.50
17.50
(.689)
Ø15.60
(.614DIA)
2
0.40min-0.50Max
(.016MIN.-.020MAX.)
1.50min-10.00Max
(.059MIN.-.393MAX.)
(.531DIA)
Ø13.50
VDD
RED wire
BLACK wire
GND
OUTPUT
WHITE wire
LINEAR OUTPUT GRAPH (VDC = 5V@20°C)
➁O-ring
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page32
APEM www.apem.com B1-33
IHL series
Hall effect pushbutton switches - bushing Ø 12 mm - linear
Overview
B1
IHL
SERIES
Actuator shape
RRound
Operating force
3Soft
5Standard
(progressive from
1N to 3,5N)
7Hard
Output voltage
01 0,5 to 4,5 V
Other : on request.
Actuator colours
1Blue
2Black
3Green
4Grey
5Yellow
6Red
7White
9Orange
BDark blue
Terminals
FFlying leads
Regulator
XNone
55V regulator
Other : on request
ABOUT THIS SERIES
On the following pages, you will find successively :
model structure of switches and options in the same order as in above chart
Dimensions : first dimensions are in mm while inches are shown as bracketed numbers.
Mounting accessories : Standard hardware supplied : 1 hex nut 14 mm (.551) across flats and 1 O-ring.
Hex nut part number U166.
Packaging unit : 25 pieces
NOTICE : please note that not all combinations of above numbers are available.
Refer to the following pages for further information.
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page33
B1-34 APEMwww.apem.com
B1
IHL series
Hall effect pushbutton switches - bushing Ø 12 mm - linear
Round - non-illuminated
MODEL
STRUCTURE
• With or without regulator
Without regulator
(5.905)
150.00
(.425)
10.80
Ø17.60
(.693DIA)
Ø12.00x0.75SI
(.472DIAx0.75IS)
(.440)
11.20
12.80
(.503)
(.185)
4.70
➞Flat
Soft operating force
IHLR013XF
Standard operating force
IHLR015XF
Hard operating force
IHLR017XF
With 5V regulator
(5.905)
150.00
70.00
(2.756)
(1.181)
30.00
Soft operating force
IHLR0135F
Standard operating force
IHLR0155F
Hard operating force
IHLR0175F
ACTUATOR COLOURS
1: blue - 2: black - 3: green - 4: grey - 5: yellow - 6: red - 7: white - 9: orange - B: dark blue
07-Serie IH-A_08-Serie IP-A 31/10/14 08:19 Page34
