P r o d u c t S p e c i f i c a t i o n s Telecommunications Network Line Protection Lightning fast . . . again and again and again . . . guaranteed Teccor's T1 Series modules use integrated semiconductor technology for self-resetting protection against overvoltage and overcurrent (sneak current) transients caused by lightning, electrostatic discharge, and AC power faults. Until needed, T1 Series modules are transparent to the telephone network, allowing efficient operation at maximum speed and bandwidth, with no signal degradation. The T1 Series plug-in modules fit existing PORTA SYSTEMSTM frames and can be used in applications at telephone exchanges, remote locations, building entrances, and customer premises. Breakdown voltages are available from 35V to 350V and overcurrent (sneak current) ratings from 150mA to 350mA. An integrated, fast acting, unibalanced, fail-safe mechanism ensures controlled operation for added personnel safety and superior equipment protection. Teccor Electronics is a global supplier and the largest US manufacturer of solid state transient voltage suppressors. Years of dedication, research, and development have created this first, fully integrated, single-pin protection module. Combining the manufacture of the silicon and assembly of the module ensures the most cost-effective solution. * Enhances Reliability and Survivability of the Network * Reduces Network Faults * Reduces Service Calls * 6 Year Warranty (contact factory for details) * Meets Telcordia 974 and N.E.C. Requirements * Easy Access for Line Testing * Broadband (high speed data) compatible * Available in three- and five-point configurations P r o d u c t S p e Overvoltage Protection Performance @ 25C Response Time: < 1ns Stand-by Voltage: Available from 35 to 350 volts Available from 35 to 350 volts Rated Impulse Discharge Life: Unlimited @ 100A (10 x 1000s) DC Holdover: Clears within 20ms Capacitance: 30pF @ 50V, 1VAC, 1MHz Safety and Equipment Protection: i f i c a t i o n s Overcurrent Protection Performance @ 25C DC Breakdown Voltage: Available from 35 to 350 volts Impulse Breakdown: c Activation Time: < 210 seconds with >350mA of current Restoration Time: < 90 seconds when the fault current is removed Line Resistance: 10 ohms 20%, maximum Imbalance: < 0.5 ohms Storage Temperature: -40 to 85C Operating Temperature: -40 to 65C Fast acting unibalanced fail safe protection responds in <1 second under 120A AC power cross conditions (T-G, R-G) (A or B to Earth) Ordering Information T1 1 3 0 0 A R 0 1 5 T N TECCOR 1 PIN Test Access Application 0 2 4 8 T N Standard Service (Black) Special Service (Red) Broadband & High Speed Data (Yellow) Pass Through (Grey) Test Points No Test Points Pin Finish T Overvoltage Protection 000 No Overvoltage Protection (see balance option) 075 75V Breakdown 220 220V Breakdown 300 300V Breakdown Tin Overcurrent Protection N000 No Overcurrent Protection R015 150mA Self Resetting R035 350mA Self Resetting Balance Option A B N Unbalanced (T-G, R-G) Balanced (T-G, R-G, T-R) No Overvoltage Protection Teccor Electronics 1801 Hurd Drive Irving, Texas 75038-4385 United States of America Tel: +1 972-580-7777 Fax: +1 972-550-1309 Internet: E-mail: Listed http://www.teccor.com protectionsystems@teccor.com Data Sheet: T 1 Ser ies 1 Pin ( 02/01) An Invensys company PORTA SYSTEMS is a registered trademark of Porta Systems, Inc. * All specific ations are s ubject to change without notice * Patent Pending